Answered: 6.) A voltage v = 320 sin (100t + π/3)…

Engineering

Electrical Engineering

6.) A voltage v = 320 sin (100t + π/3) is applied to a resistor of 43 ohms. Find the value of power dissipated.

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter29: Service-entrance Calculations

Section: Chapter Questions

Problem 6R: What load may be used for an electric range rated at not over 12 kW? (Table 220.55) _____

See similar textbooks

Related questions

Q: For the circuit shown find the maximum * and minimum values of zener diode current. IL 5 kn www. Iz…

A: We need to find out minimum and maximum current for zener diode for given circuit

Q: Find the electric flux density at a point having a distance 4 m from a uniform line charge of 6 nC/m…

Q: 1. Z-Transform of 8(n+3) is a) z b) z² c) 1 d) z³ 2. A system which is linear is said to obey the…

Q: A toaster oven is rated at 1100 W for operation at 120 V, 60 Hz. ▾ Part A What is the resistance of…

A: Given data : Rated Power of toaster oven P= 1100W Voltage of toaster oven V=120V

Q: A 500-kV, 60-Hz, 3-phase completely transposed overhead line has the resistance R = 0.0201/km, D =…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: What minimum value of series resistance is required when three 10- watt, 10-volt, 1000-mA zener…

Q: An unbalanced star-connected load is supplied from a 400-V, 3-ph, Y-connected alternator through…

Q: Q1) Find lo using current division Show work clearly Q2) Find RAB in the circuit given? 6 ΚΩ 12 mA A…

Q: For the circuit shown determine D1 current * (ID1.) 330 R ID2 D2 Si Vo E = 10 V 16.7 mA 28.2 mA…

A: For silicon diode, cut in voltage is rqual to 0.7 volts. For parallel connection, voltage across…

Q: What system does the emission designation F2D describes? O a. FSK Data O b. Telephone О с. AM TV O…

A: The International Telecommunication union(ITU) uses some codes to describe signals. For example :-…

Q: 6.21 For the circuit in Fig. 6.21, let VBB be set to the value obtained in Example 6.3, part (a),…

A: Consider the given diagram. Given: V=1.7 Vβforced=10

Q: Two balanced three-phase motors in parallel, an induction motor drawing 400 kW at 0.8 pf lagging and…

A: Power Triangle is the right angle triangle it represent the reactive active and apparent power .…

Q: For the circuit shown Vo is: 마 미 20 D. ann -5 2.2km 5V

Q: How does TP4056 works? What is the purpose of red and blue lights in the components?

A: The TP4056 chip is a single-cell lithium-ion battery charger that protects the cell against…

Q: The resistance of a wire is 5Ω at 50°C and 6Ω at 100°C. The resistance of the wire at 0°C will be?

Q: Determine the approximate amount of collector current for this transistor circuit, given the…

Q: The Simulink model shown below in Figure 1 outputs the signals shown in Figure 2: Input…

A: Given simulink model whose input is a sawtooth wave and the corresponding output as shown in the…

Q: A 6-pole alternator running at 1000 rpm, supplies an 8 pole induction motors. Find the actual speed…

Q: Two balanced three-phase motors in parallel, an induction motor drawing 400 kW at 0.8 pf lagging and…

Q: A 10 transformer has 500 primary and 1200 secondary turns. The net cross-sectional area of the core…

Q: Determine Zab in the circuit below. jΖΩ -j4Ω 00- mon Zab both -j4 Ω 6Ω 4Ω 6Ω 6Ω 32 Ω 8 Ω

Q: What is the impulse response of a stable discrete-time system with the following mathematical…

A: We need to find out the inverse z Transform of given system

Q: Draw the small signal equivalent circuit. Determine the following: Zo Zin Av (voltage gain) Ai…

A: The required parameters can be calculated by using the DC and AC analysis of the cascade amplifier.

Q: For the circuit below, find the value of ZT 8Ω -j12Ω Ε = j16 Ω Ε 20 Ω 10 Ω www j15 ΩΣ -j16Ω Στ www…

Q: 3→ D = 4x a If V.D 3za + 2ya C/m², find the following: y

Q: What is the magnitude of the electric field (in N/C) at a distance of 1 mm from a single electron?…

A: Brief description: By knowing the standard electric field expression we need to calculate the…

Q: In this circuit and graph, there are three different load lines plotted, representing three…

A: We need to select correct option for given circuit

Q: 3. If p(x, y, z) = 2xz¹-x²y, find Vo and Vol at the point (2,-2, 1). (b) A-Vp, (c) V-(Vo) at

Q: 5. Calculate the inductive reactance of a 0.9-μH coil at 800 MHz.

Q: A balanced delta-connected load with impedance per phase of 30/30 is connected to an abc-sequence…

Q: Given the electric field E = (y + 1)a + (x − 1)a + 2a, find the У potential difference between the…

Q: A three-phase source has a phase sequence of EAB - EBC - ECA and delivers the following delta load…

Q: An inductor of 2H is connected to a circuit at a frequency of 50Hz. Compute the inductive reactance…

Q: The power input to a synchronous motor is measured by two wattmeters both of which √√3 indicate 50…

Q: 12. Draw the voltage and current waveforms for the circuit of Figure 2.28 if E is a one volt peak…

A: Given data, C=3.3 nF, f=10 kHz, E= 1 V Circuit diagram is given as,

Q: 10.23: For the following electric circuit, find Z and Y (1200+j850)2 (1500+j900) 2 parameters? Also,…

Q: A parallel plate capacitor [Q4] is kept in the air has an area of 0.50m2 and separated from each…

A: Given, A parallel plate capacitor is kept in air with Area of plates, A=0.50 m2 Separation between…

Q: A receiver has two uncoupled tuned circuits before the mixer, each with a Q of 75. The signal…

A: (a) The image rejection ratio is calculated as follows: The image signal frequency for high side…

Q: Q3) For the given circuit, provide the following: Use the conventions covered in lecture (current…

Q: An AM transmitter antenna current is measured with no modulation and found to be 2.6 amperes. With…

Q: A toaster oven is rated at 1100 W for operation at 120 V, 60 Hz. ▼ ▼ Part A What is the resistance…

A: Given, A toaster oven has Rated power, P=1100 W Rated voltage, V=120 V Rated frequency, f=60 Hz

Q: 6.) A voltage v = 320 sin (100t + π/3) is applied to a resistor of 43 ohms. Find the value of power…

A: We need to find out the power dissipation in resistor

Q: If a wave has a period of 0.10 sec, it has a frequency of Select one: a. 0.01 Hz. b. 100 Hz. c. 10…

A: Given, A wave has a period of T=0.10 s

Q: 11. Draw the voltage and current waveforms for the circuit of Figure 2. Figure 2.27 1e-3 sin2pi1000t…

A: In this question , we will draw voltage and current waveform of given circuit....

Q: Two wattmeters are connected for the two-wattmeter method with current coils in lines A and B of a…

Q: If this circuit were used in a digital circuit, it would be a NOT gate. Vcc 5 V Vin True False Vout…

Q: • Choose the correct answer for the power of element 2 and identify if the power is consumed or…

A: Given,

Q: A three-phase source has a phase sequence of EAS- Esc - ECA and delivers the following delta load…

Q: 13. Evaluate * y" − 3y' + 2y = 4e²t ; y(0) = −3, y '(0) = 5 -e2t 4e²t et + 7 7 (1+t)4e²t - 7et 7 B)…

A: given here a equation and asked to evaluate the equation.

Q: Design a simple circuit using Ohm’s law. In the circuit you designed, explain how you could reduce…

A: Power dissipation is the process of generating heat due to loss in the device, in resistors as the…

Question

6.) A voltage v = 320 sin (100t
+ π/3) is applied to a resistor
of 43 ohms. Find the value of
power dissipated.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Exercise 2: Resistance-Inductance Series Circuits on an AC Supply Calculate (a) peak to peak voltage (b) time period (c) Total impedance (d) Total voltage and total current for the circuit given
Explain how Faraday’s law is utilized to generate alternating voltage in a power plant. Based on your understanding of conservation of energy, compare and contrast traditional fossil fuel based power plants to modern wind turbine generators.
a) Find the mathematical expression for current İ2(t)b) Calculate the complex power on the inductance
Three coils each having resistance 6 Ω and inductance L H are connected in star to a 415V, 50Hz, 3-phase supply. If the line current is 30A, find the value of L.
What load may be used for an electric range rated at not over 12 kW? (Table 220.55) _____
Exercise 1: Resistance-Inductance Series Circuits on an AC Supply Calculate (a) peak to peak voltage (b) time period (c) Total impedance (d) Total voltage and (e) total current for the circuit given
Ohm's law describes the relation of energy and power dissipated by an element. Select one: True False
A resistance 10 Ω and inductance 100mH in series, is connected to a 200V, 50 Hz supply. Calculate (a) the current flowing, (b) the phase difference between the supply voltage and current, (c) the voltage across the Resistance and (d) the voltage across the inductance.
Design a solar tower power plant and concentrating solar power plantfor electric generation explain using diagrams
A resistance 10 Ω and inductance 100 MicroF in series, is connected to a 200V, 50 Hz supply. Calculate (a) the current flowing, (b) the phase difference between the supply voltage and current, (c) the voltage across the Resistance and (d) the voltage across the capacitance.
Power Electronics: According to the information obtained from the catalog, the threshold voltage value and internal resistance of the thyristor:V = 2v, R=0.84 milliohm,The current given in the figure passes through this thyristor. Wave information:Im = 1000 AD = 20f = 200hzWhat is the active power consumed on this thyristor in watts?A)184.6B)97.8C)284.3D) 382.5E) 137.2
Three coils each having resistance 6  and inductance are connected in star with 415V. If the line current is 30 A, If θ = 45 then calculate the power dissipation in kW when it is connected in Delta?