4.7. For a pure buoyant plume, it can be shown that the vertical velocity and the buoyancy factor of the ascending air vary with time according to U c pª and B x tP. Solve for the numerical values of a and 3.

4.7. For a pure buoyant plume, it can be shown that the vertical velocity and the buoyancy factor of the ascending air vary with time according to U c pª and B x tP. Solve for the numerical values of a and 3.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 34CQ: The old rubber boot below has leaks. To what maximum height can water squirt from Leak 1? How does...

See similar textbooks

Related questions

Q: 3.Which of the following is the equation representing the direct varaition of the statement…

A: GivenAtmospheric pressure P varies inversely as altitude (h)

Q: A mercury barometer located in a room at 25◦C has a height of 750 mm. What is theatmospheric…

A: Given in question - Temprature(T) = 25°c Hight (H) = 750 mm =…

Q: What is the mass of air at 20 degree Celcius in a room with dimensions 3m by 4m by 5m? (P gir =1.20…

A: The volume of air in the room is, V=3 m×4 m×5 m=60 m3 The density of air, ρair=1.20 kg/m3

Q: What is the mass of air contained in a room that measures 2.50 m × 5.50 m × 3.00 m if the density of…

Q: What is the volume, in m3, of 10,000 kg of CO2 at 20∘C and 1.0 atm pressure? To put this in…

A: The volume is given by,

Q: A wind tunnel has an inlet section with a velocity of 360 ft/s at standard atmospheric conditions.…

Q: The volume of an air bubble increases by a factor of 3.19 times as it rises from the bottom of a…

Q: Q.4. The supersonic nozzle of the figure is overexpanded with AJA, = 3 and a stagnation pressure of…

A: Given data: Area ratio (Area at exit plane/throat area), AeAt=3 Stagnation pressure, P0=350 kPa…

Q: Calculate the correction that needs to be applied to a T 89° C if barometric pressure when measuring…

Q: Due to unavailability of mercury, a barometer was constructed using water in the closed column with…

A: Here, it is given that, A barometer is constructed using water in the closed column with a certain…

Q: The density of air is 1.3 kg/m at sea level. From your knowledge of air pressure at ground level,…

Q: If the atmospheric pressure is 1,051 mm Hg and the height difference between the two arms is 14.4 cm…

Q: B) The pressure drop 'p' in a nozzle depends upon the velocity 'v' of a liquid leaving and the…

Q: the barometic equation that is pressure as a function of height. Given that the temperature is…

A: Using Barometric equation , we get P=P0e-MghRT⇒MghRT=lnP0PGiven, air pressure is twice less…

Q: 2. Given the barometric pressure of 14.7 psi atm (29.92 in. HG atm), solve for the absolute pressure…

A: Given: Barometric Pressure Patm = 14.7 psi atm

Q: gz - Lvqi = 302525 J/kg and a total specific humidity qt = qv+qi= 16.2 g/kg. Determine its…

A: In this question we have to find the smallest air density. Please give positive feedback if the…

Q: How high does the mercury (13.6 x 10³ kg/m³) rise when in a mercury barometer when the atmospheric…

A: Given that:- Density of mercury=13.6×10^3 kg/m^3 Atmospheric pressure=1.1×10^5 pascal

Q: (II) How high would the level be in an alcohol barometerat normal atmospheric pressure?

A: We know that the normal atmospheric pressure is equal to P = 1.013 x 105 N/m2. The density of the…

Q: Can we use Ideal Gas Equation for problems involving water? Why? How about Air?

A: The ideal gas equation relates the pressure, volume and temperature of an ideal gas. It is given by,…

Q: What is the ratio of the average distances that oxygen willdiffuse in a given time in air and water?…

A: Diffusion constant of oxygen in water and air is given as,

Q: What is a Bourdon gauge? What range of pressures can it be used to measure? As it is normally…

A: The Bourdon pressure gauge uses the principle that a flattened tube tends to change to a more…

Q: Calculate the density of air entering the nozzle, if the air leaves a nozzle at a P=1.5atm and…

A: Given: While entering, v1 =150 m/s Inlet to exit diameter ratio = 3:1.5 Inlet diameter = 3p and…

Q: Space botany requires a certain pressue of 1.20 space pressure units (SPU) for the growth biomes to…

A: 1 Space Pressure unit=3 earth atm 1earth atm=760 torr we need our answer in torr

Q: A garden hose has an inner radius of 1.3 cm, is connected to a spray nozzle (radius: 0.5 cm). If…

Q: 2.25 The dynamic viscosity of nitrogen at 59°F is 3.59 x 10 Ibf · s/ft². Using Sutherland's…

Q: 2.25 The dynamic viscosity of nitrogen at 59°F is 3.59 x 107 Ibf · s/ft². Using Sutherland's…

Q: Assuming air as the perfect gas, find the density of air at an altitude of 10000 feet at which the…

A: Given parameters are, At altitude h =10000 feet, pressure p2 = 50225 Pa At sea level, pressure…

Q: Q.2. When an oblique shock strikes a solid wall, it reflects as a shock of sufficient strength to…

Q: In the chapter on fluid mechanics, Bernoulli’s equation for the flow of incompressible fluids was…

Q: Is gasoline can be considered inelastic? Why

A: Gasoline has very few substitute. So, it is always in demand.

Q: What is the mass of air at 20 degree Celcius in a room with dimensions 3m by am by Sm? (P ar 1.20…

Q: Your low-flow showerhead is delivering water at 1.1 × 10-4 m3/s, about 1.8 gallons per minute. If…

A: The given values are, Q=1.1×10-4 m3/sd2=0.021 m

Q: Consider a low-speed flight of the space shuttle as it is nearing a landing. If the air pressure and…

A: Given, air pressure=P=121590 Pa tempertaure=t=400 K let density of air be ρ now we can use the…

Q: What will be the minimum pressure to compress 500 dm3 of air at 1 bar to 200 dm3 at 30°C?

Q: The rate of change of atmospheric pressure P with respectto altitude h is proportional to P,…

Q: Which of the following is true for the situation below? po is the atmospheric pressure, p is the…

A: h=Difference of height in fluid=16−6=10 cmρ=Denisty of mercuryg=Acceleration due to…

Q: An important design consideration in two-phase pipe flow of solid-liquid mixtures is the terminal…

A: The terminal velocity of a solid particle in the rest water is given by, The dimensions of the…

Q: A 1.2-m-external-diameter spherical tank is located outdoors at 1 atm and 25°C and is subjected to…

Q: At what flow rate (in m3/s) might turbulence begin to develop in a water main with a 0.300 m…

A: Given data The diameter of the main pipe is: d = 0.3 m The expression for the Reynolds number is…

Q: determine the atmospheric pressure at a location where the barometric reading is 740 mm hg. Assume…

A: The net force acting on an object causes the acceleration of the object. The net force acting on the…

Q: Outside your house 1.0km from ground zero of a 100-kiloton nuclear bomb explosion, the pressure will…

A: Given data pressure inside house=1.0atm pressure rise due to explosion=2.8atm house height=3.33m…

Q: Calculate the volume (in m^3) of helium needed in a hot air balloon to lift at least 100 kg of load.…

A: According to archemede's principle Buoyant force =weight of liquid displaced

Concept explainers

Variation of pressure

From the equation of pressure, pressure is directly proportional to the applied force.

Question

4.7. For a pure buoyant plume, it can be shown that the vertical velocity and the buoyancy
factor of the ascending air vary with time according to U tª and B x t. Solve for
the numerical values of a and B.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

If the sphere's radius is 0.5m and its Re in air 1 x 106, what is nearly velocity ( air density = 1.255kg/m3 uair = 1.789 x 10-5 Pa-s)
If the atmospheric pressure is 1,051 mm Hg and the height difference between the two arms is 14.4 cm , what is the pressure of the gas sample below in atmospheres (atm)?
Consider the sealed containers (same fluid and on the same ground level) below with heights given in a and b values.Provided that b = 2a, answer the following items. If a = 2 in, and the density of the fluid is 60 lbm/ft^3, what is the pressure at point B in psia?
What are the air-standard assumptions?
Calculate the gauge pressures inside 2.00-cm-radiusbubbles of water, alcohol, and soapy water. Which liquidforms the most stable bubbles, neglecting any effects ofevaporation?
What does it mean to say that the density of gasoline is 680 kg/m3?
Under standard conditions, the density of air is 1.29 kg/m3. What is the mass of the air inside a room measuring 4.0 m × 3.0 m × 2.0 m?
A 1.2-m-external-diameter spherical tank is located outdoors at 1 atm and 25°C and is subjected to winds at 48 km/h. Determine the drag force exerted on it by the wind.
The density of air is 1.3 kg/m3 at sea level. From your knowledgeof air pressure at ground level, estimate the height ofthe atmosphere. As a simplifying assumption, take the atmosphereto be of uniform density up to some height, afterwhich the density rapidly falls to zero. (In reality, the densityof the atmosphere decreases as we go up.)
An important design consideration in two-phase pipe flow of solid-liquid mixtures is the terminal settling velocity below, which the flow becomes unstable and eventually the pipe becomes clogged. On the basis of extended transportation tests, the terminal settling velocity of a solid particle in the rest water given by VL = FL√2gD(S − 1), where FL is an experimental coefficient, g the gravitational acceleration, D the pipe diameter, and S the specific gravity of solid particle. What is the dimension of FL? Is this equation dimensionally homogeneous?
What is a Bourdon gauge? What range of pressures can it be used to measure? As it is normally calibrated, does it measure gauge or absolute pressure?
(II) How high would the level be in an alcohol barometerat normal atmospheric pressure?