600 kN A vertical column load, P=600 kN, is applied to a rigid concrete foundation with dimensions B=lm and L=2m, as shown. The foundation rests at a depth Df=0.75m on a uniform dense sand with the following properties: elastic modulus of elasticity, E=20,600 kN/m2, and Poisson's ratio, us=0.3. Estimate the elastic settlement due to the net applied pressure, Ao, on the foundation. Foundation BxL Δσ 0.75 m Soil Hs =0.3 E, = 20, 600 kN/m² 5.0 m Rock

600 kN A vertical column load, P=600 kN, is applied to a rigid concrete foundation with dimensions B=lm and L=2m, as shown. The foundation rests at a depth Df=0.75m on a uniform dense sand with the following properties: elastic modulus of elasticity, E=20,600 kN/m2, and Poisson's ratio, us=0.3. Estimate the elastic settlement due to the net applied pressure, Ao, on the foundation. Foundation BxL Δσ 0.75 m Soil Hs =0.3 E, = 20, 600 kN/m² 5.0 m Rock

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter11: Compressibility Of Soil

Section: Chapter Questions

Problem 11.1P

See similar textbooks

Similar questions

Consider a continuous foundation of width B = 1.4 m on a sand deposit with c = 0, = 38, and = 17.5 kN/m3. The foundation is subjected to an eccentrically inclined load (see Figure 6.33). Given: load eccentricity e = 0.15 m, Df = 1 m, and load inclination = 18. Estimate the failure load Qu(ei) per unit length of the foundation a. for a partially compensated type of loading [Eq. (6.89)] b. for a reinforced type of loading [Eq. (6.90)]
Solve Problem 7.8 using Eq. (7.29). Ignore the post-construction settlement. 7.8 Solve Problem 7.4 with Eq. (7.20). Ignore the correction factor for creep. For the unit weight of soil, use γ = 115 lb/ft3. 7.4 Figure 7.3 shows a foundation of 10 ft × 6.25 ft resting on a sand deposit. The net load per unit area at the level of the foundation, qo, is 3000 lb/ft2. For the sand, μs = 0.3, Es = 3200 lb/in.2, Df = 2.5 ft, and H = 32 ft. Assume that the foundation is rigid and determine the elastic settlement the foundation would undergo. Use Eqs. (7.4) and (7.12).
A 6 m. x 9 m. rectangular foundation carrying a uniform load of 288 kPa is applied to the ground surface. Compute the total vertical stress in kPa due to this uniform load at a depth of 6 m. below the center of the loaded area if unit weight of soil is 18,30 kN/m.
(b) Figure Q2 (b) shows the ring foundation to support a silo. Given R1 = 3 m while R2 =6 m. The total vertical load is 7500 kN. (i) Calculate and plot the vertical stress increase with depth up to 7 m (use 1 minterval) under the centre of the ring (point O).(ii) Determine the maximum vertical stress increase and its location.
Consider a continuous foundation of width B = 1.4 m on a sand deposit with c' = 0, Φ' = 38° and γ = 17.5 kN/m3. The foundation is subjected to an eccentrically inclined load (see Figure 4.31). Given: load eccentricity e = 0.15 m, Df = 1 m, and load inclination β = 18°. Estimate the failure load Qu(ei) per unit length of the foundation a. for a partially compensated type of loading [Eq. (4.85)] b. for a reinforced type of loading [Eq. (4.86)]
A square footing foundation, 3 m by 3 m, and positioned on the ground surface of a soil deposit, supports a column load of 1,350 kN. Determine the vertical stress resulting from the foundation loading at a depth 3 m below the base of the footing for locations beneath the center and beneath the edge, assuming:(a) Boussinesq conditions apply.(b) Westergaard conditions apply.
A mat foundation, 15 m x 15 m, is made of reinforced concrete and to be supported by a three-layer soil profile, as shown. The mat is 1 m thick, and the average stress on the surface of the slab assessed from the structural engineering analysis is 75 kPa. (Unit weight of concrete = 23.58 kN/m^3) The 5-m thick sand layer immediately below the mat foundation has been compacted to standard Proctor specifications, most likely to optimum moisture content, which is why its moist density is given. (A) Determine the pre-construction effective stress at Point A (bottom of the clay layer). This is the in situ effective stress (overburden pressure) measured from the ground surface prior to the placement of the mat foundation. (B) Determine the vertical stress increase induced by the mat foundation at Point A using the “Influence Chart,” commonly referred to as the “Spider Web.” (C) Determine the vertical stress increase induced by the mat foundation at Point A using the “Stress Isobars.” (D)…
A rectangular footing (4.14 x 4.43 m) is placed 1.38 m below the ground surface. The soil arrangement is composed of sand (ground) for the first 6.29 m and followed by clay for the next 5.94 m. The force acting on the footing is 10581 kN. Determine the resulting stress increase at the midheight of the consolidating layer in kPa. Assume 2V:1H pressure diagram. Unit weight of sand = 16.8 kn/m3. Unit weight of clay = 18.4 kn/m3
a 6m square foundation exerts a uniform pressure of 300kPa on a soil.Determine a.vertical stress increments due to the foundation load to a depth of 10m below its center
A square foundation of (5m x 5m) is to carry a load of 4000KN.calculate the vertical stress at a depth of 5m below the center of the foundation. IN=0.084 for m=n=0.50 Also, determine the vertical stress using the 1:2 distribution method.
A flexible foundation is 2 m x 4 m rests on granular soil at ground level. It carries a uniformly distributed load of 160 kN/m2. The sand has an elastic modulus of 39 MPa , a Poisson's Ratio of 0.3 and is 5 m thick. Estimate the elastic settlement below the center of the loaded foundation. Give your answer in cm rounded to 2 decimal places.
A 300-kN loading is supported on a 1.5 m by 1.5 m square foundation constructed on the ground surface of a homogeneous soil deposit (soil unit weight is 19 kN/m3). Determine the values of the preconstruction and the postconstruction vertical stress imposed on the soil at a point 2 m below the center of the foundation area (assume the Westergaard conditions apply).