7. (II) A house at the bottom of a hill is fed by a full tank of water 6.0 m deep and connected to the house by a pipe that is 75 m long at an angle of 61° from the horizontal (Fig. 10–49 0). (a) Determine the water gauge pressure at the house. (b) How high could the water shoot if it came vertically out of a broken pipe in front of the house? 6.0 m 75 m 田田 61% 田田田

7. (II) A house at the bottom of a hill is fed by a full tank of water 6.0 m deep and connected to the house by a pipe that is 75 m long at an angle of 61° from the horizontal (Fig. 10–49 0). (a) Determine the water gauge pressure at the house. (b) How high could the water shoot if it came vertically out of a broken pipe in front of the house? 6.0 m 75 m 田田 61% 田田田

Name: 17. (II) A house at the bottom of a hill is fed by a full tank of wat
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: 17. (II) A house at the bottom of a hill is fed by a full tank of water6.0 m deep and connected to the house by a pipe that is 75 mlong at an angle of 61° from the horizontal (Fig. 10–49 0). (a)Determine the water gauge pressure at the house. (b) Ho

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 115AP: A sump pump (used to drain water from be basement of houses built below the water table) is draining...

See similar textbooks

Similar questions

Why is it difficult to swim under water in the Great Salt Lake?
An oil gusher shoots crude 25.0 m the through a pipe with a 0.100-m diameter. Neglecting resistance but not resistance of the pipe, and assuming laminar flow, calculate pressure at be entrance of be 50.0-m-Iong vertical pipe. Take of the oil to be 900 kg/m3 and its viscosity to be 100(N/m2) s (or 1.00 Pa s). Note that you must take into account the pressure due to 50.0-m column of oil in pipe.
Show that the total force on a rectangular dam due to the water behind it increases with the square of the water depth. In particular, show that this force is given by F=gh2L/2 , where is the density of water, h is its depth at the dam, and L is the length of the dam. You may assume the face of the dam is vertical. (Hint: Calculate the average pressure exerted and multiply this by the area in contact with the water. (See Figure 11.42.)
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate be new flow rate for following changes with all other factors remaining the same as in original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid wit 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube used with a 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half length, and pressure difference is increased by factor of 1.50.
Water pressure inside a hose nozzle can be less than atmospheric pressure due to the Bernoulli effect. Explain in terms of energy how the water can emerge from the nozzle against the opposing atmospheric pressure.
(a) Verify that a 19.0% decrease in laminar flow through a tube is caused by a 5.00% decrease in radius, assuming that all other factors remain constant. (b) What increase in flow is obtained from a 5.00% increase in radius, again assuming all other factors remain constant?
Suppose water is raised by capillary action to a height of 5.00 cm in a glass tube. (a) To what height will it be raised in a paraffin tube of the same radius? (b) In a silver tube of the same radius?
Calculate the maximum height to which water could be squirted with the hose in Example 12.2 example if it: (a) Emerges from the nozzle. (b) Emerges with the nozzle removed, assuming the same flow rate.
The tip of a nail exerts tremendous pressure when hit by a hammer because it exerts a large force over a small area. What force must be exerted a nail a circular tip of 1.00-mm diameter to create a pressure of 3.00109 N/m2? (This pressure is possible because the hammer striking the nail is brought to rest in such a short distance.)
If the gauge pressure inside a rubber balloon with a 10.0-cm radius is 1.50 cm of water, what is the effective surface tension of the balloon?
Referring to Figure 14.20, prove that the buoyant force on be cylinder is equal to the weight of the fluid displaced (Archimedes' principle). You may assume that be buoyant force is F2F1 and that the ends of be cylinder have equal areas A. Note Eat be volume of be cylinder (and that of be fluid displaces) equals (h2h1)A .
Water pressure inside a hose nozzle can be less atmospheric pressure due to the Bernoulli effect. Explain in terms of energy how the water can emerge from the nozzle against the opposing atmospheric pressure.