ect with dimension. mode 50 R20 Ø20 25 15 Ø32 Ø60 80 45 50 60

Q: A particle is moving along a straight line and its acceleration in m/s 2 is given by: a = 6t−18. The…

A: Given:a=6t-18u=15 m/s

Q: An air-standard Brayton cycle has a pressure ratio of 12. Find the thermal efficiency of the cycle

A: Given data:

Q: Before entering the engine of a BMW320D, air drawn in at 20°C and atmospheric pressure enters the…

A: Given Data The initial temperature is:Ti=20°C The volume flow rate is:V˙=120litres/minute=120×10-3…

Q: General Directions: Solve what are asked for in the following problems. Show complete solutions by…

A: Given:- Length of rod=6 m,Point load at A=-2 N ↓,Point load at B=3 N↑ ,Point load at C=-2 N↓ ,Point…

Q: 1 Different representation of gas cycle P 2Po D Ро V Vo 3Vo Figure 1: Problem 1, an ideal gas cycle.…

A:

Q: = 0 MPa, Txy = 0 MPa, Given the following state of stress where ox = 50 MPa, oy (i) draw Mohr's…

A:

Q: Q4: The 2-Mg uniform pole in Fig.4 is supported by a ball-and -socket joint and two cables Determine…

A: Find the tension in cables .

Q: Water is flowing is to be pumpel for 1000 m alory 50 mm intonal odameku pipe. at the rcete of 3:0kg…

A:

Q: A WT305 × 41 standard steel shape is used to support the loads shown. Assume w = 40 kN/m, LAB = 2.0…

A:

Q: The strain components ɛx, Ɛy, and yxyare given for a point in a body subjected to plane strain.…

A:

Q: A 16 ft long, simply supported beam is subjected to a 4 kip/ft uniform distributed load over its…

A:

Q: 2. Determine the reactions at 'B' and 'D' 20 kN 6 m 6m 2 m 2m 4 m

A:

Q: 1. An engine operating on the air standard heat engine has 13 KJ heat added at isochoric process,…

A: given; heat added at isobaric pressure (Q)=13KJheat ratio(k)=1.35initial…

Q: A roller coaster is moving at a certain path in the x-y plane and can be considered as a particle…

A:

Q: Starting from x = 0 with no initial velocity, a particle is given an acceleration a = 8(v² + 49)'/2,…

A:

Q: As a means of measuring the viscosity, a liquid is forced to flow through two very large dp parallel…

A:

Q: What water level H must be maintained in the tank as shown in Fig. P. 3.5.20 to deliver a flow rate…

A: Flow rate, Q= 5×10-4 m3/sec Friction factor, f= 0.0295 D= 25 mm= 0.025 m L= 25 m   To find: Water…

Q: An engine operating on the air standard heat engine, initially at 1.02 bar and 23 oC is compressed…

A:

Q: The diameters of the two cylinders A and B in the figure shown are 80 mm and 750 mm, respectively.…

A:

Q: The weight of a Falcon rocket is 500,000 kg. It will be landed on earth at a constant speed of 100…

A: Given data - Initial mass of rocket = 500,000 kg  combustion gases is ejected at a constant rate of…

Q: Q4 The diagram shows the distributed loading profile for building material on a horizontal surface.…

A: Answer: (a) The single equivalent force: 285 kN. (b) The location of equivalent force from point O…

Q: 10N A(2.3, 5) B(3,1.-2) D(-4, -2,0) C(4,0, 10) In the above, B, C, D are fixed and their coordinates…

A:

Q: In a large student house in Sheffield, cold water is supplied by the mains water supply at a…

A: Given data Temperature of water = 10° CVolume flow rate = 24 liters per minute = 0.4 L/s = 0.4 x…

Q: The system in the figure is in equilibrium. A concrete block of mass 216 kg hangs from the end of…

A:

Q: A flat rectangular plate 1 m wide and 2 m long is immersed in water. The shorter side parallel to…

A:

Q: For materials that have very low ductility and high strength and room temperature what is often used…

A: The materials that have low ductility as well as high strength at room temperature are prone to very…

Q: respectively. Determine • The amount of heat absorbed • The amount of heat rejected • The efficiency…

A: To find Amount of heat absorbed amount of heat rejected Efficiency of cycle MEP

Q: What is the benefit of the jet extrusion impact experiment

A: Impact extrusion is a manufacturing method that uses a metal slug to create items comparable to…

Q: 3. A 60-gram mass vibrates in simple harmonic motion (SHM) at the end of a spring. The amplitude of…

A:

Q: 1. Determine the pin reactions at 'A'.

A:

Q: Part A Outside air at a temperature of 25° C is drawn into the duct and then heated along the duct…

A:

Q: A thin outer border of a building's area covers 10×10m^2. The sky temperature is 300K meanwhile the…

A:

Q: An air refrigeration system is required to produce 52.5  kW of refrigerati-on with a cooler pressure…

A:

Q: 3. THE SYSTEM IS 20C. IF ATMOSPHERIC PRESSURE IS 101.03 KPA AND ABSOLUTE PRESSURE AT THE BOTTOM IS…

A: Given dataAtmospheric Pressure = 101.03 kPaAbsolute pressure at the bottom = 231.3 kPaWe have to…

Q: 1. Determine the force equilibrium of the 200-kg crate. Cord BC in each cord for remains horizontal…

A:

Q: VB = (0 B SB VA m/s SA

A:

Q: A liter of water weighs 9 N. Compute it mass in kilograms (UP TO THREE DECIMAL PLACES

A: Given W=9N

Q: The left field wall at a baseball park is 320 feet down the third base line from home plate; the…

A:

Q: AWT305 x 41 standard steel shape is used to support the loads shown. Assume w = 46 kN/m, LAB = 1.2…

A:

Q: 3. At 335 °C, a steam turbine receives 800 kPa of steam. Then expand to a pressure of 0.02 MPa in an…

A:

Q: A flat rectangular plate 1 m wide and 2 m long is immersed in water. The shorter side parallel to…

A: Calculate the distance of the plate centroid from the free surface using the given figure. x¯=0.5…

Q: As shown in Figure 1 of the ski ramp, you need to make sure that the skier lands safe once they jump…

A: positive ax=0 , ay=-gapplying equation of motion along the…

Q: 2. Determine the reactions at 'B' and 'D' 20 KN 6 m 6 m 4 m 12

A:

Q: A tank initially holds 100 gal of a brine solution containing 20 lb of salt. At t = 0, fresh water…

A:

Q: The strain components ɛx, Ɛy, and Yxy are given for a point in a body subjected to plane strain.…

A:

Q: Water is flowing through a circular pipe made of cast iron with a diameter of 26 cm. If Reynolds…

A: Given,  Flow of water through pipe Reynolds number (Re) = 105 Concept: Since Reynolds number (Re)…

Q: The rectangular wings of a microlight aircraft have a combined spanwise length of 9.144 m and…

A:

Q: A steel 0.75-in diameter shaft (G= 12,000 ksi) is subjected to the following torques in lb-ft: TA =…

A: Answer: ◆ The maximum shear stress in the shaft is 7243.318 psi. ◆ The rotation angle of pulley C…

Q: The stresses shown act at a point in a stressed body. The stress magnitudes are Sx = 55 MPa and Sy…

A: GivenSx=55MPaSy=230MPaβ=53o

Q: In a large student house in Sheffield, cold water is supplied by the mains water supply at a…

A: