4.47.2 In the circuit shown in the image below, if R1 = 28 Q, R2 = 39 Q, and 1A, determine the Thevenin resistance RTh (in Q) for its Thevenin equivalent circuit= 2.1observed between terminals a and b.R2R1+,201ybPlease pay attention: the numbers may change since they are randomized. Youranswer should keep 1 plaafter the decimal poirYour Answer:Answer

Answered: Image /qna-images/answer/057031de-7872-48c4-903d-98247fff54fc.jpg

4.47.2 In the circuit shown in the image below, if R1 = 28 Q, R2 = 39 Q, and 1 = 2.1 A, determine the Thevenin resistance RTh (in Q) for its Thevenin equivalent circuit %3D observed between terminals a and b. R2 R1 201y Please pay attention: the numbers may change since they are randomized. Your answer should keep 1 place after the decimal point. Your Answer: Answer

4.47.2 In the circuit shown in the image below, if R1 = 28 Q, R2 = 39 Q, and 1 = 2.1 A, determine the Thevenin resistance RTh (in Q) for its Thevenin equivalent circuit %3D observed between terminals a and b. R2 R1 201y Please pay attention: the numbers may change since they are randomized. Your answer should keep 1 place after the decimal point. Your Answer: Answer

Classical Dynamics of Particles and Systems

5th Edition

ISBN:9780534408961

Author:Stephen T. Thornton, Jerry B. Marion

Publisher:Stephen T. Thornton, Jerry B. Marion

Chapter1: Matrices, Vectors, And Vector Calculus

Section: Chapter Questions

Problem 1.21P: Show (see also Problem 1–11) that

See similar textbooks

Similar questions

I would love a detailed explanation for this problem. In a phasor diagram, how do we, approximately, know where Vrms will be located? It is known that Vl leads current while Vc lags current by 90 degrees. But what about Vrms in relation to current or in general?
For temperature-dependent ohmic resistors (at least the kind we're focusing on), the relationship between resistance & temperature is linear. With that in mind, compare the formula for temperature-dependent ohmic resistance to the equation for a line (y = mx + b) and determine the slope and the y-intercept for a graph of R vs. T. Your answers should be in terms of Ro, ?, & To. [NOTE: for Ro & To the subscript is a lowercase o] R = Ro[1 + ?(T − To)] slope = y-intercept =
How much current is flowing when 15 C pass a specified point in 5 s? Solve and explain.
A wire of length 1 km, has a conductance of 0.6 mho. What is theconductance of the same wire which is 3 km long?
Let's say you have a 20 cm long silicon wire, with a diameter of 4 cm. What current flows through this wire if a 1000 V potential difference is applied to the two ends? Please enter your answer in the unit of mA. You can use 2300 Ohm.m for the resistivity of silicon.
The power rating of a resistor is the maximum power it can safely dissipate without being damaged by overheating. (A) If the power rating of a certain 12 kΩ resistor is 6.0 W, what is the maximum current it can carry without damage? Express your answer with the appropriate units. (B) What is the greatest allowable potential difference across the terminals of the resistor in part A? Express your answer with the appropriate units. (C) If a 6.0 kΩ resistor is to be connected across a 120 V potential difference, what power rating is required for that resistor? Express your answer with the appropriate units.
Find the total charge in mC of a cylindrical conductor (solid wire) 1 meter long and a diameter of 2mm. Given also its charge density (De) is 10^29 carriers/m^3 and its carrier velocity (u) is 19.9x10^-6 m/s
A constant current transfers 10*10^14 electrons onto one plate of a capacitor in 3 minutes [min]. (a) What is the current, in units of amperes [A]? Express the answer using an appropriate SI prefix such that there are only 1, 2, or 3 digits shown to the left of the decimal. (b) If the capacitor has a capacitance of microfarads [F], what is the voltage in units of volts [V] across the capacitor?
If 25 A current flows through a circuit at a voltage difference of 1.3 x 102 V, how much is the power consumption? How many 50-Watt bulbs can be operated with this voltage source? If the charge for consumption rate from Edison is 25 c/ kilowatt-hour, what is the charge for 8 hours? How much is going to be the monthly bill only for these bulbs?
Find the total current flowing across R4 in the circuit below if R1 = 120 Ω, R2 = 40 Ω, R3 = 50 Ω, and R4 = 85 Ω and ε = 7.0 V. Give your answer in milliamps (mA).
Describe the general characteristic of a n-type and a p-type conductor?
Pacemakers designed for long-termuse commonly employ a lithium-iodine battery capable of supplying 0.42 A # h of charge. (a) How many coulombs of chargecan such a battery supply? (b) If the average current producedby the pacemaker is 5.6 mA, what is the expected lifetime of thedevice?