CO,m = 1 kg i m = 0.5 kgP= 3 atm P= 2 atmN2Diaphragm,InsulationT= 338 K_} T= 282 K[Hint: Since the tanks are well insulated, there is no heat transfer with the sur-roundings. Since the boundaries are fixed, there is no work. Hence, from the firstlaw, U2 = U1]. 6. Consider two well insulated-tanks as shown in the figure. The tanks containcarbon dioxide and nitrogen at the given pressures and temperatures. The ther-mally non-conductive diaphragm is now removed. Find the final temperature andpressure of the mixture at equilibrium.

Answered: Image /qna-images/answer/340de412-e494-43e8-a322-859e4c1a1d65.jpg

6. Consider two well insulated-tanks as shown in the figure. The tanks contain carbon dioxide and nitrogen at the given pressures and temperatures. The ther- mally non-conductive diaphragm is now removed. Find the final temperature and pressure of the mixture at equilibrium.

6. Consider two well insulated-tanks as shown in the figure. The tanks contain carbon dioxide and nitrogen at the given pressures and temperatures. The ther- mally non-conductive diaphragm is now removed. Find the final temperature and pressure of the mixture at equilibrium.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

How much heat must be added to a 0.3 m2 rigid volume containing water at 200 C in order that the final temperature is raised to 800 C? The initial pressure is 1 MPa
In a container with a fixed volume of 2 m3, there is saturated liquid vapor mixed water at a pressure of 100 kPa initially. In this case, three-quarters of the total mass is in the liquid phase. Then the electric heater inside the container is operated. Calculate the electrical work required to evaporate all of the liquid in the container in case of a heat loss of 120 kJ / kg from the container to the environment. Plot the process saturation curves and constant pressure curves on the T-v diagram.
Consider a 1.36-kg solid spherical aluminum with a cylindrical hole. It is supported by an insulating base. Initially, it has a temperature of 235°C. Then a 85.0-g water at a temperature of 24.5°C is poured filling the cylindrical hole. (a) How much water will be left in the hole after the temperature of the aluminum-water9 system stabilizes? (b) What will be the final temperature of the system?
Two spheres each 3.0ft in diameter are connected by a pipe in which there is a valve. Each sphere contains nitrogen gas with sphere A has a temperature of 80°F, while the other is 120°F. With the valve closed, sphere A has a gauze pressure of 51.9 psi and the other 10.9 psi. After the valve has been open long enough for equilibrium to obtain, what is the equilibrium temperature if the final pressure is 35.2 psig?
The relatice humidity in a room of 2mx3mx6m is 80% at 18 °C. A cylinder with 2dm^2 area is placed in the middle of the room with 4 liter water inside (density=1gcm^-3) The room is closed. We increase the temperature of the room to 25 °C and wait for equilibrium to set in. Calculate the height of the remaining water column in the cylinder. The vapor pressure of water at 18 °C is 2065 Pa and the enthalpy of vaporization is 44kJ/mol within the investigated temperature range.
You are required to purchase a 3,000 L tank of liquid butane to heat a maintenance building during the winter. You are concerned about the tank rupture and the possibility of a vapour cloud explosion of all the butane. How far (in metres) must the tank be from the maintenance building to ensure that it will receive only partial demolition in the event of an explosion? The specific gravity of liquid butane is 0.6, and the energy of explosion for butane is 510 kcal/gm-mol. Assume the explosion efficiency is 10 % in this case.
Plot the process on pv diagram which show the state points relative to the vapor dome. Label the states 1,2,3.. to indicate the sequence of the change in state.
Given the pressure - volume diagram in figure below. Assume ideal gas undergo cyclic process. Path AB is adiabatic compression while path CD is adiabatic expansion. Also, paths BC and DA are isochoric processes. Ifthe value of y is 1.5, and the ratio of VilVy = 10 a. Calculate: QoalQsc b. Calculate Was assuming initial volume Vi= 2L and Pi = 1 atm. P C
When water boils in a pot with a loose lid, the increased pressure forces the lid upward, releasing steam and reducing the pres- sure in the pot so that the lid drops back down. If the water continues to boil, the lid can rattle upward and downward. Consider a 1 L pot half filled with boiling water. In this case there is half a liter, or 1 mol, of air and steam above the water. (a) Estimate the mass of the lid. (b) When the water is rapidly boiling, estimate the height to which the lid jumps during a steam-release event. (c) By multiplying the weight of the lid by the height of the jump, estimate the work done by the steam as the lid moves upward. (d) Treat the process as adiabatic and use the first law of thermodynamics to estimate the drop in the temperature of the steam as it pushes the lid upward.
A large mining company was provided with a 3 m3 of compressed air tank. Air pressure in the tank drops from 700 kpa to 180 kpa while the temperature remains constant at 28°C. What percentage has the mass of air in the tank been reduced? (neat hand written)
2) Two glass bulbs, one on the left with a volume of 2 liters and the other on the right with avolume of 6 liters, are connected to one another by a thin tube that is initially closed by astopcock. The bulb on the left has 0.1 moles of ideal gas, and the bulb on the right isevacuated. The system is in thermal equilibrium with the surroundings at 300K. When thestopcock is opened, the gas flows out to fill both bulbs. Calculate A for this process. If wewere to insert a propeller to extract work as the gas flows from left to right, what is themaximum amount of work that we could possibly extract?
A spherical balloon filled with H2 gas to a volume of 3.35x10-2 m3 at 17 °C is carefully lowered into the sea to a depth of 50 m, where the seawater temperature is about 12 °C. Assume the gas is always in thermal equilibrium with the surrounding seawater. The atmospheric pressure at the surface is P0 = 1.013 x 105 N/m2 and the specific gravity of the seawater is 1.03. What is the change in thermal energy of the gas from surface to 50 m below?