480 250 B. 360 130 320 360 450 Dimensions in mm
Q: 1) Determine the magnitude of the horizontal and vertical components of the total force per meter…
A:
Q: Cables AB, BC and AD support a 10 kips load as shown. Determine; a) The magnitude of the tensions in…
A:
Q: The hydraulic cylinder BD exerts on member ABC a force P directed along line BD. Knowing that P must…
A: Draw the free body diagram showing the forces along ABC.
Q: supported
A: xB=3ft AB=52+32=34 CD=22+32=13 At point C ∑Fx=0313FCD=4530FCD=28.84lb∑Fy=0-213FCD-3530+FCB=0FCB=34lb…
Q: Problem 1.- A stake is being pulled out of the ground by means of two ropes as shown. Knowing that…
A: Given data: The tension in the rope, T=120 N. The vertical resultant force is, Ry=160 N. Balance…
Q: The end of the coaxial cable AE is attached to the pole AB, which is supported by the wire stays AC…
A:
Q: 06. The supporting cables AB and AC are oriented so that the components of the 360-lb force along AB…
A: W=360 lbFAB=185 lbFAC=200 lb
Q: A wall section of precast concrete is temporarily held in place by the cables shown. If the tension…
A: The coordinates of A, B & C are: Let the tension is AB,AC are: Let the tension is AB,AC are:…
Q: A steel tank is to be positioned in an excavation. Knowing that the magnitude of P is 500 lb,…
A: Given data as per the question Magnitude of force P = 500 lb considering Free Body Diagram of the…
Q: 2.13 Three ropes support the weight at A. The tension in ropes AB and AC is 15 lb. Determine the…
A:
Q: Two tugboats are pulling a barge. If the resultant of the forces exerted by the tugboats is a…
A: (a) Consider the force triangle as shown below.
Q: Knowing that the tension in rope AC is 365 N, determine the resultant of the three forces exerted at…
A: Given Data: The force F1 = 500 N The force F2 = 200 N The force F3 = 365 N θ is the angle between…
Q: A 1600-lb crate is supported by three cables as shown. Determine the tension in each cable.
A:
Q: Solve Prob. 3.43 for the position corresponding to x = 4 in. The 20-in. tube AB can slide along a…
A: Given x=4 in a Using equation , 3.30 . CA=4i-12j+24k CA=42+-122+242=27.123 in…
Q: QUESTION The weights of two children sitting at ends A and B of a seesaw are 40 Ib and 65 lb,…
A:
Q: ! Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…
A:
Q: Two cables are tied together at C and are loaded as shown. Determine the tension (a) in cable AC,…
A: GIVEN MASS , M=200KGLET TAC & TBC BE TENSIONS IN THE CABLEAC & BC RESPECTIVELY
Q: A rectangular plate is supported by three cables as shown. Knowing that the tension in cable AB is…
A: Given: The tension in the cable AB = 408 N Solution:…
Q: The bucket of the front-end loader shown carries a 3200-lb load. The motion of the bucket is…
A: Draw the free body diagram for Bucket.
Q: Three horizontal forces are applied as shown to a vertical cast-iron arm. Determine the resultant of…
A: Given Data: The force acting at point A is P. The force acting at point B is FB = 600 N. The force…
Q: The hydraulic cylinder BC exerts on member AB a force P directed along line BC . Knowing that P must…
A: Given Load P component’s magnitude = 600 N To find The magnitude of the force Component along line…
Q: 1. Two cables are tied together at C and are loaded as shown. Determine the tensions in cables AC…
A:
Q: To test the strength of a 625 × 500-mm suitcase, forces are applied as shown. If P = 88 N, (a)…
A:
Q: A concrete foundation mat of 5-m radius supports four equally spaced columns, each of which is…
A: Given Data: The value of load F1 = 100 kN. The value of load F2 = 75 kN. The value of load F3 = 25…
Q: Cables AB, BC and AD support a 10 kips load as shown. Determine; a) The magnitude of the tensions in…
A:
Q: A rectangular plate is supported by three cables as shown. Knowing that the tension in cable AD is…
A: From the geometry define the vector DA. Now determine the unit vector and length of vector DA.
Q: A rectangular plate is supported by three cables as shown. Knowing that the tension in cable AB is…
A: A=(0,480,0)B=(-320,0,360)TAB=408 NThus vector BA is given…
Q: The rectangular plate of sides 530 mm x 1240 mm is supported by hinges along its side BC and by the…
A:
Q: Ropes AB and BC are two of the ropes used to support a tent. The two ropes are attached to a stake…
A: Given Data: The coordinate of point A is (-3,3,0 ). The coordinate of point B is (0,0,1.5 ). The…
Q: A beam supports three loads of given magnitude and a fourth load whose magnitude is a function of…
A: The beam is given as follows, Ballance the force in the y-direction to get the resultant equivalent…
Q: For the reinforcement shown, Determine by the method of nodes the magnitude of the force on the…
A: Given data F = 321 N P = 123 N a = 2.2 m b = 1.8 m θ= 76°
Q: Question 3 A rectangular plate is supported by three cables as shown. Knowing that the tension in…
A:
Q: The homogeneous wire ABCD is bent as shown and is attached to a hinge at C . Determine the length L…
A: Firstly to find the centroid of three sections Centroid of AB lies in 40mm Centroid of BC lies in…
Q: 1. Two cables tied together at C are loaded as shown. Determine the range of values of Q for which…
A: Given, θ=30 P= 75 lb
Q: Knowing that a= 55° and that boom AC exerts on pin C a force directed along line AC , determine (a)…
A: Law of sines: FACsin35=TBCsin50=1500sin95
Q: Four pegs of the same diameter are attached to a board as shown. Two strings are passed around the…
A:
Q: 1.28 Two members of a truss apply the forces shown to the gusset plate. Knowing that P = 10000 Ib,…
A: dear student please rate me positive :) Stay safe stay happy ! given - P= F1= 1000 lb F2 = 8000…
Q: QUESTION 5 Two structural members B and C are bolted to bracket A. Knowing that both members are in…
A:
Q: The crate shown is supported by ropes AB and AC. Determine the tension in the ropes. B 5 40° 3 A W =…
A:
Q: A cable is connected to an L shaped arm OAB as shown. The magnitude off the tensile force on the…
A:
Q: The end of the coaxial cable AE is attached to the pole AB, which is strengthened by the guy wires…
A: The component of force exerted on the pole at point A is FyA=85×sin60=69.28 lb Force acting at BC is…
Q: A rectangular plate is supported by three cables as shown. Knowing that the tension in cable AD is…
A: Given : The tension in the cable AD = 429 N Solution : The coordinates of point in the system : The…
Q: The guy wire BD exerts on the telephone pole AC a force P directed along BD. Knowing that P must…
A: Calculate the angle made by force P with vertical as follows: tanθ=72.4θ=tan-172.4=71.1° Draw the…
Q: In using the bolt cutter shown, a worker applies two 300-N forces to the handles. Determine the…
A: Applying∑Fx=0SoBx=0taking moment about A∑MA=096By-24Q=096By=24QQ=4By...........1
Q: Q2): A telephone cable is clamped at A to the pole AB. Knowing that the tension in the left-hand…
A: Given T1 = 800 lb Resultant of T1 and T2 is vertical To determine (a) The required tension T2 if…
Q: A concrete foundation mat of 5-m radius supports four equally spaced columns, each of which is…
A: Sum of the forces in the vertical direction are R=-25j^-75j^-125j^-100j^=-325j^ kN Magnitude of the…
Q: Q2): 423 lb 30° A steel tank is to be positioned in an excavation. Knowing that the magnitude ofP is…
A:
Q: A uniform cable weighing 3 lb/ft is held in the position shown by a horizontal force P applied at B…
A: Given Data: The weight of the cable is, w=3 lb/ft. The value of the horizontal force at point B is,…
Q: 4. The block shown is acted on by its weight W = 400 lb, a horizontal force F = 600 lb, and the…
A: The vector sum of two or more vectors is the outcome. It's the outcome of combining two or more…
A rectangular plate is supported by three cables as shown. Knowing that the tension in cable AD is 520 N, determine the weight of the plate.
Trending now
This is a popular solution!
Step by step
Solved in 3 steps with 21 images
- he crystal lattice has a -------------- arrangement a- One dimensional. b- Two dimensional. c- Three dimensional d- Four dimensional.Determine in [kg / m3] the density of gold (FCC) that has an atomic radius R = 0.1242 nm.Determine the intercepts of a plane when the miller indices are (111) where h is negative.
- It is a linear defect that revolves around the line that runs along the extra half-plane of atoms. a. Vacancy b. Dislocation of the edges c. Self-interstitial d. Dislocation of a screw e. Frenkel flaw Which of these is not a microscopic method? a. SEM b. XRD c. SPM d. AFM e. TEMusing this graph and explain why the twin boundary energy in the given image in 2D is higher than the bonding energy of perfect crystalprove the interplanar spacing of the cubic crystal structure (primitive) [prove the distance in cubic]
- 12) The imperfections of crystals do not depend upon a. Deformation of the solid b. coordination number c. Rapid cooling from high temperature d. High energy radiation striking the solidWhat is wrong with each of the following quantum number designationsand/or sublevel names?A) determine the theoretical density of nickel has atomic radius 0.1246 nm and atomic weight of it 59.7 g/mol
- Determine the miller indices for the plane given.Show that the atomic packing factor for BCC is 0.68.The attached photo shows the Young’s modulus of a cubic single crystal as a function of orientation. where a1 a2 and a3 are the direction cosines between the direction hkl and [100], [010], and [001], respectively. For a certain crystal, E111 = 500 GPa and E100 = 90 GPa. Calculate Young’s modulus for this single crystal in the <110> direction