7.5 kN |P |Q D 0.5 m -1.5 m– 0.75 m 0.75 m

Q: To test the deflection on a uniform 100-kg beam, a boy of who weighs 50 kg exerts a pull of 150N on…

A:

Q: A cable 200 m long weighs 50 N/m and is supported from two points at the same elevation. Determine…

A:

Q: Two reservours with different liquilds A (s.g 0.8) and B (s.g 1.5) are connected by a Im square…

A:

Q: 6.139 A hand-operated hydraulic cylinder has been designed for use where space is severely limited.…

A:

Q: A metal bar AB of a weight W is suspendedby a system of steel wires arranged as shown in thefigure.…

A: Given:   Let,L=Length of side perpendicular to bar=5ina=Length of side parallel to bar=2inHypotnuse…

Q: Two cables are tied together at C and are loaded as shown. Determine the range of values of P for…

A: Given data To determine the range of values of P which both cables remain taut.

Q: in compression, determine the factor of safety against failure:

A:

Q: II. A rope is looped over the two fixed posts each of 16 cm diameter as shown, If u= determine the…

A:

Q: Knowing that the ultimate load for cable BD is 100 kN and that a factor of safety of 2.4 with…

A:

Q: A roller of radius r= 12 cm and weighs Q= 500 kN is to be pulled over a cub of height h = 6 cm by a…

A:

Q: The center span of the Verrazano-Narrows Bridge consists of two uniform roadways suspended from four…

A: Given data

Q: The beam of negligible weight is supported horizontally by two springs. If the beam is horizontal…

A:

Q: A beam is subjected to a linearly distributed downward load and rests on two wide supports BC and DE…

A: Given Data: The beam is subjected to 3 distributed loads. One is a trapezoidal load and the other…

Q: Knowing that the forces P and Q are equivalent to a single force R that passes through point A, Q =…

A: given;

Q: (a) Determine the maximum allowable horizontal span for a uniform cable with a weight per unit…

A: Draw the free-body diagram of the cable.

Q: A power transmission cable consists of ten copper wires each of 1.5 mm diameter surrounding three…

A:

Q: A collar B with a weight of W can move freely along the vertical rod shown. The constant of the…

A: To find: The value of θ corresponding to equilibrium. Given: The weight of the collar is W = 300 N.…

Q: For the shown frame and loads P=756 KN and Q=1512 KN, P-3 m- 3 m 1.5 m 1m magnitude of y-component…

A:

Q: Q2/ Knowing that the forces values given as: F1=26 N, F2328 N, F3=51 N, x1=0.6 m, x2=0.2 m, H=2 m…

A:

Q: In the mechanism shown below, the distributed load W is 300 N/m and the angle 0 is 35°, knowing that…

A:

Q: A machine component is subjected to the forces and couples shown.The component is to be held in…

A: Given Applied loading in the structure To find Rivet hole (a) On line FG (b) On line GH

Q: Which of the following most nearly gives the maximum uniform loading "w" in N/m that the cable can…

A: According to Bartleby guidelines, we are allowed to solve only a single problem.Please post the rest…

Q: Determine the forces in the members of the roof truss shown 30.2kN 30° 30 30° A 12.2kN

A: Given Truss We have to find force in member of trusses using method of joint

Q: 480 250 D B 360 130 320 360 450

A: Given:weight of plate (Wp)=850NTo find: tension in cable AC (TAC)

Q: crements. From the results obtained, determine (a) the maximum deflection of the rope, (b) the…

A:

Q: For the load diagram shown, determine the Reaction at B, Rg P = 10 kN X=1.8 m X2=1.05 m For the load…

A:

Q: Determine the reactions at A and B for the steel bar and loading shown in Fig. assuming a close fit…

A: Draw the schematic diagram for each condition given.

Q: The length of the 2-mm diameter steel wire CD has been adjusted so that with no load applied, a gap…

A:

Q: E 1.5 m D 1.5 m A 1.5 m PV B . 2 m 2 m

A:

Q: 6. A 12-m bar of negligible weight is acted upon by a vertical load P= horizontal load T 200 N and a…

A:

Q: W = 932.0kN B 60 m C 180 m A -130 m y

A:

Q: A vibration isolation unit consists of two blocks of hard rubber with a modulus of rigidity G= 19…

A: Given data: Modulus of rigidity (G) = 19 MPa                     A vibration isolation unit is given…

Q: Collar A is connected as shown to a 50-lb load and can slide on a frictionless horizontal rod.…

A: Draw the free body diagram of collar

Q: F,

A: Drawing the free body diagram of the beam as shown below – In the above FBD for F2 is shifted on…

Q: The uniform brass bar AB has a rectangular cross section and is supported by pins and brackets as…

A: Given Data  Load, P= 1.8 kips, Length of the bar AB, L = 7ft=84 in Depth of the beam, d=1.5in…

Q: Show that the curve assumed by a cable that carries a distributed load w(x) is defined by the…

A: Given: The beam is loaded with the uniform distributed load w(x).

Q: The ring at B is supported in equilibrium by spring AB, a cable running through the frictionless…

A: Given Data: The value of forces F1=340 N and F2=200 N. The unstretched length of the spring is…

Q: A machine component is subjected to the forces and couples shown. The component is to be held in…

A: ∑FX;      200cos55-120cos70+P=RXRX=152.14+P∑FY;      -200cos55-120cos70-80=RYRY=244.53 N Take moment…

Q: 2. A frame supports a 20lb load as shown. Detemine the reactions exerted by the pins on the frame…

A:

Q: Problem 3 A 30-m cable is strung as shown between two buildings. The maximum tension is and the…

A:

Q: The load of 2000 lb is to be supported by the two vertical steel wires for which sY = 70 ksi.…

A: Given data σy=70 ksilAB= 60 inlAC=60.04 inA=0.02 in2Est=29×103 ksi

Q: Collar A is connected as shown to a 50-lb load and can slide on a frictionless horizontal rod.…

A: Free body diagram       Force triangle

Q: 2. A 20-kg crate hanging at D is supported by a horizontal spring AB and a cable AC, as shown.…

A:

Q: F1 926N 1.50m 3.70 m 2.60 m 69.3° 71.1° 56.6° F2 F3

A:

Q: An acrobat is walking on a tightrope of length L-20.1 m attached to supports A and B at a distance…

A: Given, Length of the rope is 20.1 m Distance between AB is 20 m Let, Length of lope AC=l Horizontal…

Q: Supported as shown with the setup below. BC is a cable line having an area of 100 mm. If the cable…

A:

Q: Determine the forces in the members of the roof truss shown 23.4kN 30° 30° 30° 12.2kN B.

A:

Q: Show your work. Three cables are connected at A, where the forces P and Q are applied as shown.…

A:

Q: For the load diagram shown, determine the Reaction at B, Rg w = 9 kN/m xl = 1.15 m x2 = 1.58 m For…

A:

Q: For a system of levers shown, find the load P to maintain equilibrium with the bar AB in horizontal…

A:

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.