(5-5)' High carbon steel or alloy steel can be used for the set of tools na lathe. The tools must be sharpened periodically. Data for each are as follows: Output per hour Time between tool grinds Time required to change tools High carbon steel 60 pcs 4h 1h Alloy steel 70 pcs 6 h 1h The wage of the lathe operator is P50.00 per hour, based on actual working hours. The tool changer costs P60.00 per hour. Overhead costs for the lathe are P45.00 per hour, including tool-change time. A set of unsharpened high carbon steel costs P500 and can be ground ten times; a set of unsharpened alloy steel costs P850 and can be- ground five times. Which type of steel should be used?

(5-5)' High carbon steel or alloy steel can be used for the set of tools na lathe. The tools must be sharpened periodically. Data for each are as follows: Output per hour Time between tool grinds Time required to change tools High carbon steel 60 pcs 4h 1h Alloy steel 70 pcs 6 h 1h The wage of the lathe operator is P50.00 per hour, based on actual working hours. The tool changer costs P60.00 per hour. Overhead costs for the lathe are P45.00 per hour, including tool-change time. A set of unsharpened high carbon steel costs P500 and can be ground ten times; a set of unsharpened alloy steel costs P850 and can be- ground five times. Which type of steel should be used?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

the answer in M1 is 4283.29lb, can you show me how to get this answer?
2. Please use 3 sig fig only for answer. 57.93 and 57 are wrong answers for the second problem
The temperature of a block of aluminum increases by 17.5 K. What is this temperature increase in ∘C?
can you please find the solutions for the 5questions .thanks
Show all working explaining detailly each step. Answer Qb(i), (ii) & (iii)
A machinist wishes to insert a brass rod with a diameter of 3 mm into a hole with a diameter of 2.998 mm. By how much would the machinist have to lower the temperature (in °C) of the rod to make it fit the hole?
DRAW THE FBD FOR THIS PROBLEM. ANSWER CORRECTLY AND PROVIDE DETAILED SOLUTION
why W of m = 0.42 ??????? I do not understnd this
Read and solve, include units in each step.
Answer detailly 4(ii)
for the power wouldn't it be desnity x Q x hp / 0.75 ? or did my professor make a mistake
K2 please help with my reviewer. Provide me the full solution and answer thank you SN=40