Answered: 600g of ice at -8℃ is put inside a…

600g of ice at -8℃ is put inside a calorimeter filled with 4000g water initially at 20 ℃. What is the final temperature of the system? c water = 4.186 J/g℃ c of ice = 2.093 J/g℃ Hf = 334 J/g

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter10: Thermal Physics

Section: Chapter Questions

Problem 2P: The pressure in a constant-volume gas thermometer is 0.700 atm at 1.00 102C and 0.512 atm at 0C....

See similar textbooks

Related questions

Q: 1. John is riding the Ekstreme Tower at Enchanted Kingdom. If John free falls for 2.6 seconds, what…

A: Given:- The time for john's free fall is t = 2.6 sec Find:- What will be the final velocity? How…

Q: When 20 N of force is applied to a spring of natural length 2 m, the resulting compression is 0.5 m.…

A: Given in question - Force(F) = 20N Natural length(L) = 2 m…

Q: A cylindrical container that is open at the top holds a fluid of density 900 kg/m3. At the bottom of…

Q: Problem 2 Civil Engineering students requires them to monitor the traffc safety at a busy…

A: Velocity VA=55mph Velocity VB=70mph Angle=60degree

Q: The voltage in circuit is 24 V and resistance is 5 ohms, find the current ?

A: Ohm's law, description of the relationship between current, voltage, and resistance. The amount of…

Q: Resistors of 20 Q, 20 Q and 30 Q are connected in parallel. What resistance must be added in series…

A: According to question we need to find--- Resistance, which connect in series? current?

Q: ____17. When an atom is a gamma ray emitter, the atom releases: ________________. ____18. The time…

A: 17. Gamma is form of electromagnetic radiation. Gamma ray is electromagnetic ray of shortest…

Q: The Thermistor advantages .A Very sensitivity .B Small mass

Q: A mass that can oscillate without friction on a horizontal surface is attached to a horizontal…

Q: Explain how the emission spectrum provides information about the composition and properties of an…

Q: Two point charges of values +3.4 and +6.6 mC, respectively, are separated by 0.20 m. What is the…

A: Potential energy is given by the formula, U = ke *q1 *q2 /r Given, q1 = +3.4 mC q2 = +6.6 mC r =…

Q: Which of the following is a successful strategy for minimizing the acceleration that you would…

Q: The rate of heat conduction out of a glass window on a winter day is rapid enough to chill the air…

A: Area of the glass window, A=4.43 m2 The thickness of the glass window, d=0.95 cm The temperature of…

Q: 4. The value of the line integral of the B field around the closed path in the figure is 5.030 x 106…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: An electric car starts from rest and accelerates for 20s at a rate of 2.0 m/s? along a straight…

Q: integoates <6 9i] A doop R= 10 m disin tegoat@es of of Jadius oithe stal deep the change Sanme in to…

Q: A rifle bullet with mass m is fired horizontally with speed v0 when it hits a wooden block of mass…

A: the kinetic energy of an object is the energy that it possesses due to its motion. It is defined as…

Q: 1. Half of the volume of an object that weighs 100 N is submerged in water when allowed to float…

Q: 3. An electron is found at rest in between a set of parallel plates with a potential difference of…

A: We need to explain the motion of the electron in the electric field between the plates and then it’s…

Q: Explain how magnetic fields exert force on moving electric charges. Answer in 5 to 6 sentences.

A: When a charged particle moves in a magnetic field, then a force act on it which is called Lorentz…

Q: kindly answer this immediately thankyou -An automobile has a speed of 60 mi/h. When the brakes are…

A: An automobile has a speed of 60 mi/h. When the brakes are applied, it slows to 15 mi/h in 4 second.…

Q: E30 A ship of mass m and speed v strikes a stationary iceberg of mass 10 m. Find the resull- ing…

A: Mass of the ship = m Mass of the iceberg = 10m The velocity of the ship before collision = v…

Q: An object is 15cm from a converging lens of focal length 10cm. A diverging lens with focal length…

Q: Coastal and Barbour structures A wave train is observed approaching a coast that has straight…

A: Given, Distance=5m Wavelength=93

Q: For the situation shown in Figure calculate FL , the magnitude of the force exerted by the left…

A: According to our guideline ,we have to do the first question only. please upload other question…

Q: Part A Two 7.0 cm X 7.0 cm metal electrodes are spaced 1.0 mm apart and connected by wires to the…

Q: The apparent depth of an object submerged in water or other transparent liquid is A. closer to the…

A: Given in question - The apparent depth of an object submerged in water or other transparent liquid…

Q: A paraglider started to descent in his wingsuit. Knowing that air resistance will be significant to…

A: 10) The acceleration remains constant and the velocity decreases due to air resistance, hence the…

Q: If a car travelling at 34 m/s is subjected to a steady deceleration of 4 m/s?, how long will it take…

Q: 01 = 26°, 82 = 37', T1 = 89.2 N, g=9.80 m/s2, m = ? kg, Enter your answer using 3 significant…

A: Given,

Q: g. Fill in the missing data A group of food technologist used a single-cylinder rotational…

A: Radius=1cm=1×10^-2m Length=6cm=6×10^-2m

Q: Put a pan of water on a weighing scale and read the weight. Dip a piece of iron in the water taking…

Q: One hundred grams of aluminum at 100° C is mixed with 100 g of water at 10 ° C. What is the final…

Q: Why 2200 m/s was changed to 22 W ? Can't we solve with using the 2200 m/s?

Q: n a SIMPLE Rankine cycle, the steam throttled condition is 8 MPa and 480°C. The steam is then…

Q: 6. A train approaching a crossing sounds its horn with a frequency of 750 Hz. An observer standing…

A: Given: The frequency of the train's (the source's) horn: fs = 750 Hz. The frequency of the whistle…

Q: A 50 kg student bounces up from a trampoline with a speed of 3.4 m/s. Determine the work done on the…

A: Given: The mass of the student is 50 kg. The speed of the student is 3.4 m/s. The height of the…

Q: A 20-mF capacitor is attached across a 1000-V power supply. What is the net charge on the capacitor?…

Q: Eartha and Astro are twins. Eartha stays in Earth while Astro rides on a spacecraft. Astro returned…

A: You have posted multiple questions, according to company policy, we will answer the 1st question…

Q: 3. A crate of mass 10 kg is pulled up a rough incline with an initial speed of 1.5 m/s. The pulling…

Q: 4-26 Determine tensionT for pulley system. Show FBD. I Fy= 0 5T= 200 T= 40/b 2001b

A: Given: The weight of the object is 200 lb. The free-body diagram is given below.

Q: To what potential should you charge a 1.0 F capacitor to store 1.0 J of energy?

Q: 8. In a bypass engine, the bypass air: Increases the air mass flow and therefore reduces the…

A: We have to write about bypass engine

Q: A body is projected at an angle of 30° to the horizontal with kinetic energy 40 J. What will be the…

Q: The voltage in circuit is 24 V and resistance is 5 ohms, find the current ?

A: voltage in circuit (V) = 24 volts resistance (R) = 5 ohm

Q: Which of the following statements best describes Oersted’s Principle? a. A current-carrying…

A: Oersted’s Principle : It state that When the steady state current is passes through a wire it create…

Q: A current, i(t) = 50 cos(100nt) enters the input terminal of an electric device. What is the charge…

A: Given Current is given as i=50cos100πt We have to find the charge at t=5 ms=5×10-3 s

Q: Find the electrical potential at 0.15 m from a point charge of 6.0 mC. (ke = 9.00 ´ 109 N×m2/C2).…

Q: 14 ohms takes a current of A .find the heat developed in 20 seconds.

A: We know , Heat (H)=i2Rt----------------(1) ANS: Heat developed in 20 sec is 280 Joule.

Q: A diver comes off a board with arms straight up and legs straight down, giving her a moment of…

A: Given data: Initial moment of inertia I1 = 18 kg.m2 Final moment of inertia I2 = 3.6 kg.m2 Time…

Question

600g of ice at -8℃ is put inside a calorimeter filled with 4000g water initially at 20 ℃. What
is the final temperature of the system?

c water = 4.186 J/g℃
c of ice = 2.093 J/g℃
Hf = 334 J/g

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A hollow aluminum cylinder 20.0 cm deep has an internal capacity of 2.000 L at 20.0C. It is completely filled with turpentine at 20.0C. The turpentine and the aluminum cylinder are then slowly warmed together to 80.0C. (a) How much turpentine overflows? (b) What is the volume of the turpentine remaining in the cylinder at 80.0C? (c) If the combination with this amount of turpentine is then cooled back to 20.0C, how far below the cylinders rim does the turpentines surface recede?
A hollow aluminum cylinder 20.0 cm deep has an internal capacity of 2.000 L at 20.0C. It is completely filled with turpentine at 20.0C. The turpentine and the aluminum cylinder are then slowly warmed together to 80.0C. (a) How much turpentine overflows? (b) What is the volume of the turpentine remaining in the cylinder at 80.0C? (c) If the combination with this amount of turpentine is then cooled back to 20.0C, how far below the cylinders rim does the turpentines surface recede?
One way to cool a gas is to let it expand. When a certain gas under a pressure of 5.00 106 Ha at 25.0C is allowed to expand to 3.00 times its original volume, its final pressure is 1.07 106 Pa. (a) What is the initial temperature of the gas in Kelvin? (b) What is the final temperature of the system? (See Section 10.4.)
A 1.00-mol sample of hydrogen gas is heated at constant pressure from 300 K to 420 K. Calculate (a) the energy transferred to the gas by heat, (b) the increase in its internal energy, and (c) the work done on the gas.
Suppose 26.0 g of neon gas are stored in a tank at a temperature of 152C. (a) What is the temperature of the gas on the Kelvin scale? (See Section 10.2.) (b) How many moles of gas are in the tank? (See Section 10.4.) (c) What is the internal energy of the gas? (See Section 10.5.)
In an insulated vessel, 250 g of ice at 0C is added to 600 g of water at 18.0C. (a) What is the final temperature of the system? (b) How much ice remains when the system reaches equilibrium?
A cubic container of volume 2.00 L holds 0.500 mol of nitrogen gas at a temperature of 25.0 . What is the net force due to the nitrogen on one wall of the container? Compare that force to the sample's weight.
If water with a mass mk at temperature Tk is poured into an aluminum cup of mass mA1 containing mass mc of water at Tc, where Tk Tc, what is the equilibrium temperature of the system?
A bar of gold (Au) is in thermal contact with a bar of silver (Ag) of the same length and area (Fig. P20.55). One end of the compound bar is maintained at 80.0C, and the opposite end is at 30.0C. When the energy transfer reaches steady state, what is the temperature at the junction?
The pressure in a constant-volume gas thermometer is 0.700 atm at 1.00 102C and 0.512 atm at 0C. (a) What is the temperature when the pressure is 0.040 0 atm? (b) What is the pressure at 450C?
Equal 0.400-kg masses of lead and tin at 60.0C are placed in 1.00 kg of water at 20.0C. (a) What is the equilibrium temperature of the system? (b) If an alloy is half lead and half tin by mass, what specific heat would you anticipate for the alloy? (c) How many atoms of tin NSn, are in 0.400 kg of tin, and how many atoms of lead NPb are in 0.400 kg of lead? (d) Divide the number NSn of tin atoms by the number NPb of lead atoms and compare this ratio with the specific heat of tin divided by the specific beat of lead. What conclusion can be drawn?
(a) Use the ideal gas equation to estimate the temperature at which 1.00 kg of steam (molar mass M=18.0 g/mol) at a pressure of 1.50106 Pa occupies a volume of 0.220 m3. (b) The van der Waals constants for water are a=0.5537 Pa m6/mol2 and b=3.049105 m3/mol. Use the Van der Waals equation of state to estimate the temperature under the same conditions. (c) The actual temperature is 779 K. Which estimate is better? `