7. A 480 V, 50 kW, delta-connected three phase, 60 Hz, six pole induction motor operates at a slip of 1.5% and has a power factor of 82% and an efficiency of 88%. Determine the actual rotor sneed 1818 rpm 1200 гpm 1182 rpm 1156 rpm

7. A 480 V, 50 kW, delta-connected three phase, 60 Hz, six pole induction motor operates at a slip of 1.5% and has a power factor of 82% and an efficiency of 88%. Determine the actual rotor sneed 1818 rpm 1200 гpm 1182 rpm 1156 rpm

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter32: Three-phase Motors

Section: Chapter Questions

Problem 13RQ: A squirrel-cage induction motor is operating at 1175 RPM and producing a torque of 22 Ib-ft. What is...

See similar textbooks

Related questions

Q: Calculate the time constants for both RC and RL circuit using the nominal values for R, C, and L.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A full-wave bridge rectifier with a 120-V rms sinusoidal input has a load resistor of 1 k_. (a) If…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Derive the time response v,(t) for the circuit given in Figure Q3. Where, v(t) is a step signal. Q3

Q: Design the circuit of the figure operates in saturation with VDD,F +8V, ID = 0.5 mA, VD = 6V. Let…

A: We need to find out unknown resistance value for given circuit

Q: Actuator / Valve Packaging Figure Q2

Q: Which substrate does an p-channel made device possess? O a. None of options Ob. Both P & N-type O c.…

Q: 13.15 Find the Norton equivalent for the circuit in Fig. 13.84 at terminals a-b. 20 Ω j20 2 o a j5 2…

A: In this question, We need to determine the Norton equivalent for the given circuit across the…

Q: - Determine an alternative method for implement the full-adder. Hint: Write the expressions of the…

A: We need to design Full adder circuit .

Q: Find the resistance of a circular wire that is 0.5-m long with radius of 1mm and has a resistivity…

Q: Assuming an ideal diode, sketch V¡ , Va and ig for the half-wave rectifier below. The input is…

Q: Given Vi=20V peak-to-peak, draw the output wav eform for the said clamper circuit below: Vi Vo 5V…

A: The clamper circuit is shown below: The above clamper circuit is a positively biased clamper…

Q: Determine the current flowing across 1-N resistor using Source Transformation Method and the…

Q: 4. The simplest way to reverse the rotation direction of a three phase AC motor is Use stator CEMF…

A: In this question we will write about the simplest way to reverse the rotation direction of three…

Q: 1.Consider Find the finite discrete convolution for x[n] = δ[n] - 3δ [n - 8 ] , h[n] = δ[n+1] +…

A: The solution is given below

Q: If a 0.5H inductance rated 110v is to be operated at a source of 230v. At what value of resistance…

A: It is given that: L=0.5HVL=110VVs=230 VAssuming,f=50 Hz

Q: Determine the energy per bit-to-noise density ratio when the receiver input carrier power is 100…

Q: Determine the volume charge density

A: Electric field lines are zero inside the perfect conductor. And permittivity of medium…

Q: Problem 02: For the following series-parallel network, the supply voltage E = 300VZ60° as shown in…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: For the circuit below, solve for the current at 4-N resistor using Superposition Theorem -www- lo V

A: We have to find the current across 4ohm resistor using superposition

Q: Derive the truth table, simplified equation, and logical diagram 1. Design a 4-bit majority…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: A Da D

A: NOR Gate: A NOR gate (short for "not OR gate") is a logic gate that only generates a high output (1)…

Q: Example 26.17. A 4-pole, lap-wound, d.c. shunt generator has a useful flux per pole of 0.07 Wb. The…

Q: Starting with the initial values (1, 1, 1), solve the following system of equations by the…

A: Given the system of equations x12-x22+x32=11x1x2+x22-3x3=3x1-x1x3+x2x3=6

Q: D2 2K he circuit shown, determine the voltage across resistor R2. your answer 1.5V he circuit shown,…

Q: (a) Figure Q2(a) shows a clipper circuit made with an ideal diode. Vi(t) ovf R 10 V - T/2 Vi(t)…

Q: Derive three equations for electric power in terms of electric voltage, electric current and…

A: Solve the problem

Q: 1. The magnitude of the resultant flux in three phase supply system is equal to (a) Pm (b)m (d) Фт…

Q: F(X,Y,Z,W)=X + X.Y.Z + X.Y.ZW + X.Y.ZW where m= m(X,Y,Z) "Compressed around W"

A: The solution is given below

Q: write ALP to transfer the contents of Memory location addressed by 250o which equal 17 to regater A…

A: To transfer the contents of memory location addressed by 2500 which is equal to 17 to register A…

Q: Question 3 The 555 timer is connected in the following circuit. The resistance of the extra resistor…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: 15 V + 25 V 10 V + + V2 20 V V3

Q: 20 R2 D1 1.5V In the circuit shown, determine the current flowing through the resistor R1. *

Q: Find the Q-point values for the JFET with voltage-divider bias. IDss = 5 mA Vpp +12 V Rp 1.8 kN 3.3…

Q: Also compure m- or -T 122 らtに 20 cos(at+30 3/4 F The circuit is in the delivered to R Determine R…

Q: 3. What generates the rotating magnetic field on the stator?

A: The rotating magnetic field on the stator us produced by:

Q: K 1. Draw the root locus for the system shown below with G(s) Show all the (s+5)(s+3) steps and…

Q: 1. Given Vi = 20V peak-to-peak, draw the output waveform for the said clamper circuit below: C + +…

Q: A. Phase-to-neutral voltage at source. B. Line-to-line voltage. C. Phase-to-neutral voltage at load.…

Q: Q) Choose (active, saturation or cutoff as the corect unewer for the following n When I0and Ver Ve…

A: We need to tell about region of operation for bjt

Q: Question 6: A program with 20 machine instructions is executed on a 109HZ frequency CPU. The…

A: a) The clock period of the CPU is, t=1ff=109 Hzt=1109t=9.17 ms b) Since, the instruction is…

Q: For an earth station receiver with an equivalent input temperature of 200 K, a noise bandwidth of 20…

Q: Draw the signal

A: In this question we will draw signal.....

Q: 1. What is the advantage of PPM over PWM? 2. Is the synchronization is must between Tx and Rx 3.…

Q: 22 22 10V I1 13 12V + I2 12 I4 62 15 12V 32 32 +

Q: Use the Wye-Delta circuit shown below. Compute for the voltage drop of the line at phase c. What is…

Q: Briefly describe the 5 major types of DC generators according to the manner in which their field…

Q: 3. A full-wave rectified wave is clipped at 70.7% of its maximum value alr shown belour. Aind Is…

Q: Q1/ I Match the linking words or phrases with their synonyms. a but b for instance c in contrast d…

A: finally -lastly (e) firstly -in the first place (d) for example - for instance (b)

Q: Design a sequential circuit with two D flip-flops and two input x and y. When x=0, the state remains…

A: Given, a sequential circuit with two D flip-flops and two input x and y. When x=0, the state remains…

Q: Homework: Determine the output C for the system represented in figure below: R G G2 H. R

Concept explainers

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.

Question

7. A 480 V, 50 kW, delta-connected three phase, 60
Hz, six pole induction motor operates at a slip of
1.5% and has a power factor of 82% and an
efficiency of 88%. Determine the actual rotor
sneed
О 1818 гpm
1200 гpm
1182 rpm
1156 гpm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A squirrel-cage induction motor is operating at 1175 RPM and producing a torque of 22 Ib-ft. What is the horsepower output of the motor?
What are the advantages and disadvantages of using the following types of motors? shaded-pole motor PSC motor split-phase motor capacitor-start–capacitor-run motor
Why are different motor connections shown for what appears to be the same motor in the various diagrams in Figure 332? FIG. 332 Typical arrangements for four-speed, three-phase, two-winding motors.
Name three factors that determine the torque produced by an induction motor.
A 1100 V, 50 Hz, delta connected induction motor has a star connected slip ring rotor with a phase transformation ratio of 3,8. The rotor resistance and standstil leakage reactance are 0,012 ohm/phase and 0,25 ohm/phase respectively. Neglecting the stator impendance and magnetising current determine the rotor current at 4 % slip with slip rings shorted. A. 123 A B. 430,5 A C. 560 A D. 742,3 A
A 3 phase induction motor is wound for 6 poles and is supplied fromn 50-Hz system. Calculate 1) the synchronous speed 2) the rotor speed, when slip is 2% and 3) the frequency of the rotor currents at standstill.
A 3-phase induction motor is wound for 6-pole and is supplied from 50 Hz system calculate (i) the speed of the motor when slip is 6% and (ii) the rotor current frequency the motor runs at 500 r.p.m.
A 3-phase 440V, wye connected induction motor has a star-connected stator and delta connected rotor with a turns ratio of 10. The rotor resistance and standstill reactance per phase are 0.01Ω and 0.2Ω respectively, what will be the rotor voltage per phase at standstill?
3-Phase 50Hz 6 pole induction motor has rotor resistance of 0.1 ohm and reactance of 0.92. ignore voltage drop in stator and assume thee rotor resistance is constant. Full load slip is 3%, then find the value of the maximum torque.
A three phase star connected six -pole induction motor has the following parameters. R1=0.294ohm, R2=0.144ohm, X1=0.503ohm, X2=0.209ohm, Xm= 13.5ohm. The slip of the motor is 2 percent. the stator input impedance of the motor is??
a three phase star connected six pole induction motor has the following parameters R1=0.294 ohm,R2=0.144ohm,X1=0.503ohm,X2=0.209ohm Xm=13.25ohm a slip of the motor is 2%. the stator input impedence of the motor is?
A three phase induction motor with supply frequency of 60 Hz, 8 poles. If the slip is 2.5 % at a certain load, determine (a) the synchronous speed, (b) the speed of the rotor (c) the frequency of the induced e.m.f in he rotor and (d) speed of the induction motor if the slip changes to 6 %