Answered: Using the exact exponential treatment,…

Using the exact exponential treatment, find how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-M Ω resistor to 90.0% of its final voltage.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 49P: The timing device in an automobile's intermittent wiper system is based on an RC rime constant and...

See similar textbooks

Related questions

Q: A capacitor of capacitance 5.0×10-6 F is discharging through a 4.0-MΩ resistor. At what time will…

A: Energy stored in a capacitor at time t in terms of the initial energy stored

Q: Consider a series RC circuit for which R = 7.5 M2, C = 6.5 µF, and E = 29 V. Find the charge on the…

Q: A capacitor bank is designed to discharge 5.00 J of energy through a 10.0-kΩresistor array in under…

Q: Consider a series RC circuit as in Figure below for which R =3.4 MQ, C=9.8 µF, and ɛ=30.0 V. Find…

A: Capacitance is defined as the ratio of the charge stored to the potential difference applied across…

Q: A 2.00- and a 7.50- Fµ capacitor can be connected in series or parallel, as can a 25.0- and a100-kΩ…

Q: A 10.0-V-emf battery is connected in series with the following: a 2.00-µF capacitor, a 2.00-N…

A: C = 2 μF R = 2 ohm Vbattery = 10 volts

Q: A Christmas light is made to flash via the discharge of a capacitor. The effective duration of the…

Q: A 3.00 M resistor and a 1.00 mF capacitor are connected in series with an ideal battery of emf e=…

Q: Consider a series RC circuit as in Figure below for which R =1.5 MQ, C=6.5 µF, and ɛ=30.0 V. Find…

A: Given thatε=30 Vc=6.5 μFR=1.5 MΩ

Q: A capacitor of capacitence 5.0×10^-6 F is discharging through a 4.0M-ohm resistor. At what time will…

Q: Using the exact exponential treatment, determine how much time is required to charge an initially…

A: Write the given values with suitable variables. R=75 MΩ=75×106 ΩC=100 pF=100×10-12 FVV0=0.9 Here, R…

Q: A 0.7-F capacitor is connected in series with a 9-ohm resistor. If the connection is energized from…

A: Capacitance of capacitor C = 0.7 F Resistance R=9 Ω Voltage V = 11 V Initial charge Q0=175 mC =…

Q: ain car battery with a 12.0 V emf has an initial charge of 162 A·h. Assuming that the potential…

Q: If two 20uf capacitors in series were connected to two 1 k ohm resistors in parallel… what would the…

A: Given, Two capacitor of capacitance C = 20 μF Resistance R = 1 kΩ = 1000 Ω

Q: Consider a series RC circuit as in Figure below for which R =6.5 MQ, C=4.3 µF, and ɛ=30.0 V. Find…

A: After a very long period of time the capacitor starts to behave as an open switch. Therefore the…

Q: In an RC series circuit, E = 20.0 V, R = 1.60 M2, and C = 1.80 µF. (a) Calculate the time constant.…

Q: A 15.0 μF capacitor initially charged to 23.5 μC is discharged through a 3.50 kΩ resistor. How long…

A: When a charged capacitor is conneted to the resistance and also form a closed loop then the current…

Q: How long will it take a charged 80-uF capacitor to lose 30% of its initial energy when it is allowed…

Q: Consider a series RC circuit for which R = 4.0 M2, C = 5.5 µF, and E = 33 V. Find the charge on the…

A: Given R = 4M ohm (Resistor) C = 5.5microF (capacitance) e = 33V (emf of the battery) To…

Q: The timing device in an automobile's intermittent wiper system is based on an RC time constant and…

A: Given: The capacitance of the circuit is 0.4 μF. The resistance of the circuit is variable.

Q: Using the exact exponential treatment, find how much time is required to discharge a 250-μF…

Q: Consider a series RC circuit as in Figure below for which R =3.4 MQ, C=9.8 µF, and ɛ=30.0 V. Find…

Q: What value resistor will discharge a 1.0 µF capacitor to 10% of its initial charge in 2.0 ms?

A: Write the given values of the problem- Discharge=1.0 μF Capacitor=10 % Initial charge=2.0 ms

Q: A resistor and a capacitor are connected in series across an ideal battery having a constant voltage…

A: We know that when the capacitor is charged it acts as a short circuit so here initially when the…

Q: A voltage ΔV is applied to a series configuration of n resistors,each of resistance R. The circuit…

A: Formula to calculate the resistance across the circuit when resistors are connected in series…

Q: In an RC series circuit, ε = 12.0 V, R = 1.71 MΩ, and C = 2.18 µF. (a) Calculate the time constant.…

Q: Using the exact exponential treatment, find how much time is required to charge an initially…

A: Resistance , R = 73 MΩ = 73 x 106 Ω . Capacitance , C = 132 pF = 132 x 10-12 F Rate of final voltage…

Q: The time, in seconds, for the current through a 652-ohm resistor in an RC circuit, with an initially…

Q: What value resistor will discharge a 2.90 μF capacitor to 20.0% of its initial charge in 2.60 ms?

A: Formula for the discharging of a capacitor is:

Q: In a RC circuit with power supply with an emf of 10 V, capacitance 5 µF, and resistance 10000, the…

Q: A 0.8-F capacitor is connected in series with a 7-ohm resistor. If the connection is energized from…

A: Voltage across capacitor=V=V0(1-e-tRC) R=resistance C=capacitance V0=maximum voltage

Q: What multiple of the time constant T gives the time taken by an initially uncharged capacitor in an…

A: We know that the charge on the capacitor while charging is given by q = qo(1- e-tτ) where q is the…

Q: In an RC series circuit, emf = 12.0 V, resistance R = 1.21 MΩ, and capacitance C = 1.87 μF.…

Q: If a 10-uF capacitor is connected to a voltage source with v(t)= 50 sin 2000t V determine the…

Q: A 12.4-µF capacitor is connected through a 0.895-MΩ resistor to a constant potential difference of…

A: Capacitance is defined as the ratio of the charge stored to the potential difference applied. Higher…

Q: Consider a series RC circuit as in Figure below for which R =4.9 MQ, C=4.2 µF, and ɛ=30.0 V. Find…

A: Vale of R=4.9Mohm Value of C=4.2micro fared Value of V= 30 volt

Q: If you wish to take a picture of a bullet traveling at 505 m/s, then a very brief flash of light…

A: Velocity , v = 505 m/s Distance , d = 1 mm = 1 x 10-3 m Capacitance , C = 610 μF = 610 x 10-6 F To…

Q: Calculate the terminal voltage for a battery with an internal resistance of 0.950 SN and an emf of…

A: (A) Given Data : The internal resistance of the battery is given as r=0.950 Ω The emf of the battery…

Q: In an RC circuit, show that 1.6 time constants must elapse if an initially uncharged capacitor is to…

A: Recall for charging a capacitor q as a function of time is given by. q=Cε(1-e-tRC)

Q: What is the maximum voltage that can be applied to a 186 k ohm resistor rated at 16 watts? Give your…

Q: A 2.00- and a 7.50-μF capacitor can be connected in series or parallel, as can a 25.0- and a 100-kΩ…

Q: Consider a series RC circuit as in Figure below for which R =7 MQ, C=8.5 µF, and ɛ=30.0 V. Find the…

A: Value of C= 8.5 micro fared Value of E=30 volt Value of R=7Mohm

Q: Consider a series RC circuit as in Figure below for which R =1.9 MQ, C=1.9 µF, and ɛ=30.0 V. Find…

Q: Using the exact exponential treatment, find how much time is required to charge an initially…

A: Given data The capacitance of the capacitor is given as C=50 μF. The Resistance of the resistor R=75…

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

Using the exact exponential treatment, find how much time is required to charge an initially uncharged 100-pF capacitor through a 75.0-M Ω resistor to 90.0% of its final voltage.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 2.00- and a 7.50F capacitor can be connected in series or parallel, as can a 25.0- and a 100k resistor.Calculate the four RC time constants possible from connecting the resulting capacitance and resistance in series.
A 2.00- and a 7.50-F capacitor can be connected in series or parallel, as can a 25.0- and a 100k resistor. Calculate the four RC time constants possible from connecting the resulting capacitance and resistance in series.
Figure 21.55 shows how a bleeder resistor is used to discharge a capacitor after an electronic device is shut off allowing a person to work on the electronics with less risk of shock, (a) What is the time constant? (b) How long will it take to reduce the voltage on the capacitor to 0.250% (5% of 5%) of its full value once discharge begins? (c) If the capacitor is charged to a voltage V0through a 100-O resistance, calculate the time it takes to rise to 0.865V0(This is about two time constants.)
A capacitor with initial charge Q0 is connected across a resistor R at time t = 0. The separation between the plates of the capacitor changes as d = d0/(1 + t) for 0 t 1 s. Find an expression for the voltage drop across the capacitor as a function of time.
The values of the components in a simple series RC circuit containing a switch (Fig. P21.53) are C = 1.00 F, R = 2.00 106 , and = 10.0 V. At the instant 10.0 s after the switch is closed, calculate (a) the charge on the capacitor, (b) the current in the resistor, (c) the rate at which energy is being stored in the capacitor, and (d) the rate at which energy is being delivered by the battery.
Integrated Concepts If you wish to take a picture of a bullet traveling at 500 m/s, then a very brief flash of light produced by an RC discharge through a flash tube can limit blurring. Assuming 1.00 mm of motion during one RC constant is acceptable, and given that the flash is driven by a 600F capacitor, what is the resistance in the flash tube?
Using the exact exponential treatment, find how much time (in s) is required to charge an initially uncharged 120 pF capacitor through a 67.0 MΩ resistor to 91.0% of its final voltage. __________s
Suppose you wanted to charge an initially uncharged 110 pF capacitor through a 55 MΩ resistor to 90.0% of its final voltage. How much time (in s) would be required to do this?
Suppose you wanted to discharge a C = 350 μF capacitor through a R = 350 Ω resistor down to 1.00% of its origional voltage. How much time would be required in seconds?
In an RC series circuit, ε = 12.0 V, R = 1.92 MΩ, and C = 1.51 µF. (a) Calculate the time constant. (b) Find the maximum charge that will appear on the capacitor during charging. (c) How long does it take for the charge to build up to 9.98 µC?
A 2.00- and a 7.50- Fµ capacitor can be connected in series or parallel, as can a 25.0- and a100-kΩ resistor. Calculate the four RC time constants possible from connecting the resulting capacitance and resistance in series.
A 12.4-µF capacitor is connected through a 0.895-MΩ resistor to a constant potential difference of 60.0 V. Compute the charge on the capacitor at the following times after the connections are mad: 0, 5.0 s, 10.0 s, 20.0 s, and 100.0 s. Compute the charging currents at the same instants.