A rectangular foundation 4 m x 6 m (Figure 1) transmits a stress of 100 kPa on the surface of a soil deposit. Plot the distribution of increases of vertical stresses with depth under points A, B, and C up to a depth of 20 m. At what depth is the increase in vertical stress below A less than 10% of the surface stress?

A rectangular foundation 4 m x 6 m (Figure 1) transmits a stress of 100 kPa on the surface of a soil deposit. Plot the distribution of increases of vertical stresses with depth under points A, B, and C up to a depth of 20 m. At what depth is the increase in vertical stress below A less than 10% of the surface stress?

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Vertical Stress Increase In Soil

Section: Chapter Questions

Problem 8.11P

See similar textbooks

Similar questions

Problem 1. A rectangular foundation 4m x 6m transmits a stress of 100 kPa on the surface of a soil deposit. Plot the distribution of increases of vertical stresses with depth under points A, B, and C up to a depth of 20m. At what depth is the increase in vertical stress below A less than 10% of the surface stress?
a 6m square foundation exerts a uniform pressure of 300kPa on a soil.Determine a.vertical stress increments due to the foundation load to a depth of 10m below its center
The soil stress state is shown in the figure, σx = 10 kN/m2, σy = 50 kN/m2, τxy = -10 kN/m2:(1) Please use Mohr circle to draw the soil stress state(2) Calculate the maximum principal stress σ1 and the minimum principal stress σ3(3) Please find the (pole) position(4) What is the angle of intersection between the maximum principal stress surface and the horizontal plane?
The soil stress state is shown in the figure, σx = 10 kN/m2, σy = 50 kN/m2, τxy = -10 kN/m2 What is the angle of intersection between the maximum principal stress surface and the horizontal plane?
Determine the increase in vertical stress at a depth of 5 m below the centroid of the foundation shown in Figure 2.
A circular footing 3 m in diameter applies a uniform surface pressure of 150 kPa. Determine the vertical stress increase beneath the center at 2 m deep from the ground level.
Q. 12 A soil profile at a certain location is as shown in figure. A rigid circular foundation of 4 m diameter rests on the sand. The contact pressure at the underside of the foundation is 230 kN/m?. The average coefficient of compressibility of the clay is 0.65 × 10-3 m2/kN for the stress range encountered. The ultimate settlement of the foundation assuming 45° load distribution
In Problem 16.3, if there was a surcharge of 20 kN/m2 at the ground level, what would be the total horizontal normal stresses at A and B? Use the results from Problem 16.3. 16.3 The soil profile at a site is shown Figure P16.3. Find the total horizontal normal stresses at A and B, assuming at-rest conditions.
Redo Problem 6.12 using Figure 6.15. 6.12 Refer to Problem 6.1. Using Eqs. (6.3) and (6.29), estimate the average stress increase (av) below the center of the loaded area between depths of 3 m and 6 m. 6.1 A flexible circular area is subjected to a uniformly distributed load of 150 kN/m2 (Figure 6.2). The diameter of the load area is 2 m. Determine the stress increase in a soil mass at points located 3 m below the loaded area at r = 0, 0.4 m, 0.8 m, and 1 m. Use Boussinesqs solution. Figure 6.2 Increase in pressure under a uniformly loaded flexible circular area
Solve Problem 7.8 using Eq. (7.29). Ignore the post-construction settlement. 7.8 Solve Problem 7.4 with Eq. (7.20). Ignore the correction factor for creep. For the unit weight of soil, use γ = 115 lb/ft3. 7.4 Figure 7.3 shows a foundation of 10 ft × 6.25 ft resting on a sand deposit. The net load per unit area at the level of the foundation, qo, is 3000 lb/ft2. For the sand, μs = 0.3, Es = 3200 lb/in.2, Df = 2.5 ft, and H = 32 ft. Assume that the foundation is rigid and determine the elastic settlement the foundation would undergo. Use Eqs. (7.4) and (7.12).
Refer to Problem 6.1. Using Eqs. (6.3) and (6.29), estimate the average stress increase (Δσav) below the center of the loaded area between depths of 3 m and 6 m. 6.1 A flexible circular area is subjected to a uniformly distributed load of 150kN/m2 (Figure 6.2). The diameter of the load area is 2 m. Determine the stress increase in a soil mass at points located 3 m below the loaded area at r = 0. 0.4 m, 0.8 m, and 1 m. Use Boussinesq’s solution. Figure 6.2 Increase in pressure under a uniformly loaded flexible circular area
In the figure, the rectangular foundation is loaded with a uniform load of 225 kPa. Accordingly, calculate the vertical stress increase 10 m below point A.