(6) Calculate the valui of resistors having coloubands in the following order.tù Blue, Grey Orangee,Red, Silvercii, Red, Green ,Yellow, Brown, Gold, Blue

(i) Explanation: According to the color code of carbon resistor, blue stands for 6, grey stands for…

Answered: (6) Calculate the valui of resistors…

(6) Calculate the valui of resistors havring colou bands in the following order. is Blue, Grey, Orange, Red, Seleser cii, Red, Green, Yellow, Brown, Gold, Blue

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 12CQ: Semi-truck or trucks use four large 12-V batteries. The starter systemrequires 24 V, while normal...

See similar textbooks

Related questions

Q: A spherical shell with inner radius r, and outer radius r, is formed from a material of resistivity…

Q: In one form of plethysmograph (a device for measuringvolume), a rubber capillary tube with an inside…

A: Given,

Q: What happened for a conductor at a constant voltage and raising the temperature applied to it? Also…

A: Explanation: Ohm's law states that the current is directly proportional to the potential difference…

Q: If you touch the terminal of a battery, the small area of contact means that the skin resistance…

Q: a conductor hav ing 0.1 inch Determne the resus tamce of diamefer with @ t = 75°c 150 meture leng…

A: Given Diameter = 0.1 inch = 0.254 cm Radius = 0.254/2 = 0.127 cm = 0.127 ×10-2 m Length = 150 m…

Q: 13-15. For the circuit below, i, = 1.4 A. Calculate ix and the total power dissipated by the…

A: io = 1.4 ALet, Ro = 16 Ω, R1 = 8 Ω, R2 = 4 Ω, and R3 = 2 Ω

Q: TA wire A wire B se/2 Assume thot same voltage is applied Current density accras these for wines…

Q: Ps Two Conductancas G ard 62 haring valnes of boo and Joo yn S respectiny , are connactid in…

Q: Can u elaborate the explanation? Does't brightness of lamp depend on power why did they mention only…

A: Solution:

Q: Show that the power dissipated by the load resistor is maximum when the resistance of the load…

A: Consider the network:

Q: Find the cument in the Circait. scame value R/2 Q-1 Each Resistor has and R= 1001, V = SoV, %3D

A: For the given circuit, the circuit is symmetry, therefore IA=IB. The equivalent circuit is The…

Q: If the resistance of a small immersion heater (to heat water for tea or soup, Fig. 18–32) was…

A: Resistance of water heater increased

Q: In he crcut shown in (Figure 3), you replace the 2 fi resistor between points band d with a 4.00…

A: According to Guidelines, I can help you with 3 parts of the question. If you need help with other…

Q: For some an application, it is important that the value of a resistance not change with temperature.…

A: Given: Total resistance of carbon & nichrome wire-wound resistor, Rt=4.7 kΩ Standard data:…

Q: Find ve(t) in the circuit of Fig.7 if v,(t) = 2e-3tu(t).

Q: Given that the delivered power to a resistor is equal to P when the current flowing in the resistor…

A: Option c = 146.4 P is the answer

Q: hrom preant in she X-HAy machine ahoe acakmhing Porentiel is 50 ou0 V ah

Q: -: Q) Find Vo by using Thevenins Therom 4Ω 1Ω ww ww 50 ЗА 16 Ω 10 Ω V. 12 V

A: converting the circuit into thevenin's circuit to find Rth short circuit all the voltage source and…

Q: If the resistance of pure iron is 0.10 Ω at 20oC and the temperature coefficient of iron is 5.0 x…

Q: A 60 W fluorescent bulb has resistance of about 12 Ω when cold (30˚C) and 120 Ω when on (hot).…

A: Given that, A 60 W fluorescent bulb has resistance of about 12 Ω when cold (30˚C) and 120 Ω when on…

Q: (II) Three 1.7 -KΩ resistors can be connected together infour different ways, making combinations of…

A: The first case of the three resistors connected together in series combination. The net resistance…

Q: Q: For a Si conductor of length 5um doped n-type at 1015scm-3. Calculate the current density for an…

A: Given: Length of the silicon conductor = 5μm Applied voltage = 2.5 V The mobility of the charge…

Q: 3.72 By inspection, write the mesh-current equations for the circuit in Fig. 3.116. 8 V 4 V ww- 5Ω…

A: Ohms law states that when a conductor is placed in the potential difference, the voltage is directly…

Q: The resistance of a silver wire is 0.30 at 20°C, at what temperature will its resistar 5% if its…

A: Given data: Initial resistance Ri=0.1 Ω Final resistance Rf=25100×0.3=0.075 Ω Temperature T1=20° C…

Q: Rank the following arrangements of three identical resistors according to decreasong equivalent…

A: “Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: The wires of our appliances are insulated with a material mixed with rubber, which has a very high…

A: The resistance of the insulating material is R=ρlA=ρlπro2-ri2=1013 Ω·m2.5 mπ5×10-3 m2-0.5×10-3…

Q: At wha temperature would be resistance of a copper conductor be double its resistance at zero degree…

Q: When two unknown resistors are connected in series with abattery, the battery delivers 225 W and…

Q: Unreasonable ResultsTwo resistors, one having a resistance of 145 Ω , are connected in parallel to…

A: R1 = 145 ohm R = 150 ohm

Q: R. Twr resistors R,=500 f R,=75 Are comectad in poralel and the combination is fomserd bong ar…

Q: (II) Eight 7.0-W Christmas tree lights are connected inseries to each other and to a 120-V source.…

A: Given: The power of each bulb is 7.0 W. The number of bulbs is 8. The voltage is 120 V.

Q: Can you think a situation in which measurement of a resistor’s value would be important?

A: When we apply potential difference across a circuit then current flows through the circuit. To…

Q: A coil of 400 turns is wound uniformly on an annealed steel core with a mean-circumference of 0.2 m…

Q: What Curtent flows f pomthe battery in Flg, 13-5? 256

Q: Four 60-W 110-V bulbs are to be operated from a 230-V source. Determine the value of the resistance…

A: Power of each bulb = 60 W Voltage across each bulb = 110 V Voltage of the source = 230 V

Q: Calculate the collector-emitter voltage for this emitter-stabilized circuit. +15V

Q: If a wire is stretched to double its original length without loss of mass, how will the resistivity…

A: The resistivity of material is a property of material it is fixed for material.

Q: A cylindrical resistor is to be constructed so that it offers the same resistance whether the…

A: The length of the resistance in millimeter is 81.5 mm , in centimeters it is 8.15 cm

Q: The pitential at the terminals of the battery falls from aV on arcost to a volts when a resistar of…

A: Given EMF E = 9 Volt External resistance R = 10 0hm Terminal potential V = 6 volt

Question

(6) Calculate the valui of resistors having colou
bands in the following order.
tù Blue, Grey Orange
e,
Red, Silver
cii, Red, Green ,
Yellow, Brown, Gold, Blue

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Semi-truck or trucks use four large 12-V batteries. The starter systemrequires 24 V, while normal operation of the truck’s other electrical components utilizes 12 V. How could the four batteries be connected to produce 24 V? To produce 12 V? Why is 24 V better than 12 V for starting the truck’s engine (a very heavy load)?
When the potential difference across a certain conductor is doubled, the current is observed to increase by a factor of 3. What can you conclude about the conductor?
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-M Ω resistor to 90.0% of its final voltage.
Can anybody be shocked when touching a wire carrying a very large current with a low voltage source? Why?
A block of weakly-conducting material with conductivity sigma has two pieces of metalembedded inside, which form a capacitor with capacitance C.(a) Find the resistance R between the two pieces of metal.(b) At t = 0, the two pieces of metal have a potential difference V0, and at future times t not equal to 0the potential is V (t) = V0e-t/TFind T
Is it possible to connect a group of resistors of value R in such a waythat the equivalent resistance is less than R? If so, give a specificexample
Would your headlights dim when you start your car’s engine if the wires in your automobile were superconductors? (Do not neglect the battery’s internal resistance.)
Using the exact exponential treatment, find how much time is required to charge an initially uncharged 132 pF capacitor through a 73 MΩ resistor to 90% of its final voltage.
When two unknown resistors are connected in series with abattery, the battery delivers 225 W and carries a total currentof 5.00 A. For the same total current, 50.0 W is delivered whenthe resistors are connected in parallel. Determine the value ofeach resistor.
Using the exact exponential treatment, find how much time is required to discharge a 250-μF capacitor through a 500-Ω resistor down to 1.00% of its original voltage.
Why can't the current flow uniformly (linear over time) when the capacitor is charging or discharging? For example, why doesn't the charge just flow at a steady rate off of the capacitor while discharging?
The emf of a battery is E = 12 V . When thebattery delivers a current of 1 A to a load, thepotential difference between the terminals ofthe battery is 10 V volts.Find the internal resistance of the battery.Answer in units of Ω.