4.53.1 In the circuit shown in the image below, if R1 = 21 Q, Ro = 11 Q, and 1 A, determine the Norton current IN (in A) for its Norton equivalent circuit observed 4.3 %3D %3D between terminals a and b. Vo. o a Ro R1 2V. Please pay attention: the numbers may change since they are randomized. Your answer should keep 1 place after the decimal point. Your Answer: Answer

Q: A positive-sequence, balanced delta-connected source supplies a balanced delta-connected load. If th...

A:

Q: A 1-phase, 20 km line delivers a load of 12 MW at 11 kV having a lagging p.f. of 0.8 at the receivin...

A: In this answer we will find the sending end voltage and the regulation of transmission line as expla...

Q: A 3 phase star connected alternator is rated at 1600 kVA, 13,500 V. The armature effective resistanc...

A: It is given that: PL=1280 KW=1280×103 WS=1600 KVA=1600×103 VAVL=13500 V Ra=1.5 ΩXc=30 Ω    

Q: explain what sinusoidal signals are, and how they’re used in every day life.

A: sinusoidal signals are those signals which is continuous and varies with respect to the time.  It is...

Q: Identify whether the following CT systems are BIBO stable or not. y(t) = x(1) + 1.5 x(1)dt 1.) y(t) ...

A:

Q: Q2/3-phase.E.W.C. R using center tap transformer supplies highly inductive load, find: 1. The averag...

A:

Q: The severity of line-to-ground and 3-phase faults at the terminals of an unloaded star connected syn...

A: Given, Terminal voltage, E = 1 pu Positive, negative, and zero sequence reactance is X1=X2=j0.35 pu ...

Q: “Interchanging S0 and S1 pins with RD’ and WR’ pins has no effect on the operations of an 8085 micro...

A: Microprocessors- Microprocessors are programmable devices which can be attached to any electronic de...

Q: A wide sense stationary process X(t) is passed through a linear time-invariant filter with mpulse re...

A: Given function

Q: What is zener effect?

A:

Q: A hot wire anemometer was calibrated in an air jet at ambient temperature TO = 20.6 °C and a wire te...

A:

Q: By banning petrol cars, the UK hopes to O turn the tide on global warming O save money become the bi...

A: By banning the petrol cars,  the UK hopes to  turn the tide on global warming.  By banning the petr...

Q: A biomass furnace is tested to determine its performance in terms of heating and evaporating water. ...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: A two-level brightness intensity lamp circuit was made. A 12 W lamp was the load and the supply is ...

A: It is given that: P=12 W Vs1=3 VVs2=6 V

Q: By banning petrol cars, the UK hopes to O turn the tide on global warming O save money become the bi...

A: One of the key points of Boris Johnson's 10-point plan is to ban on the sale of diesel- and petrol-p...

Q: (2v2 + i) – i (1+v2i)

A: Function is given, 22+i-i1+2i

Q: What is the voltage across a silicon diode when a forward bias current of 2.39 mA is measured operat...

A: What is the voltage across a silicon diode when a forward bias current of 2.39 mA is measured operat...

Q: Three impedances of 5—j10, 6 + j 5 and 3 + j15 ohms are connected in wye from a line-to-line voltage...

A: Here, we have given, three impedances. These impedances are forming star connection. So, we have to ...

Q: A 400/800 ratio transformer has secondary winding resistance of 0.5 ohm. What is the total resistanc...

A: Total resistance referred to primary side = Secondary winding resistance×primary voltagesecondary vo...

Q: jiven the following circuit, solve for Vo. Must use Nodal Analysis. 2 mA 5 kn ww 4 kn 6 mA 10 kn 2 k...

A:

Q: 7. The voltage generated across one inductor of a 30 alternator is 6 volts. There are 120 slots and ...

A:

Q: Given the NMOS inverter circuit as shown below: 3.3 V M1 2 V Vx M2 The W/L ratio for M¡ is twice tha...

A:

Q: a pɔ q e DE • 22 • 92 • sz .. 25 22 61 61 91 12 LL abcde

A: A circuit made up of only parts connected to a series is known as a series circuit; similarly, one f...

Q: 1.Calculate the voltage v3. 2.power drawn from sources find it. 3.XL and R1 circuit currents f...

A: The given circuit is shown below:

Q: What is the direction of the electric field at the position indicated by the dot in the figure? Spec...

A: In this question,  2 electric charges are placed as shown in the circuit.  Find the electric field a...

Q: W17.4 We are given a periodic function f with period 2a and such that f(x) = -f(-x+n) for all r. (a)...

A: We are given a periodic function f with period 2π and such that f(x)=-f(-x+π) for all x. a) We need ...

Q: R3 R R1 R2 A R R R4 Ra Vo Vi R D B- +

A:

Q: Two voltage measurements made across the same resistance are V1 25 V and V2 100 V. Calculate the pow...

A: The solution is given below 

Q: Compute the DFT for the sequence [3,2,1,0]

A:

Q: Draw nominal - T model of Transmission Line.

A:

Q: Write a conclusion about voltage drop and power loss calculations for Ring d.c distribution system.

A: Ring DC distribution system: It is the system for distributing the power. In this system, the first ...

Q: Determine the current in the following circuit: R = 50 R2 - 20 V= 10V0 R-40 2A iz

A: Given,

Q: 2. Calculate the rms value of the half-wave rectified sine wave shown in Figure P5.12. v(i) V 5 sin(...

A:

Q: 10 V a 30 V 8 V

A:

Q: E=14V R1=471 ohm R2=363 ohm R3=450 ohm Calculate ID2

A: In this question,  If E=14V, R1=471ohm , R2=363 ohm, R3=450 ohm   Calculate diode current in the dio...

Q: A piece of crystalline silicon is doped uniformly with phosphorus atoms. The doping density is 1x 10...

A: Given, A piece of crystalline silicon is doped uniformly with phosphorous atoms. Doping density, n=1...

Q: Voltage Peak value RMS value Average value Peak-to- peak value O V Time VT = Vmsinwt

A: Given, The wave form is sinusoidal. Please find the below attachment for the clear explanation.

Q: Question 10. Consider H(z) with the zero-pole diagram as shown below. Determine which frequency resp...

A:

Q: What is the nature of a circuit if its total impedance is 4-j4 ohms? Group of answer choices reactiv...

A:

Q: A singer voice is sampled for 4 second by an 8-bit ADC at a sampling frequency of 10 kHz. The sample...

A: Given that n=8bit fs=10kHz t=4sec

Q: A rectifier is a component that converts ac to dc by allowing the current to be

A: Given, Rectifier . Let's write the definition of rectifier.

Q: s3 + 5s2 + 12s +K = 0. Find the range of K for all the roots to lie to the The characteristics equat...

A: Find the range of K for all the roots to lie to the left of s =1 for the given characteristic equati...

Q: Discussion Question 1: A rectangular block of iron is 2cm x 2cm x 30cm. How would you connect this b...

A: A rectangular block of iron which has the dimensions of 2 cm× 2 cm × 30 cm. So now if we connect it ...

Q: Two parallel branches have admittances 0.3+ j0.4 and 0.2- j0.25 , respectivel If the current in the ...

A: In this question,  Choose the correct options What is value of total current if  Two parallel Branch...

Q: A capacitor carries a charge of 0.1 C at 5 V. Its capacitance is O 0.02 F O 0.5 F O 0.05 F O 0.2 F

A: Given: A capacitor carries a charge, Q = 0.1 C At voltage, V = 5 V

Q: The information in an analog signal voltage waveform is to be transmitted over a PCM system with an ...

A: Given, Analog signal voltage waveform is to be transmitter over a PCM system. Accuracy is ∆2=±0.1%  ...

Q: Give at least 3 applications of Fourier Series.

A: Fourier series: A periodic function (potentially infinite) can be represented as a sum of cosine &am...

Q: Under the condition that Ra = R, in terms of V1, derive or solve for an expression for V0 usinng cir...

A:

Q: Given a coaxial capacitor with the length of L which has two coaxial conductors with radius a=1 cm a...

A: a=0.01  and b= 0.04 L=100m ∈r=2.2 1V=-∫E→.dla<ρ<bQ=∮s D→.dsQ=∫02π∫0l Dρ aρ. ρ dϕ dz aρ       a...

Q: ) The diode model is employed most frequently in the analysis of electronic systems. -) Electrons in...

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for yo...

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.