Answered: 5) Non coherent detection requires the…

5) Non coherent detection requires the knowledge of transmitted carrier frequency and phase at the receiver. a. True b. False а. b.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter5: Transmission Lines: Steady-state Operation

Section: Chapter Questions

Problem 5.17MCQ

See similar textbooks

Related questions

Q: A 50Ω lossless transmission line is terminated with a load impedance valued ZL = RL + jXL. According…

Q: 3. Write the effect of frequency of the signal for attenuation in transmission line?

A: The separation and attenuation of different frequencies by a transmission line causes distortion of…

Q: By using appropriate equation, prove that the input impedance of a terminated Zz + jZ, tan BI Zo +…

A: Lossless Transmission Line A lossless transmission line is defined as a transmission line that has…

Q: At an operating frequency of 300 MHz, a lossless 50-2 air-spaced transmission line 2.5 m in length…

A: Thank you for posting the question at Bartleby according to our guidelines we solve one question at…

Q: The 50 ohm half wavelength lossless transmission line is terminated with a 60 ohm load impedance. If…

Q: [3] which produces a voltage reflection coefficient Fx = 0.52 angle -320 at a point X on the line…

A: A transmission line with no line resistance and no dielectric loss is known as a lossless line. This…

Q: Line parameters of a transmission line at 2 GHz are R = 10 mn/m, G = 1 µS/m, L = 1 µH/m, C = 1 nF/m…

A: The given circuit diagram is shown below: It is given that: R=10 mΩ/m=10×10-3 Ω/mG=1 μS/m=1×10-6…

Q: Question)The coupling factor and isolation of a lossless, symmetric directional coupler are 8 dB and…

A: Given data, The value of the C is 8 dB, The value of I is 20 dB

Q: The magnitude of the [A] parameter of a short transmission line is smaller than that of medium line.…

A: first we will write the expression for A constant for short and medium transmission line to judge…

Q: 6. A 3000 transmission line is 0.8 m long and terminated with a short circuit. The line is operating…

A: z0= 300 ohm, wavelength =0.8m, length =0.8m

Q: A 400 kV, 50-Hz transmission line is 400 km long. Assuming that sending end of the line is energized…

A: It is given that: Velocity of propagation=v=300,000 km/sSending end voltage=VS=400 kVFrequency=f=50…

Q: Derive the scattering parameters for each of the following networks by using the parameter def-…

A: In the question, network 1 is mention but it is not shown in the figure. hence we will consider the…

Q: A lossless 75Q transmission line is terminated by a load impedance of 90+j750. Using the Smith…

A: Since you have asked multipart questions, we will solve the first three subparts for you. If you…

Q: A transmission line has the following per-unit-length parameters: L = 0.5 µH/m, C = 200 pF/m, R =…

A: Given Data: R = 4 ohm L = 0.5 uH C = 200 pF G = 0.02

Q: What will be the attenuation constant for a lossless transmission line?

A: Formula for attenuation constant is given by α=12RCL+GLC

Q: 4. The propagation constant consists of two terms. the first term is the attenuation constant, and…

A: We need to select correct option for lossless transmission line

Q: Two identical pulses each of magnitude 12 V and width 2 us are incident at i = 0 on a lossless…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: A lossless transmission line is 80 cm in length and operating at a frequency of 140 MHz. The line…

A: Given, Length=80cm=0.8m Frequency=f=140MHz Capacitance=C'=70×0.8=56pF Inductance=L'=0.4×0.8=0.32μH…

Q: 2. What is a carrier frequency?

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Tt=3.14 For a Transmission line, L=6,4 nH/m, R=2,9 0/m, C=1,2 µF/m and G=8,5 S/m (f = 1 GHz). For…

A: According to the question we have to find the value of ZR.

Q: Calculate the charecterictics impedance, propagation constant and velocity of propagation at 600 KHz…

A: Given: f=600KHz L=0.5Mh/km C=0.8μF/km R=G=0 (negligible)

Q: The static wave ratio in a 300 ( N) lossless transmission line terminating at an unknown load…

A: According to mentioned you solve only (a) part. we have to find the reflection coefficient.

Q: A loss-less 200N line is terminated on a load given by (200-j200)№. Given that the propagation…

A: the Given loss-less 200Ω line is terminated on a load 200-j200Ω The Propagation constant is…

Q: A 5.2cm long, lossless 100Ω transmission line was terminated with a load of ?? = 30 + 50Ω. With the…

A: The load reflection coefficient is: So, the magnitude of the reflection coefficient is: 0.617 And,…

Q: Q1) Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming a…

A: Given: Consider the circuit shown below, with an ideal source connected to a lossless line. Assuming…

Q: A 120-22 lossless line is terminated with 40- and 20- resistors in parallel. The voltage a the input…

Q: The static wave ratio in a 300 ( N) lossless transmission line terminating at an unknown load…

A: GIVEN DATA:

Q: Derive an expression for sag in a transmission line of equal hight poles.

A: We have to derive formula of sag for equal height poles in a transmission line.

Q: The standing-wave ratio on a lossless 3002 transmission line terminated in an unknown load impedance…

Q: Q1: Draw the block diagram for AM/DSB-SD system uses a carrier frequency 1MHZ and pilot carrier of…

Q: sinusoidal voltage wave is propagating on a low loss transmission line. The voltage as a function of…

Q: One end of an air lossless transmission line having the characteristic impedance of 75 Q and length…

A: Power generation, transmission, and distribution systems constitute a power system. The power…

Q: The static wave ratio in a 300 ( 2) lossless transmission line terminating at an unknown load…

A: Given:Z0=300 Ω

Q: -ohm resistive load and is operated at 100 MHz. At an electrical length of 0.4 wavelengths, what is…

Q: A 30-m-long lossless transmission line with Z, = 50 N operating at 2 MHz is terminated with a load…

Q: A 300ᘯ transmission line is 0.8 m long and terminated with a short circuit. The line is operating in…

A: A 300ᘯ transmission line is 0.8 m long and terminated with ashort circuit.The line is operating in…

Q: 6. The standing-wave ratio on a lossless 300-2 transmission line terminated in an unknown ZL is S=…

Q: An extra high voltage transmission line of length 300 km can be approximate by a lossless line…

A: Given, An extra high voltage transmission line of length= 300 km Propagation constant, β= 0.00127…

Q: 2.7) True or False: Directional antennas provide poor efficiency of power transmission. 2.8) Fill in…

A: Given True or false question and few fill in the blanks based on antenna theory. Please find the…

Q: For a medium transmission line, VRNL is equal to Vs. Select one: O True O False

A: sending end voltage will be same as no load receiving end only when capacitance effect is absent .…

Q: An extra high voltage transmission line of length 300 km can be approximated by a lossless line…

A: Given, An extra high voltage transmission line of length, l = 300 km Propgation constant, β=…

Q: The line parameters of a lossless transmission line are L = 0.25 µH/m and C= 100 pF/m. If the…

Q: A 75 Q lossless transmission line is to be matched with a 100-j802 load using Single stub. Calculate…

A: Given :Z0=75 ΩZL=100-j80 ΩZL=128.06∠38.66° f=30 MHz

Q: 4. The propagation constant consists of two terms. the first term is the attenuation constant, and…

A: We need to find out attenuation constant for lossless transmission line

Q: An extra high voltage transmission line of length 300 km can be approximated by a lossless line…

Q: [Q6] Determine the primary constants, R, L, G, and C for a distortion-less line working at 300 MHz.…

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

100%

I need the answer as soon as possible

5)
Non coherent detection requires the knowledge of transmitted carrier frequency
and phase at the receiver.
a. True
b. False
а.
b.
6)
Balanced demodulator in AM systems is
a. Phase detector
b. Integrator
c. Differentiator
d. Envelope detector

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction

VIEW

Step 2 Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The A.M transmission is used for long distance and video communication instead of F.M. Why? Also analyze the effect of noise and environmental conditions (i.e.moister, temperature and geographical terrain) on both modulation schemes and elaborate which modulation schemes will be more effect by noise and environmental conditions? (your answer should be technical and to the point). Subject is Communication system
The A.M transmission is used for long distance and video communication instead of F.M. why? Also analyze the effect of noise and environmental conditions (i.e. moister, temperature and geographical terrain) on both modulation schemes and elaborate which modulation scheme will be more affected by noise and environmental conditions? (Your answer should be technical and to the point).
what do we need to regulate voltage between sender and receiver? define the relation between turning capacitors value and phase angle between sender and receiver
With two port paramters Explanation of why S21 changes when the resistors are shorted to ground. Should includedescription in terms of the wave behavior on the transmission line and impedance matching
In layman's term, explain super heterodyne receiver.
A simple point-to-point microwave transmission link has no redundancy. Failure of the link will result in an outage. Therefore, typical microwave transmission links are designed with redundancy. Explain the following redundancy techniques 1+1 Hot Standby (HSB), 1+1 Space Diversity (SD), and 1+1 FD (Frequency Diversity).please explain.
How many dB is the interference loss in the short-circuit transmission line?
Identify and describe components of radio frequency communications focusing on units of power and comparisons, radio frequency mathematics, signal/interference/noise ratios, and budgets. Need detailed answer please. Thanks in advance
Explain how you would create a pcb design for transmission line?
2. What is a carrier frequency?
Derive an expression for sag in a transmission line of equal height poles
Distinguish between Lumped or Distributed elements in a Transmission Line.