Please show all work and report answers to three signficant digits. 7. Determine the phasor secondary current in the transformer circuit below.1: 251020° VZ, 900- j700 S2

Answered: Image /qna-images/answer/3ac563a4-0966-4b94-96ae-6a4e01f87349.jpg

Answered: 7. Determine the phasor secondary…

Engineering

Electrical Engineering

7. Determine the phasor secondary current in the transformer circuit below. 1:25 1020° V ž, 900- j7002

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 7RQ

See similar textbooks

Related questions

Q: A 50 KVA transformer has 400 turns on the primary and 50 turns on the secondary winding. The primary…

A: Given: Rating = 50kVA Primary turns, N1=400 Secondary turns, N2=50 turns Primary induced voltage =…

Q: 150 kVA, 2800-240 V, 50 Hz transformer. Reg.Ls = 0.0082N , Xeq,Ls = 0.0223N Step down transformer…

Q: TWO transformers A and B are connected in parallel to a load of (2+j1.5) ohm. Their impedances in…

Q: 23. The secondary windings of a 60 Hz transformer has 50 tums. If the induced voltage of this…

Q: 502 j1002 25N 400Ω 1:4 2:1 50Ω j100 120V -j1002 1002 u u u m

A: According to the question we have to calculate the value of effective impedance as seen by the…

Q: The primary side referred equivalent impedance of a 440/110 V, 50 KVA single phase transformer is…

Q: 1- A single-phase power system is shown in Figure below. The power source feeds a 100- kVA 14/2.4-kV…

A: Given single phase power system shown Transformer is100 KVA 14/2.4-kvThe load on the transformer…

Q: The voltage on the secondary of a single phase transformer is 200 V when supplying a load of 8 kW at…

Q: Draw a connection diagram for the three-phase transformer in vector group Dy11.

A: 3 phase transformer : In a three phase transformer there are a set three primary winding and…

Q: In a single phase transformer, if the average value of emf is 231 V, then RMS value is_ 256.41…

A: We need to find RMS value for given average value.

Q: A 205 V/ 129 V single-phase transformer has a core loss of 124 W and the no-load current is O0.8 A.…

A: In the question, given a single phase transformer 205/129V Core loss Po= 124W Current at no load =…

Q: In a step down transformer, number of turns in the primary winding is lesser than the number of…

Q: In case of a Balanced load, the impedance values in all three phases should be same in magnitude and…

Q: 150 kVA, 2800-240 V, 50 Hz transformer. Reqis = 0.0082N , Xeq.Ls = 0.02230 Step down transformer…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: 1. A 50 KVA transformer with impedanc 3% and a power factor of a load is 86.6% primary voltage is…

A: In this question we will find transformer voltage regulation...

Q: The current drawn on no load by a single phase transformer is io = 3 sin (314t - 60°) A, when a…

A: Given value of no - load current and no - load voltage are -

Q: Q/ 400/200 V, single-phase transformer is supplying a load of 50A at a power factor of 0.866…

Q: In a single phase transformer, if the RMS value of emf is 240 V, then the average value is O 138.56…

Q: Excereis 1. Two trans formers A and B to are Connected in parallel load of (2+jl.5)2. Their…

Q: In a single phase transformer, if the RMS value of emf is 225 V, then the average value is. O 389.71…

A: According to the question we have to calculate the value of the Average voltage.

Q: A 230/115 V single phase transformer is supplying a load of 5 A at a power factor of 0.866 lagging.…

Q: A single phase transformer is rat 2,424 V / 206 V. 60 Hz The eau

Q: The turn ratio of a step-down transformer is 30:1 and the series impedance (referred to the primary)…

A: In this question we need to find a phase angle of a load voltage.

Q: onsider a three winding transformer with the following particulars: = 50-40° A. Assume that V₂ is 1=…

A: Solution- THREE WINDING TRANSFORMER Given, Z1=Z2=Z3 = 0.02+j0.08 ohmV2 = 400 VI2 = 60∠-30° AI3…

Q: 025 4- The no- - lood primary current of a certain transformer is 1A at a lagging power factor of…

A: First refere the secondary current to primary side and then add the no load current and referred…

Q: Open-circuit 120.0V 0.290A 8.778W Short-circuit 6.848V 2.017A 13.36W Data at secondary Open-circuit…

A: For better utilization of transformer core and for good efficiency, Important parameters of…

Q: A multitap transformer has 1500 turns on the primary, 100 turns between B and C, 600 turns between A…

Q: A 212 V/ 116 V single-phase transformer has a core loss of 124 W and the no-load current is 0.7 A.…

Q: . The following wye-delta 3p transformer has a 1p winding ratio of 10:1 and X= 10 (reflected to the…

A: The winding ration of 1-phase is,k=10:1k=10andX1=1ΩThe voltage across ab is,vab=13.8kV

Q: se, transformer has star connected primary and Delta connected secondary, the line voltag 200 V…

Q: Explain the followings: 1- Commutetor. 2- Draw a comlete phasor diagram of single phase transformer…

Q: A 40 MVA, 3-winding transformer has its winding rated as follows: Primary (Y) Secondary (Y) Tertiary…

Q: Main source of harmonics in the power system is Static power cinverter Resitive heating loads Power…

A: According to the question we have to discuss, the main source of harmonics in the power system.

Q: (b) For an iron core transformer as shown in Figure 6, calculate the primary current I1, primary…

Q: 150 kVA, 2800-240 V, 50 Hz transformer. Regis = 0.0082N , Xeq.Ls = 0.0223N Step down transformer…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: transformer losses and exciting current are neglected, the transformer series reactance is .06 p.u…

A: Subtransient reaction engine reaction during the first short-circuit cycle. Temporary reaction…

Q: Example 18: A 50 Hz, single phase transformer draws a short circuit current of 35 A at 0.25 pf lag,…

A: Given values are -

Q: A 37.5 kVA transformer has a rated core loss and copper losses of 1. 300 W and 500 W. Determine the…

A: 1. Transformer has Rating (R) = 37.5 KVA Core loss (Lcore) = 300w Copper loss (Lcu) = 500w Power…

Q: In a single phase transformer, if the RMS value of emf is 221 V, then the average value is 199.10 O…

Q: Problem #4: A single phase transformer has primary and secondary impedances of (1.4 + j5.2) and…

A: Transformer is a state device which step up or step down the voltage or current. It is also used for…

Q: In a single phase transformer, if the RMS value of emf is 237 V, then the average value is O 118.50…

A: We will derive average output voltage of the sine wave and using given RMS value we will find…

Q: A 5750 V/ 260 V, 50HZ single-phase transformer

A: Single Phase Transformer A single-phase transformer is a stationary electrical machine that does…

Q: Need it ASAP A transformer has a rated output of 200 kVA at a power factor of 0.6. Determine the…

Q: Transformers (Ver_2) 1. A resistive load of 0.120 is connected across the secondary terminals of a…

Q: A three phase transformer has 900 primary turns and 150 secondary turns. If the supply voltage is…

A: Given, No.of primary turns(Np)= 900 No.of secondary turns(Ns)=150 Primary voltage (Vp)= 3.5 kV The…

Q: Excereis 1. Two transformers A and B to a load off (2+ jh5) Their impedanas in Seandary terms.…

A: TRANSFORMER: The transformer transfers power from one circuit to another circuit without a change…

Q: short transmission line connects a step-up transformer on the source side with a series impedance of…

Q: In a single phase transformer, if the average value of emf is 231 V, then RMS value is O 115.50 O…

A: First we will find out the peak value from given average value,then we will find out the RMS value…

Q: homework: why the Rc is in parallel with Xm for equivalent circuit of transformer 11:01 AM

A: The transformer equivalent circuit is shown below. In the transformer equivalent circuit RC…

Q: 1. A three-phase transformer , has 420 turns on the primary and 36 turns on the secondary winding.…

Question

Please show all work and report answers to three signficant digits.

7. Determine the phasor secondary current in the transformer circuit below.
1: 25
1020° V
Z, 900- j700 S2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Digital Modulation Scheme (Amplitude-Shift Keying [ASK], Phase-Shift Keying [PSK], Frequency-Shift Keying [FSK])

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A source supplies power to the following three loads connected in parallel: (1) a lighting load drawing 10kW. (2) an induction motor drawing 10kVA at 0.90 power factor lagging, and (3) a synchronous motor operating at 10hp,85 effIciency and 0.95 power factor leading (1hp=0.746kW). Determine the real, reactive, and apparent power delivered by the source. Also, draw the source power triangle.
Need it ASAP A transformer has a rated output of 200 kVA at a power factor of 0.6. Determine the rated power output and the corresponding reactive power.
Electrical Apparatus Two transformers A and B are connected in parallel. The respective impedances referred to the secondary are 0.5 +j4 Q and 0.8 +j6 Q. The total load on the transformer is 120 kVA at 0.8 lagging power factor. Calculate the kVA load on transformer B.
The equivalent circuit of a transformer is shown below. Given VLs= 2400 20° and IL= 62.5 L-36.8°. Calculate the value of Vi and li
What is the inductance of the primary (L_1) and secondary coil (L_2) of a step - down transformer if V_secondary = 14VAC, I_secondary = 3A. V_primary = 120VAC, Frequency = 60Hz
In a single phase transformer, if the average value of emf is 231 V, then RMS value is O 115.50 O 256.41 133.37 O 400.10
Q17 Choose correct answer: Delta-Star connection of transformer is best suitable for................... loads. A) Power B) Both lighting and power C) Capacitive D) Lighting
Please answer fast A transformer has a rated output of 400 kVA at a power factor of 0.6. Determine the rated power output and the corresponding reactive power.
.A single phase transformer with a ratio of 6600/600 has a load impedance of (4+ j3) Ω connected across the terminals of low voltage winding. The power delivered to the load is
To improve the load power factor, a Delta-Connected capacitor bank is connected on the low voltage side of the transformer, through A 66/11 kV transformer.The capacitor bank has a rated voltage of 11 KV. Determine the capacitance per phase required to improve the power factor from 0.8 lagging to 0.95 lagging. Power rated (S) =150MVA.
Determine the ratio of the kW output of transformer A to the kW output of transformer B. Both transformer have equal ratings and turns ration. Transformers A and B are connected in parallel to serve a 750-A single phase load at 0.85 pf lagging. The equivalent impedance of the transformers are 2.5 + j3.75 and 2.875 + j6.25 omhs, respectively.
TWO transformers A and B are connected in parallel to a load of (2+j1.5) ohm. Their impedances in secondary terms are Za = (0.15+j0.8) ohm amd Zb = (0.1+j0.6)ohm, thier no load terminal voltage are Ea = 200 (angle 0 degree) and Eb = 210(angle 0 degree). Find the power output and power factor of each transformer