6. To Check the working condition of fuse the knob should be at FLUK E 79 SERIES EMULTIMETEROFFHzC.DAPRESS4onRANGE OE AUTORANGE, 40nG.FOUCH HOLO)10A401000V750VCOMFUSED

A fuse is an electric safety device which use to protect the other devices by overcurrent, it…

Answered: 6. To Check the working condition of…

Science

Physics

6. To Check the working condition of fuse the knob should be at FEDA

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter7: Electricity

Section: Chapter Questions

Problem 14P

See similar textbooks

Related questions

Q: Difference between OPEN LOOP and CLOSE LOOP?

Q: Modified True or False: Write TRUE if the statement is valid and FALSE if otherwise. If the…

A: Ans:-1 False:- Transmission system is a high voltage transmission line that carries electricity from…

Q: A step-down transformer has a turns ratio of 1:10, and its primary is connected across the terminals…

A: If a voltage 'V' is applied across a resistance 'R', then the power dissipation in that resistor is:…

Q: When a switch ima. Circuits is closed, the light turns on. Explain why this happens.

Q: 22. The graph shows the variation with time of the output voltage V for the rotating coil generator.…

A: The output voltage of the rotating coil generator is, E=NPZϕ60 A here N is the rotational speed of…

Q: A 230 V emf is across a transformer's 140-turn primary coil. What is the emf in the 220-turn…

A: The equation for the transformer is given by,

Q: Give difference between AC generator and DC generator.

A: Sl. No.Differentiating PropertyAC GeneratorDC Generator1DefinitionAC generator is a mechanical…

Q: Load Resistance used in ohms Primary coil turns (Np) Secondary coil turns (Ns)

A: Since you have posted questions with multiple sub-parts, we will solve the first three for you. To…

Q: 47. (II) (a) What is the maximum instantaneous power dissi- pated by a 3.0-hp pump connected to a…

A: Power rating of pump = 3 Hp Vrms = 240 Volts

Q: How can we calculated power drawn from the 12-2 DC supply ww 3-62 w A₁ Svolts

Q: A transformer has 430 turns in the primary coil and 140 in the secondary coil. By what factor does…

Q: Consider the following circuit 402 ww +1.5V 60 ww +3V 302 ww Calculate the current in the left loop,…

A: Emf of cell in left loop is V1 = 1.5 V Emf of cell in the right loop is V2 = 3 V

Q: (II) The generator of a car idling at 1100 rpm produces12.7 V. What will the output be at a rotation…

A: Given: The generator of a car idling at 1100 rpm E1 = 12.7 V To determine: the output is at a…

Q: Which of the following statements about an ac process is untrue? The change in entrony is zero

A: Given Data : Adiabatic process

Q: 32. find the capacitance of the capacitor. 33. find the average power dissipated by the resistor.…

A: Impedence = v/I = 120 / 0.6 = 200 ohm Inductive reactance = wL = 188.5 ohm 32)Therefore,…

Q: In series circuit, if anyone of the resistor is short circuited, the remaining part of the circuit…

A: In series circuit, all the resistors are connected end to end with each other. Thus, the same…

Q: In which of the following circuits would the fuse blow as soon as the switch is closed" A D E

A: Concept. : Fuse will blow if there is a short circuit.

Q: In a power supply diagram, which block indicates a smooth dc output? O rectifier O regulator O…

A: To identify : The component which helps to smooth a dc output

Q: Apply the loop rule to loop abcdefgha

A: Given data: The first emf is: E1 = 24 V The third emf is: E3 = 6 V The fourth emf is: E4 = 36 V The…

Q: A generator produces 18.0 V when turning at 920 rev/min. What emf does it produce when turning at…

A: Let, E1=18.0 Vf1=920 rev/minf2 = 520 rev/min To determine: E2

Q: given that a 1760W motor is connected to AC network in our lab and the flowing current is 9A. Find…

A: solution is given by

Q: Why does AC power alternate ?

A: Ac power is defined as a flow of charge that exhibits a periodic change in direction. This is known…

Q: In a power supply diagram, which block indicates a smooth dc output? rectifier regulator O filter…

A: A power supply is a type of electrical equipment used to provide electricity to an electrical load.…

Q: A generator supplies 110 V to a transformer's primary coil, which has 57 turns. If the secondary…

Q: series RL circuit with R = 10 Q and L= 3 H has a constant voltage E applied at t = 0 by the closing…

A: In LR Circuit current can be given as I = V/R ( 1- e-Rt/L )

Q: Just after the switch has been closed, why does I=0?

A: Just after the switch has closed, voltage induced across the inductor. And from Lenz's law , voltage…

Q: A generator produces 18.0 V when turning at 920 rev/min. What emf does it produce when turning at…

A: Given data The emf produced by the generator E1 = 18 V at the frequency n1 = 920 rev/min. Another…

Q: A 220 V emf is across a transformer's 140-turn primary coil. What is the emf in the 220-turn…

Q: 4 value A step-down transformer (turns ratio = 1:7) is used with an electric train to reduce the…

A: Given: Current in secondary coil, I2= 1.06A Current in primary coil, I1 = ? N2N1= 17…

Q: In a power supply diagram, which block indicates a smooth DC output? O rectifier regulator filter…

A: Draw the block diagram of the power supply.

Q: A 140 V emf is across a transformer's 190-turn primary coil. How many turns should the secondary…

Q: 2: Explain how we can change A.C generator to D.C generator

Q: furns and a secondary colil aof 88 turns b) resistor lamp AC A Figure 18.36 a) If the primary coil…

Q: The load resistance on the output side of the transformer is 100Ω. What is the current flowing on…

A: Given data: Load resistance on output side (R) = 100 Ω Secondary voltage (Vs) = 60 V Primary…

Q: i) List any two uses of RLC circuits.

Q: Explain AC generator.

A: AC generator is device which converts mechanical energy into electrical energy in the form of…

Q: In the Open-circuit test of the transformer (OC TEST) wattmeter measures 2.7 kW, in the short-…

A: Introduction: The open-circuit test is performed to determine the iron loss of the transformer, and…

Q: 28b) When load current increases, the terminal voltage of DC shunt Generator is reduced. Justify

Q: A generator supplies 130 V to a transformer's primary coil, which has 56 turns. If the secondary…

A: It is given that, Vp=130 Vnp=56ns=470

Q: A generator produces 24.0 V when turning at 900 rev/min. What emf does it produce when turning at…

A: The formula for the emf generated is given by e = N B A w where, N is the number of turns, B is the…

Q: Suppose the speed of rotation of the coil in an AC generator is doubl happens to the amount of…

Q: An ideal 15-kVA transformer has 300 turns on the primary winding and 50 turns on the secondary…

Q: 2. What will happen to the rest of the light bulbs if..... VVVVV JOUE 3 5 2 (a) the switch is…

A: "Since you have posted a question with multiple sub-parts, as per strict guidelines to us we will…

Question

6. To Check the working condition of fuse the knob should be at

FLUK E 79 SERIES EMULTIMETER
OFF
Hz
C.
D
A
PRESS
4on
RANGE O
E AUTORANGE, 40n
G.FOUCH HOLO)
10A
40
1000V
750V
COM
FUSED

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Apply the loop rule to Loop afedcba in die preceding problem.
Apply the loop rule to loop aedcba in Figure 21.25.
Suppose you have a motor with a power factor significantly less than 1. Explain why it would be better to improve the power factor as a method at improving the motor's output, rather than to increase the voltage input.
If the power output in the previous problem is 1000 MW and line resistance is 2.00 (, what were the old and new line losses?
A switch has a variable resistance that is nearly zero when closed and extremely large when open, and it is placed in series with the device it controls. Explain the effect the switch in Figure 21.43 has on current when open and when closed.
Apply the loop rule to loop abcdefgha in Figure 21.25
There is a voltage across an open switch, such as in Figure 21.43. Why, then, is the power dissipated by the open switch small?
A long, inexpensive extension cord is connected from inside the house to a refrigerator outside. The refrigerator doesn't run as it should. What might be the problem?
Calculate the peak voltage of a generator that rotates its 200-turn, 0.100 m diameter coil at 3600 rpm in a 0.800 T field.
Apply the loop rule to loop abcdefghija in Figure 21.52.
Apply the loop rule to loop afedcba in Figure 21.47.
Apply the loop rule to loop akledcba in Figure 21.52.