5. What is the inductance in Henry of an inductor whose reactance is 15.6 2 at 73.0 Hz? Round-off to the nearest ten-thousandth

Q: In a Compton Effect experiment, a photon (λ = 4 × 10-¹⁰ m) strikes an electron at rest and rebounds…

A: Please note : As per answering guidelines I can answer the first question only. Since, this is not a…

Q: 58. . A motorcyclist drives at 22 m/s in a direction 35° east of north relative to a car, and at 8.0…

A: Solution:-

Q: Find the impulse Force 21.16 N Time=0.03 s

A: Given data : Force=F Time=t   Required : Impulse

Q: A 40 cm long copper wire carries a current of 6 A and weighs 0.35 N. A certain magnetic field is…

A:

Q: Find the final velocity of car U=2 m/s t=22 s a=2.44 m/s2

A: Given data : Initial velocity=U Time=t Acceleration=a   Required : Final velocity

Q: Refer to the figure below to answer the following questions. a) Determine the total resistance. b).…

A: Resistance of branches and series  R' = (10+40) = 50Ω  R" = (20+30) = 50Ω  Branches in parallel…

Q: PRACTICE PROBLEM 2.2: By combining the resistors in Figure below, find Req. Answer: 6 Q. 292 352 www…

A:

Q: A diving bell is to be designed to withstand the pressure of sea water at a depth of 900 m. The…

A: a) Determine the total pressure at the depth.

Q: A circuit consists of three resistors connected in series to a 24.0-V battery. The current in the…

A:

Q: Find the mass Density=777 kg/m3 Volume=0.002 m3

A: Given data : Volume=V Density=ρ   Required : Mass

Q: Determine out out on these two please

A:

Q: 2. Determine the combined resistance of three resistors 3.0, 5.00, and 6.00 connected in parallel.

A: Write the given values with the suitable variables. R1=3 ΩR2=5 ΩR3=6 Ω Here, R denotes the…

Q: 11. What is the critical angle for light to stay inside a thin glass rod (n = 1.40) surrounded by…

A: Write the expression for the critical angle. Here, ns represents the refractive index of…

Q: A rickshaw puller pulls the rickshaw by applying a force of 180 N. If the rickaw moves with constant…

A: Given: The applied force by the rickshaw puller is 180 N. The constant velocity is 126 km/h.

Q: if the weight of the meter stick is 10 N, what must be the weight W₂ approximately? If W₂ is placed…

A: Given Data:- Weight of the meter stick is Ws=10 N  is placed at d1=15 cm of the stick. The system is…

Q: 13) Your lungs hold 4.2 L of air at a temperature of 27°C and a pressure of 101.3 kPa. How many…

A:

Q: A football is kicked at 16.5m/s at 570 above the ground. provide a diagram. a)  How long will the…

A:

Q: L. What is the law of reflection? 2. What is the difference between diffuse reflection and regular…

A: When a ray of light from one medium incedent to the surface of another medium then light ray…

Q: Find the pressure Force=2.11 N Area 0.331 m2

A: GIVEN: force =2.11 N Area =0.331m2

Q: A 40 cm long copper wire carries a current of 6 A and weighs 0.35 N. A certain magnetic field is…

A:

Q: How are stationary waves formed in closed pipes ? Explain the various modes of vibration and obtain…

A:

Q: Question 3-a, Numerical: A crane is used to carry a heavy container of 1000 kg as shown in the…

A: Please see the answer below.

Q: Find the time Speed=66.23 km/hr Distance=22 km

A:

Q: A bus is 106 m long runs at 12 m/s. Find the time ?

A: Introduction :  In this question we are provided with value of distance and speed . With these data…

Q: 11) A brass rod is 69.5 cm long and an aluminum rod is 49.3 cm long when both rods are at an initial…

A: Formula for Linear thermal expansion is l = (coeff for linear expansion) * (temp change) * (length)…

Q: A baseball falls from the top of a skyscraper. When it reaches half the terminal speed, the ball…

A:

Q: Question 4-a. Numerical: A river flows east at 3.0 m/s. A boat travels between two cities 3000-m…

A:

Q: Compare the gravitational and electrical forces between an electron and a proton in the hydrogen…

A: Required  comparison between electrical and gravitational forces between electron and proton…

Q: hey, I still need vector line graphs with this question

A:

Q: A gun is fired from the ground with a muzzle velocity of 330m/s at an angle of 25* with the…

A: Here the muzle velocity  of 330m/s and the angle of shooting is not required. And it is given that…

Q: Find the acceleration Force 23.76 N Mass=3 kg

A: Given data : Mass=m Force=F   Required : Acceleration

Q: A parallel-plate capacitor has capacitance 6.00 µF. (a) How much energy is stored in the capacitor…

A: Given,  C = 6 µF = 6 x 10-6 F   (a) V = 4 V Energy stored in capacitor, U = (1/2)CV2 U = (1/2)* 6 x…

Q: 16. What is the power dissipated in Watts by the 9-ohm resistor? Write the answer in whole number.…

A:

Q: 7. How much thermal energy is needed to change 100 g of ice at -20 °C into steam at 110 °C? ™

A: mass of ice = 100 g initial temperature of ice = -20oC final temperature = 110o C , steam

Q: move first with the acceleration profile of: aA = (7t₁ - 10 * cos(t))m/s² here ta is the time in…

A:

Q: A wire 1.5 m long has a cross-sectional area of 2.4 mm2. It is hung vertically and stretches 0.32 mm…

A:

Q: 17) On a cold day, a piece of metal feels much colder to the touch than a piece of wood. This is due…

A: Thermal conductivity of metal is more than thermal conductivity of wood  . therefore we feel much…

Q: An ocean wave has a length of 12 m. A wave passes a fixed position every 3 seconds. What is the…

A: Given data : Time=t Length=d   Required : Speed

Q: A hot gas is injected into an engine at 300°C and exhausts at 70°C . What is the highest efficiency…

A: We have a heat engine in which a hot gas is injected at a temperature T1=300oC=573 K and the gas…

Q: You have an object of mass 1,205 kg, that is a distance 1.0 m above the ground. If we call the…

A: Given Mass of an object = m = 1205 kg Height of the object = 1.0 m We have to calculate the…

Q: 1. What condition is needed for Fraunhofer diffraction? a. The slit must be narrow enough that a…

A: Fraunhofer diffraction is the diffraction pattern which is independent of the distance to the screen…

Q: Two charges separated by 6 meters exert 5-N forces on each other. If the charges are pushed to…

A: We know thatF=KQ1Q2r2WhereF=Electrostatic forceK=Coulomb constantQ1,Q2=Chargesr=Distance between…

Q: A package of mass m is released from rest at a warehouse loading dock and slides down the 3.0 -…

A: a) Apply the energy conservation equation between the top and the bottom to determine the speed at…

Q: How much centripetal force is needed to make a body of 0.5 kg to move in a circle of radius 50 cm…

A: Write the expression for the centripetal force. Here, m represents the mass, v represents the…

Q: To “see” such an orbiting electron by using a light microscope to measure the electron’s presumed…

A:

Q: 7. The point charge Q 18 nC has a velocity of 5×106 m/s in the direction a= 0.30a+ 0.40az. Calculate…

A: Write the expression for the force exerted by the electric field and magnetic field together. Here,…

Q: The weight of the body is 147N What is its mass ?

A:

Q: what is the dot product of C and E, if C = 3.45i - 3.5j + 3.48k and E = -3.6i - 7.11j + 3.13k?

A:

Q: The speed of a wave on a string with a fixed end and a free end is 292.5 m/s. The frequency of the…

A:

Q: Two satellites are placed in their desired orbit by releasing them from the International Space…

A:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.