6. A rope assumed massless is stretched horizontally between two supports that are 3.44 m apart. WWhenan object of weight 3150 n is hung at the center of the rope, the rope is observed to sag by 35.0 cm.What is the tension on the rope?

Given, distance betweent he support, x = 3.44 mweight of the object, W = 3150 Nrope is sag by, y =…

6. A rope assumed massless is stretched horizontally between two supports that are 3.44 m apart. When an object of weight 3150 n is hung at the center of the rope, the rope is observed to sag by 35.0 cm. What is the tension on the rope?

6. A rope assumed massless is stretched horizontally between two supports that are 3.44 m apart. When an object of weight 3150 n is hung at the center of the rope, the rope is observed to sag by 35.0 cm. What is the tension on the rope?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter9: Statics And Torque

Section: Chapter Questions

Problem 11CQ: Why are the forces exerted on the outside world by the limbs of our bodies usually much smaller than...

See similar textbooks

Related questions

Q: m=3Kg V=5MIS lDetermine Kinetic energy.

A: Given data : Mass of body=m Velocity of body=V Required: Kinetic energy of body

Q: Part (a) Calculate the height of the cliff in m.

Q: A pendulum is swinging back and forth with no dampening. If the bob completes 1.8 cycles every secon...

A: Given data: Frequency (f) = 1.8 Hz Required: Length of the pendulum (L)

Q: 1. How much heat is required to raise the temperature of 4 gal of water from 60 degrees Fahrenheit t...

Q: A Strong wind blows to the west at a speed of 38.7 mph relative to the ground causing a commercial p...

Q: A particle has a velocity of v= (3i+5j)m/s and a constant acceleration of a=(-1.5i-4.5j)m/s^2 What ...

Q: a typhoon is moving at 55 km/h in the direction 40° south of east. find the horizontal and vertical ...

Q: please explain with solution!

Q: "A board that is 20.0 cm wide, 5.00 cm thick, and 3.00 m long has a density 350 kg/m3. The board is ...

Q: A person used his 1500 W air-conditioning unit for 5 h every day during the month of June. How much ...

Q: At a particular spot on a soap bubble (n = 1.33), you see red light at 675 nm. If that is from the l...

A: Given : Wavelength (λ) = 675 nm Refractive index (n) = 1.33 Order ( m) = 1

Q: Comment on the Phase velocity (Vp) of the waves for increased values of Δω and Δk

Q: - 5.0 nC are positioned at the corners of 10. Three point charges with values +2.0 nC, –-3.0 nC, and...

Q: Four charges were arranged in space such that they form a rectangular configuration. The magnitude o...

A: first charge = 2 nC second charge = 3 nC third charge = 2 nC fourth charge = 3 nCLength of rectange ...

Q: A 0.40 µF and a 0.60 µF capacitor are connected in series to a 9.0 V battery. Calculate (a) the pot...

A: Capacitor,C1 = 0.40 μFC2 = 0.60 μFV = 9.0 V

Q: •51 GO Figure 5-47 shows two blocks connected by a cord (of negligible mass) that passes over a fric...

Q: onsider a force F = 80 N applied to a beam as shown in Fig. 8–37. The length of the beam is l = 5.0 ...

A: Force applied F = 80N Length of rod =5m θ=37°

Q: "A rock is under water in a shallow lake. As the rock sinks deeper and deeper into water, the buoyan...

A: In this question we have to answer about the buoyant force experience by the rock. Please give posit...

Q: The massless spring of a spring gun has a force constant k = 12.5 N/cm. When the gun is aimed vertic...

A: force constant = K = 12.5 N/cm = 1250 N/m mass = m = 10 g = 0.01 kg height = h = 5 m

Q: Is Cross-Sectional Area (CSA) or Drag Coefficient (Cdrag) a better predictor of Drag Force (Fdrag)?

A: Drag force is just like friction force that opposed the motion of object in fluid.

Q: A copper wire that has a radius of 3cm has a uniform charge density of 12 µC/m³. Determine the total...

A: Given data: Radius (r) = 3 cm = 0.03 m Uniform charge density (ρ) = 12 μC/m3 Length (l) = 1.0 m Req...

Q: 2. Physics 100 Lab Rotational Motion and Gravitation PART A: Exploring Rotational Motion Consider a ...

A: We have clock of total width d=30 cm so the radius or size of a hand R=d/2=30/2=15 cm. Also we know ...

Q: 390 m/s due west at one moment and 450m/s due north 10.0 s later. Find the plane’s average accelerat...

A: We know that An airplane is flying 390 m/s due west at one moment and 450m/s due north 10.0 s later....

Q: If the index of refraction for diamond is 2.42, what will the angle of refraction be in diamond for ...

A: Given data: Index of refraction for diamond (n2) = 2.42 Angle of incidence (i) = 60.0° in water Req...

Q: An insulated extension cord is made of a 1.5 m long copper rod with a diameter of 2.3 mm. If an alum...

A: According to question we need to find--- what should be the diameter of the aluminum wire to have t...

Q: At time t, = 2.00 s, the acceleration of a particle in counterclockwise circular motion is (3.00 m/s...

Q: Two particles of masses 1 kg and 2 kg are moving towards each other with equal speed of 3 m/sec. The...

Q: How many revolutions per minute would a 30 m -diameter Ferris wheel need to make for the passengers ...

A: The centripetal force has to be in a way that balances the weight of the passenger.

Q: The drawing shows two situations in which charges are placed on the x and y axes. They are all locat...

Q: You stand in an elevator on a scale. If the scaled reads 9/10 of your weight, what is the accelerati...

Q: A force of 250N exerted at an angle of 30 degrees above horizontal is needed to keep an 800N block m...

Q: A particle moving along the positive X-axis at 3 m/s accelerates at 2 m/s2 in the direction of the ...

A: Initial velocity = 3 ms along + x axis Acceleration = 2 ms2 along +y axis time (t) = 2 seconds

Q: What is the coefficient of friction for a 30 kg block decending a 55 degrees inclined at a constant ...

A: Given: Mass of block =30 kg Angle of incline = 55ο

Q: 1. Find the electric field at a point 2 m away from a very long positive line charge whose charge de...

A: Data Given , Charge density (λ) = 100 nC/m. = 100 × 10-9 C/m Distance ( r ) = 2...

Q: A 0.340 kg particle moves in an xy plane ace (t) = – 15.00 + 2.00t – 4.00 and y(t) = 25.00 + 7.00t –...

A: GivenMass of particlle (m)=0.340 kgx(t) = —15.00 + 2.00t — 4.00t3 and y(t) = 25.00 + 7.0t — 9.00t2

Q: A ray of light is transmitted from air to glass as shown in the figure. What is the refractive index...

Q: A 15-kg block is lifted vertically 10 meters from the surface of the earth. To one significant figur...

Q: A block of mass M, resting on a smooth table, is pulled by a string of mass m. If a for F is applied...

A: Given Block mass, M String mass ,m Force applied to string, F Force string applied to block is ,...

Q: If two balls are released simultaneously from the same height, which one will hit the floor st, the ...

Q: The Deep Space 1 spacecraft’s ion engine produced an average thrust of 37 mN and was fired for a tot...

A: Given Force = 37 mN =37 x 10-3 N Mass of spacecraft =450 kg Time = 16000 hours =16000 x 3600 = 576 x...

Q: A ball is tossed vertically with non-zero positive initial velocity. Which of the following is true ...

Q: n object moves on a horizontal coordinate line. Its directed distance s from the origin at the end ...

Q: Current=5 Ampere Voltage=10 Volt Itage%3D find resistance

A: Data provided: Current (I) = 5 Ampere Voltage (V) = 10 Volt Required: Resistance (R)

Q: There are two vectors: The x and y components of vector A a respectively. The x and y components of ...

Q: B. EQUILIBRIUM OF COPLANAR, NON-CONCURRENT FORCES (10pts.) Directions: Determine the answer for what...

Q: Why is it so important to know the different electric signs?

A: Asked: Why should we know about electric signs.

Q: Four charges form an isosceles trapezoid: Q1 = +2C is located at vertex X; Q2 = -3C is located at ve...

A: Charge q1 =+2C q2 =-3C q3 =+4C q4= - 5C We have the net force exerted by charge 1,2,3 on charge 4

Q: The resistance and the magnitude of the current depend on the path that the current takes. The drawi...

Q: •42 Go In earlier days, horses pulled barges down canals in the manner shown in Fig. 5-42. Suppose t...

Q: When two resistors are connected in series, the total resistance is 72 ohms. When connected in paral...

Concept explainers

Rotational Equilibrium And Rotational Dynamics

In physics, the state of balance between the forces and the dynamics of motion is called the equilibrium state. The balance between various forces acting on a system in a rotational motion is called rotational equilibrium or rotational dynamics.

Equilibrium of Forces

The tension created on one body during push or pull is known as force.

Question

6. A rope assumed massless is stretched horizontally between two supports that are 3.44 m apart. WWhen
an object of weight 3150 n is hung at the center of the rope, the rope is observed to sag by 35.0 cm.
What is the tension on the rope?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The board sandwiched between two other boards in Figure P4.91 weighs 95.5 N. If the coefficient of friction between the boards is 0.663, what must be the magnitude of the compression forces (assumed to be horizontal) acting on both sides of the center board to keep it from slipping? Figure P4.91
Why are the forces exerted on the outside world by the limbs of our bodies usually much smaller than the forces exerted by muscles inside the body?
Show that, as explained in the text, a force F exerted on a flexible medium at its center and perpendicular to its length (such as on the tightrope wire in Figure 5.26) gives rise to a tension of magnitude T=F/2sin() .
Pulling the string on a bow back with a force of 29.0 lb, an archer prepares to shoot an arrow.If the archer pulls in the center of the string, and the angle between the two halves is 128 degrees , what is the tension in the string?
A rope of negligible mass is stretched horizontally between two supports that are 3.44 m apart.When an object of weight 3160 N is hung at the center of the rope, the rope is observed to sag by 35.0 cm.What is the tension in the rope?
Two identical strings making an angle of θ = 30.0° with respect to the vertical support a block of mass m = 15.0 kg (Figure WU4.6). What is the tension in each of the strings?
A 50N body is supported by two ropes, one making 30* with the vertical and the other making 45* with the horizontal. What is the tension in the ropes?
. A tightly stretched horizontal “high wire” is 36 m long. Itsags vertically 2.1 m when a 60.0-kg tightrope walker standsat its center. What is the tension in the wire? Is it possibleto increase the tension in the wire so that there is no sag?
Body A has a weight/force of 441.45N and the coefficient for Body A, Body B and ramp C is 0.10. What is the smallest mass of B to make the system in equilibrium while neglecting the friction between the string and the ramp? Show the complete solution and the FBD. Answer should be: 23.92
The distance between two telephone poles is d = 54.0 m. When a 1.20 kg bird lands on the telephone wire midway between the poles, the wire sags h = 0.206 m. How much tension (in N) does the bird produce in the wire? Ignore the weight of the wire
A climbing anchor consists of two strands of nylon webbing clipped to bolts in the rock. The webbing is clipped into the rope at the other end, with the webbing making angles of 22° and 35° with the vertical. What is the tension in each of the webbing strands if the combined mass of the rope and climber is 85 kg?
A hiker who has broken his forearm rigs a temporary sling using a cordstretching from his shoulder to his hand. The cord holds the forearmlevel and makes an angle of 40.0° with the horizontal where it attachesto the hand. Considering the forearm and hand to be uniform, with atotal mass of 1.30 kg and a length of 0.300 m, find (a) the tension inthe cord and (b) the horizontal and vertical components of the force, f>,exerted by the humerus (the bone of the upper arm) on the radius andulna (the bones of the forearm).