5.a.Which organization determines allowable maximum fill ratios for different cables? A. IEEE B. IEC C. ANSI D. NEC 5.b. When should corner pull boxes be used in an installation? A. At all 90 degree bends B. At all bends less than 90 degrees C. At all bends greater than 100 degrees D. At all bends

Q: Find I, V1, V2, V3, and V4 in the circuit shown. V2 V, R2 R, 5 kN 3 Vác 3 kl 2 Vac V3 V31 9 Vác 4 kN...

A: I am attaching detailed solution image of this question.

Q: Apply Bilinear transformation to H()=8/[(s+3)(s+4)] with T=0.5s. Find H(z). Realize the filter with ...

A: Hs=8s+3s+4Hs=8s2+7s+12 Putting values of s as, s=2TZ-1Z+1 And,  T=0.5  

Q: What is the instantaneous current at t=1 sec, if a 20 micro-farad capacitor was charged with 10 cos2...

A: It is given that: C=20 μFE=10cos2377tt=1 sec

Q: intrinsic carriers

A: Doping in semiconductor- When impurity us added to a intrinsic semiconductor intentionally for enhan...

Q: Determine the maximum number of convenience outlets of 2 plug for 15, 20, 25 and 30 circuit breakers...

A: Circuit Breaker-Circuit breaker is a device which is used as a switch which breaks the circuit when ...

Q: A 50 Hz, 2 pole, 3Φ star-connected turbo alternator has 54 slots with 4  conductors per slot. The pi...

A:

Q: Write the equivalent logic equation of the circuit on Figure 4.1.

A: The given logic digram consists of switch, NAND gate and LED.The NOT gate is derived from the NAND g...

Q: 1 Ok 2 Oh :4 Oks ELECTONICS Jacov

A: The given circuit diagram is shown below:  

Q: A system contains a "start" push button and a "stop" push button, and an alarm. Design a ladder diag...

A: According to the question, we need to design a ladder diagram.

Q: A load is supplied the complex power S = 60 + j80 VA by a voltage source of 50 cos 377t V. Find the ...

A:

Q: Find the complex power supplied by the source and the power factor of the source for the network sho...

A: The solution can be achieved as follows.

Q: Determine the energy expended moving a charge of 50 u C between two points if the voltage between th...

A: GivenAmount of charge=50μCPotential difference between twop points=6v

Q: A 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a 2...

A: In this question,  We need to determine the value of resistance R if  Current I= 2.302305∠-86.6782° ...

Q: 1.35. Carefully sketch each signal described below. x[n] = {1, -1, 3, -2, 5} a. %3D | T[n] = (0.8)" ...

A:

Q: the frequency that is injected into an AM modulator is 100Mhz and it is combined with another inject...

A:

Q: 20 j 62 HE -j20 j20 10 I -j20 j42 24 Vac -j20 all HE

A: This is a complex network as it has both capacitors and inductor with it Note that the voltages at s...

Q: PARTS A- C Read and Solve carefully please Write clearly and Box the Final answer(s) & label them Pa...

A: I am attaching a detailed solution images of this question.

Q: Calculate the number of bits per signal element and the channel SHIRAS that will permit a bit rate R...

A:

Q: Si 10 mA 2.2 k2 1.2 k2

A:

Q: Design a heart rate monitoring system using MAX30100 sensor. This sensor provides output voltage in ...

A: According to the question, we need to design ADC a) Design a three bits of binary output ADC using c...

Q: three-phase, star-connected synchronous generator driven at 750 rpm is  required to generate a line-...

A:

Q: 2. For the Boolean function below: (a) List the truth table; (b) Express the function as sum of mint...

A:

Q: Find the value of the following Wilkinson's Factor: 8.

A: I am attaching detaild solution image of this question.

Q: For the LC oscillator shown in Figure 2: a) Calculate the feedback gain b) Calculate the frequency o...

A:

Q: 1 Ohm 2 Ohms Ohms 4 Ohms ELECTONICS H 220V H Ohms

A: Brief description:  In the above given question they have mentioned an electrical circuit which is h...

Q: Determine the maximum number of lighting outlets for 15, 20, 25 and 30 circuit breaker

A:

Q: Part A Use the mesh-current method to find the total power dssipated in the circuit in (Eigure 1). S...

A: In this question we need to find a power dissipation in the given circuit. To calculate power dissip...

Q: An alternator has been dismantled and the rotor slip rings are blackened with carbon deposits. Techn...

A: The brush are used to make a contact between the rotor conductor and the external circuit. Brush res...

Q: An impedance coil is connected in series with a capacitor across a 220 V, 60 Hz ac supply. The circu...

A:

Q: Sketch the output waveform of the given circuit, assuming that the voltage of the battery is 1V and ...

A: Given 

Q: 1- Identify the DC motor that can be used in Electric Traction vehicles. Also, explain the requireme...

A: Ans:- In case of traction DC Series motor is a preferable choice. DC series motor will be analysed f...

Q: Solve for i(t). * 100 S cos SV 15 cos S V *0.08 F

A:

Q: Find the resonant frequency for the network below. The circuit is energized by a 24-Vac, variable fr...

A:

Q: A 100-mH inductor is connected in parallel to the series connection of a variable resistor R and a 2...

A:

Q: frad the Volume bonded by a uylindrical aoerelinecte P=2m to 3m 6= 0→ 2M a.65 mB

A: Cylindrical co-ordinate: It is a three-dimensional coordinate system for pointing a point in space b...

Q: Vcc 1 3 5 1 2 1 3 Figure 4.4 4)

A:

Q: 3.1. Consider the integrator in Figure P3.1.This system is described in Example 3.1 and has the impu...

A:

Q: Given the circuit shown, Calculate the Peak Output Voltage. Express your answers in two decimal plac...

A: Given circuit is a centre tapped bridge rectifier with transformation of step down operation RMS val...

Q: A 3ϕ , star-connected synchronous generator driven at 750 rpm is required to generate a line-to-line...

A:

Q: 1 Ohm 2 Ohms 4 Ohms 4 Ohms ELECTONICS HU acov A07 H Ohms m

A:

Q: Ex. 1631. In Fig 1628 Vd=3.3V, Rcoil=201 Ohms, beta_meter_measure=211, V_BE=0.7V Calculate Ib assumi...

A: Given that,VCC=12VVd=3.3VRcoil=201Ω,βmeasured=211VBE=0.7V

Q: Solve I

A:

Q: Given a transistor amplifier of gain ß = 100 with emitter bias, determine the values ​​of Rb and Re ...

A: Given: Given a transistor amplifier of gain ß = 100 with emitter bias, given that Rc is equal to 1 k...

Q: QUESTION 36 For the step down transformer below the turns ratio is 4: 1, the primary voltage is 170 ...

A: This question belongs to electrical machine . It is based on the concept of power developed in singl...

Q: Draw a logic gate circuit for the following functions: F = AB’ + C’(A + B) F = (X’Y+Z) + (X +YZ’)

A: (1) The function F = AB’ + C’(A + B) is implemented by using NOR gate, AND gate and OR gate.

Q: For the parallel diode configuration of the figure, determine Vo,4, Ipiand Ipz- 0.35 A 10V

A: This question belongs to analog electronics . It is based on the concept of working of two identical...

Q: 9.a. What should be done with the connector ferrule once a connector is attached to a fiber optic ca...

A:

Q: Two similar 6,600-V, 3-φ, generators are running in parallel on constant-voltage and  frequency bus ...

A:

Q: 6) What is the voltage and current at location A with (1) the switch open and (2) the switch closed ...

A:

Q: A piece of resistance wire, 15.6 m long and of cross-sectional area I2 mm" at temperature of °C, pas...

A: 1. It is given that: L=15.6 mA=12 mm2=12×10-6 m2V=240 VI0=7.9 A  (At 0°C)      

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.