5. There exists a uniform rectangular plate of mass m and length L and width W (this dimension is into and out of the page). The plate is held stationary by a thumb pushing down at one end and by fingers pushing up at a distance x from the thumb. find the force of the thumb T and the force of the fingers F.

5. There exists a uniform rectangular plate of mass m and length L and width W (this dimension is into and out of the page). The plate is held stationary by a thumb pushing down at one end and by fingers pushing up at a distance x from the thumb. find the force of the thumb T and the force of the fingers F.

Name: 5. There exists a uniform rectangular plate of mass m and length L and
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: 5. There exists a uniform rectangular plate of mass m and length L and width W (this dimension is into and out of the page). The plate is held stationary by a thumb pushing down at one end and by fingers pushing up at a distance x from the thumb. fin

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter8: Conservation Of Energy

Section: Chapter Questions

Problem 84PQ

See similar textbooks

Similar questions

A force of magnitude 7.50 N pushes three boxes with masses m1=1.30kg ,m2=3.20kg, and m3=4.90kg. Find the magnitude of the contact force between boxes 1 and 2.
The three masses shown in the figure are in equilibrium and the inclined plane is frictionless.If θ = 30.7°, m2 = 2.00 kg, and m3 = 4.24 kg, determine the mass m1 and the magnitude of the tension T in the string connecting m2 and m3.
There are two forces on the 1.19 kg box in the overhead view of the figure but only one is shown. For F1 = 15.7 N, a = 14.7 m/s2, and θ = 34.1°, find the second force (a) in unit-vector notation and as (b) a magnitude and (c) a direction. (State the direction as a negative angle measured from the +x direction.)
A copper wire of diameter 1.0 cm stretches 1.0% when it is used to lift a load upward with an acceleration of 2.0?/?^2. What is the weight of the load?
A picture frame hung against a wall is suspended by two wires attached to its upper corners. If the two wires make the same angle with the vertical, what must this angle be if the tension in each wire is equal to 0.75 of the weight of the frame?
A uniform plank of length 2.00 m and mass 31.5 kg is supported by three ropes, as indicated by the blue vectors in the figure below. Find the tension in each rope when a 715–N person is d = 0.500 m from the left end. magnitude of T1 N magnitude of T2 N magnitude of T3 N
Using the same force table that you used, a student was given two forces and asked to find a single force that would produce equilibrium with the two forces. The two forces were given by providing one of the components and the angle the force made with the positive x- axis. The two forces were as follows: Force 1: ?? = −2.70 ?; ? = 220.0 degreees Force 2: ?? = 3.20 ?; ? = 60.0 degrees (a) For each force, calculate the magnitude of the force and the mass required to produce it. (b) Calculate the mass and its angle of application to produce equilibrium with these two forces. Please specify your angle as counterclockwise positive with respect to the positive x-axis.
Assuming that the system is in equilibrium, find the value of m3, knowing that: r1=1.6 m r2=0.8 m r3=1.7 m m1=11.2 kg m2=4.7 kg
an 817 kg construction bucket is suspended by a cable A that is attached at O to two other cables B and C, making angles u1 = 51.0° and u2 = 66.0° with the horizontal. Find the tensions in (a) cable A, (b) cable B, and (c) cable C. (Hint: To avoid solving two equations in two unknowns, position the axes as shown in the figure.)
The semi-circular arch is loaded as shown in the Figure. For this problem, P1 = 1.8 kN, P2 = 0.90 kN, and P3 = 0.45 kN. 55. •What is the resultant of the three forces? • Determine the reaction of A &B
A 0.407 kg0.407 kg book rests at an angle against one side of a bookshelf. The magnitude and direction of the total force exerted on the book by the left side of the bookshelf are given by |?L|=2.17 N?L=19.0°|FL|=2.17 NθL=19.0° What must the magnitude |?B||FB| and direction ?BθB of the total force exerted on the book by the bottom of the bookshelf be in order for the book to remain in this position?
7. Which of the following is the condition for the three-force theorem in mechanics? a. The force system should be in equilibrium only b. The force systems should be non-coplanar c. The system should be co-planar, parallel d. The force system should be in equilibrium, co-planar, concurrent, or parallel 8. Which of the following is the SI unit of force? a. Kg m b. Kg m2 c. Kg m2 /s d. Kg m/s2