This is the IR spectrum of *cinnamon oil*- Please identify the key peaks in the IR spectrum and the bond type. -If possible, identify around 5-6 peaks. 4000350030002500Wavenumbers (cm-1)200015001000500-5-0-510-1667.951119.1915744.481624.33686.50969.92%Transmittance1605.341575.06619.86 605.24 581.721449.381071.871293.681005.591392.782812.202741.221731.131494.993027.881250.611177.93 1159.681327.14841.15100 ali cinnamon

The question is based on the concept of organic spectroscopy. We need to analyse the spectral data.

4000 3500 3000 2500 Wavenumbers (cm-1) 2000 1500 1000 500 -5 0 5 1667.95 10 1119.19 744.48 1624.33 686.50 969.92 % Transmittance 1605.34 1575.06 619.86 605.24 581.72 1449.38 1071.87 1293.68 1392.78 1005.59 2812.2 2741.22 1731.13 1494.99 3027.88 1250.61 1177.93 1159.68 1327.14 841.15 100 ali cinnamon

4000 3500 3000 2500 Wavenumbers (cm-1) 2000 1500 1000 500 -5 0 5 1667.95 10 1119.19 744.48 1624.33 686.50 969.92 % Transmittance 1605.34 1575.06 619.86 605.24 581.72 1449.38 1071.87 1293.68 1392.78 1005.59 2812.2 2741.22 1731.13 1494.99 3027.88 1250.61 1177.93 1159.68 1327.14 841.15 100 ali cinnamon

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter11: Atomic Mass Spectrometry

Section: Chapter Questions

Problem 11.9QAP

See similar textbooks

Similar questions

The following are the reasons why instrumental analysis methods are used, except for: a. Narrow concentration ranges may be detected. b. Extreme low sensitivity, with molecule and noise signal detection. c. Separate equipment or facilities for control, data handling, and optimization procedures. d. All of the above
5.4.5 Chemical microanalysis5.4.5.1 Exploitation of characteristic X-raysElectron probe microanalysis (EPMA) of bulk samples is now a routine technique for obtaining rapid, accurate analysis of alloys. A small electron probe (100 nm diameter) is used to generate X-rays from a defined area of a polished specimen and the intensity of the various characteristic X-rays measured usingeither wavelength-dispersive spectrometers (WDS) or energy-dispersive spectrometers (EDS). Typically the accuracy of the analysis is š0.1%. One of the limitations of EPMA of bulk samples is that the volume of the sample which contributes to the X-ray signal is relatively independent of the size of theelectron probe, because high-angle elastic scattering of electrons within the sample generates X-rays. The consequence of this is that the spatial resolution of EPMA is no better than ¾2 µm. In the last few years EDX detectors have been interfaced totransmission electron microscopes which are capable of operating…
The molar absorptivity for aqueous solutions of phenol at 211 nm is 6.17 × 103 L cm-1 mol-1. Calculate the permissible range of phenol concentrations if the transmittance is to be less than 85% and greater than 7% when the measurements are made in 1.00-cm cells.
Calculate the resolution required to resolve the following peaks; i) CH3N+ (MW = 28.0187) and N2+ (MW = 28.0061) ii) C2H4+ (MW = 28.0313) and CO+ (MW = 27.9949) iii) C3H7N3+ (MW = 85.0641) and C5H9O+ (MW = 85.0653) iv) 116Sn+ (At W = 115.90219) and 232Th2+ (At W = 232.03800)
Convert the accompanying transmittance data to absorbances: (a) 25.5% (b) 32.8% (c) 0.085
Convert the following Transmittance to absorbance: T=0.305
Molar concentration of the dye stock solution: 2.52e-5 mol/L Operating Wavelength: 630 nm Solutions(Dilutions) Absorbance (A)(a.u.) 1 0.073 2 0.118 3 0.258 4 0.477 Using linear regression determine the absorbance/concentration relationship for the dye. [dye] =_____ x A
A solution of KMnO4 has an absorption of 0.560. Calculate the corresponding transmittance. 0.275 0.440 3.63 0.252
What percent transmittance range and what absorbance range are considered to be the optimum working ranges for spectrochemical measurements?
Potassium dichromate and potassium permanganate have overlapping absorptionspectra in 1M H2SO4 . K2Cr2O7 has an absorption maxima at 440 nm, and KMnO 4 has a band at 545nm (the maximum is actually at 525 nm, but the longer wavelength is generally used whereinterference from K2C2O7 is less). A mixture is analyzed by measuring the absorbance at these twowavelengths with the following results: A 440 =0.405, A 545 =0.712 in a 1-cm cell. The absorbances ofpure solutions of K2Cr2O7 (1x10 -3 M) and KMnO 4 (2.00x10 -4 M) in 1 M H 2 SO 4 , using the same cell gavethe following results: A Cr,440 = 0.374, A Cr,545 = 0.009, A Mn,440 =0.019, A Mn,545 = 0.475. Calculate theconcentrations of dichromate and permanganate in the sample solution.
Mass spectral measurements were made on 10 replicate low concentration Cd-EDTA samples: 181.5, 148.5, 158.5, 173.5, 142.5, 211.9, 163.5, 168.1, 157.5, and 175.1 counts. Ten measurements of a blank had a mean measurement of 42.1 counts. A sample containing 2.00 µM Cd-EDTA gave a measurement of 1827 counts. Estimate the signal and concentration detection limits for Cd-EDTA. signal detection limit: counts concentration detection limit: µM
An absorption measurement with a 1 cm path length yields a reading of 0.004 absorbance units with a noise of 0.001 absorbance units and a mean noise reading of 0 for 10 scans averaged together. Assuming the noise for a single scan does not change if the path length is increased to 6 cm and the number of scans is increase to 100, what is the signal to noise of the new measurement.