Q: A 33 KV substation is to be connected to a 11 KV stepdown substation which is at a distance of 1.5…

A: We have Transmission line which connects 33 KV Sub-Station to 11 KV Substation. This line is 1.5 KM…

Q: 1. A standard TTL gate performs what logic function for positive logic? 2. If all inputs of a TTL…

A: TTL GATE:  TTL(Transistor- Transistor logic), is mainly built up from a Bipolar junction transistor…

Q: Given the next circuit 8 A 2A 9 V 3 V 6 V

A: Given circuit diagram,       I=?

Q: For JFET, if Ipss = 15 mA. VGS (off)= - 7 V, and gm. = 4 mS or mA/V. Determine the transconductance…

A: We have an JFET with, IDSS = 15 mA = 15 * 10-3 A VGS (off) = -7 V gmo = 4 mS = 4 *10-3 S VGS = - 4 V…

Q: Problems/e. Find the transfer function for ((S)/2(5) for the following control systems by using…

A: Given block diagram:- Here, G1, G2,G3 &G4 are forward path loop gain, H1 & H2 are feedback…

Q: The total power in an Amplitude Modulated signal if the carrier of an AM transmitter is 800 W and it…

A: Given information: The carrier power of the AM signal is given as Pc=800 W. The depth of modulation…

Q: When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the…

A: Given: Current while transmitting an unmodulated carrier I0=10 A Current while transmitting…

Q: In a series RLC circuit, the applied voltage is 108V. At resonance, the frequency is 200rad/sec, and…

A: Given data, Series RLC resonance circuit, Applied voltage V =108 V Angular frequency ω=200 rad/s…

Q: A three phase power transformer having a line voltage ratio of 400 V to 33 kV is connected in…

A: We have an three-phase power transformer as shown in figure, Voltage ratio = 400 V / 33 KV Current…

Q: A 240 V, 50Hz single phase supply feeds a SP-FC-FWR. The rectifier is used to power the armature of…

A:

Q: Estimate the maximum transmission efficiency of a double. sideband suppressed carrier amplitude…

A: In this case, the maximum transmission efficiency of a double sideband suppressed carrier AM signal…

Q: Figure (b) R₁, R₂, and R3 in parallel R₁ www R₂ Ỉ R3 www b 2 of 4 T You have three resistors, R₁ =…

A: Given circuit: The given values are R1=7.00 ΩR2=8.00 ΩR3=9.00 ΩVab=12.0 V

Q: Problem: For the given circuit as shown in figure a) Find the equivalent reactance b) Draw the…

A: Solution !!

Q: A circular disk of radius a [m] is uniformly charged with ps [c/m²]. If the disk lies on the z = 0…

A: Given,Radius of the disk =rmUniform charge = ρs c/m2The disk lies on z=0 plane.

Q: Find the voltage Vo in the circuit. 492 12 V +1 Μ 8 Ω www 8 Ω ΑΝ + Vo

A: Given circuit,

Q: SW 4 SW 2 SW 3 SW 1 B D . 74LS00 1 2 4 5 9 10 12 13 6 900 1/2-74LS(20) 1 5 2 4 6 F= L1 Apply the…

A: The given logic diagram is shown below:

Q: - The figure below shows the structure of which busbar? If CBF has occurred, please explain how many…

A:

Q: The distribution factor for a 36-slots, 4-pole, single layer, 3-phase winding machine is given as:…

A: Given, A 3-phase machine with, Total pole, P = 4 Total slots = 36

Q: 5. Use Karnough maps to find minimal forms for the expressions ry'z + ry'z' + r'y' z' + x'y'z.

A: Given Boolean expression, f=xy'z+xy'z'+x'y'z'+x'y'z

Q: 3) For the region of the diode curve greater than the diode's barrier potential, (a) the curve is…

A:

Q: 10. A 3-phase overhead transmission line is supported on 4-disc suspension insulators. The voltage…

A:

Q: 3. Find the current value, V₁, V₂, and Vo. Vin = 10 V R₁ = 4.7 kQ I www A M - 5 V V₂ R2= 2.2 ΚΩ

A: Given:

Q: Example: Verify the Tellegen's theorem for the given circuit.? 10 ve V 12A 10 2

A: Tellegen's theorem: Tellegen's theorem states that the algebraic sum of all the power in a circuit…

Q: Kr=0.31+jo.31 and Zo=50 using the law below find the Value of Zr Zr-2- Kr= Zr + Zo

A: We need to find out value of Zr for given expression

Q: For a FM signal v(t) = 20 cos ( 10 * 108t + 30 sin 3000t), calculate the power dissipated by the FM…

A:

Q: A resistance strain gauge with a gauge factor of 2.0 is fastened to a steel member subjected to a…

A: Given, A resistance strain gauge with gauge factor, GF=2 Stress = 100 Nmm2 The modulus of elasticity…

Q: An unmodulated AM signal produces a current of 5.4 A. If the modulation is 100 percent, calculate:…

A: Given information: The current corresponding to the unmodulated AM signal is 5.4 A and the depth of…

Q: x(t) = e 2¹u(t) + e¯³¹u(t)

A: The expression of the given function is  xt=e-2tut+e-3tut The Laplace transform of the given…

Q: Find the Laplace transform X(s) signals x (t): (a)_x(t) = e¯2²¹u(t) + e¯³¹u(t)

A:

Q: Q2. a) Explain why the static electric field is always zero inside an isolated conductor. What is…

A: Given  Distance D=1.5 mm Electric potential 4.5 V. Electrical charge taken from b part +17 pC Find:…

Q: Problem: Determine the equivalent capacitance between AB in the given circuit. 5.0μF 6.0μF 24uF…

A: We need to find equivalent capacitance for given circuit

Q: Analyse the logic circuit of Fig. 11.2 and show that it can be replaced by a single NAND gate. Ao Bo…

A: Given: A logic circuit diagram having output as f=AB¯+A¯+B¯ we have to show that the given circuit…

Q: A CRO measurement has 2.3 divisions measured for peak-to-peak amplitude of a signal; what is the rms…

A: We got an CRO measurement as, No. of division for peak to peak signal = 2.3 Volts/div = 5   We need…

Q: AC AD BC D с B D F D D Write the output expression the circuit shown

A:

Q: A three phase 250 hp induction motor operates at 0.8 lagging power factor on 440 V, 50 Hz supply.…

A: We have been given induction motor with, HP = 250 Hp Power factor (Cosϕ1) = 0.8 lagging Supply…

Q: For an op-amp, CMRR = 10³ and differential gain A = 10³. Determine the common mode Acm gain of the…

A:

Q: A 0 0 1 1 A B B 0 1 0 1 NOR C C 1 0 0 0 Using negative logic, convert the data in Table into 1's and…

A:

Q: 200Vp 1MHz L5 L6 C5 R5 100

A:

Q: 1) Compute the Fourier Transform of each of the following signal: a) [e-at cos wot]u(t), a > 0 b)…

A: Given:  a e-atcosω0tut,α>0be-3tsin2tcxt=1+cosπt,t≤10,                t>1

Q: Q-2 Analyze the circuit. V-18 V 'R, – 18 ΚΩ R = 10 ΚΩ | R = 2 ΚΩ

A: Given circuit,

Q: A single phase two wire a.c. Find the percentage saving in feeder copper if the system voltage is…

A:

Q: If xy = 0 then x e y is equal to: x+y билни x+y xy xy

A: Given, Boolean expression, xy=0 Then, x⊕y=?

Q: Estimate the maximum transmission efficiency of a double sideband suppressed carrier amplitude…

A: In this case, the maximum transmission efficiency of a double sideband suppressed carrier amplitude…

Q: H.W. 3: A sphere of radius b [m] carries a volume charge density of Pv [C/m³]. Inside this sphere…

A:

Q: For a FM signal v(t) = 20 cos ( 10 * 108t + 30 sin 3000t), calculate the power dissipated by the FM…

A:

Q: 3) Determine the total current I in the given circuit. 20 Q mn wwww 10 12. 15 V 250 www 2.50 10 Q2…

A: Below find the answer !!

Q: A process is producing a particular product. The recorded product output length are as follows. - А…

A:

Q: A 4 pole, 230 volt, lap wound d.c.  motor has 545 conductors. With a speed of 1200 RPM, the flux per…

A:

Q: Analyse the logic circuit of Fig. 11.2 and show that it can be replaced by a single NAND gate. Ao Bo…

A:

Q: (1)nıç_a + (1)niz-a = (1)x (1)

A: The expression of the given function is xt=e-2tut+e-3tut The Laplace transform of the given function…

Latches and Flip Flop

Just like logic gates, the latches and flip-flops are the important elements of an electronic circuit. The logic gates form the important part of combinatorial circuits, while the latches and flip-flops form the essential part of a sequential circuit. Sequential circuits form the important concept of automata theory in electronics and electrical engineering, these circuits are a kind of logic circuit whose output depends on both present input and past inputs, that is, the input history.