759.3 tar1)(Larmum (0.09206tatm ) (97. 5+ a73.1SK) molk PV 160.0(0.2864) = V= a85.4mL P-759.3 torr T- 97.5 °C %3D RT

Q: 9. R. Aveyard & co-workers (J. Chem. Soc., Farad Trans., 86, 211 ( 1990 ) have measured the surface…

A: The surface excess concentration Γ is the area-related concentration of a surfactant at the surface…

Q: Parameters to use for the problems that follow: K = 1.38 × 10-23 J/K q = 1.6 × 10-¹⁹ coulombs For…

A: Solutions- Given data- Nd = 4 x 1015 cm-3 Ni = 1 x 1010 cm-3  T = 300K

Q: At room temperature, the equilibrium mole fraction of vacancies in a crystal is 10-12. Now the…

A: Chemical potential is defined as the change in energy of the system upon addition or removal of a…

Q: 0.1 g of a zeolite adsorbs 5.58 cm³ of N2 gas at a pressure of 5.56 mbar, and 22.22 cm3 of N2 gas at…

A: Introduction:          The sorption of a gas or liquid on a solid surface is called adsorption…

Q: The size of the ionic atmosphere, called the Debye radius, is 1/K, where k is given by e2 NA 1/2…

A:

Q: A container of internal volume 22.0 m3 was punctured, and a hole of radius 0.050 mm was formed. If…

A: Theoretical Formula

Q: Calculate the van der Waals second viral coefficient (B) using Zvdw at 335.6 K, where Z ydw is given…

A:

Q: Given the equation: dU = TdS – PdV %3D U = (T, V) Show that:

A: Fundamental equations of Thermodynamics(1) The combined first and second lawFrom the first law: dU=…

Q: the moment of mixing. If, by chance, a pre 10-11. Given this information, will a precipi cause Q =…

A: Given,  Molarity of Mg(NO3)2 = 1.38×10-4 M Molarity of NaF = 1.76 ×10-4 M Solubility equilibrium…

Q: 5g of a catalyst adsorbs 400cm3 of N2 at stp to form a monolayer. What is the. Surface area per Gram…

A: Convert 400cm3 into L. This can be done as follows-

Q: When the velocity of enzyme is equal to 80% Vmax, Km is equal to A [S] 1/2 [S] B 1/3 [S] C 1/4 [S]

A: Km is the concentration of substrate at which the rate of the reaction(v) is the half of the Vmax ,…

Q: There is a class of polyesters that have the general structure shown below. For example, in…

A: Since in the above case, molecular weight is constant and it will affect the glass transition…

Q: The purification of hydrogen gas is possible by diffusion through a thin palladium sheet. Calculate…

A:

Q: 2. Describe the importance of volcano curve in the surface catalysis with suitable examples

A: The answer to the following question is-

Q: Determine the number of Frenkel and Schottky defects per cubic centimeter of a metal chloride at 40…

A:

Q: II) Calculate Vmax and Km . S (mol·1") v, mol·l"-min" 4.10 x 10 1.77 x 10* 9.50 x 10 1.73 x 10* 5.20…

A: A numerical problem based on chemical kinetics, which is to be accomplished.

Q: You are making orange soda from an orange flavor emulsion. The density of the orange oil is 0.85…

A: Given: density of orange oil = 0.85 g/cm3 density of 10% sugar solution = 1.04 g/cm3 radius = 3 mm u…

Q: A thin film of Co was deposited on the end of a long cylinder of Fe3O4. Afterwards, the cylinder was…

A: Diffusion coefficient can be manipulated by using the Fick’s law .The equation for diffusion…

Q: A monolayer of N2 molecules is adsorbed on the surface of 1.00 g of an Fe/Al2O3 catalyst at 77 K,…

A: Avogadro's number is the number of species present in 1 mole of a substance. Avogadro's number is…

Q: PV = nRT. The pressure is 0.9912atm.  V = 50.5 mL.  T = 21.5°C and n = 0.00200mol.   Calculate R…

A: We have to calculate the R that is gas constant.

Q: over- The Ez component of the PDC contains active sile(s) and. subunit/s- 2:2 different 2:2 idential…

A: The answer is attached below-

Q: ОСТ 18 19 20 21 22 23 24 25 26 27 16 BJECT: RATE CONSTANT (K) RMI. 4.0x10-6 M5-1 = K, [0.60]'…

A: An equation that represents the experimentally determined rate of reaction in terms of molar…

Q: The law of independent migration of .6 * :jons is defined as

A: In this question, we have to find out the correct answer of given problem by the help of the…

Q: What pressure of nitrogen gas is required to produce a collision rate of 5.00 × 1019 s−1 at 525 K on…

A: Given Temperature = 525 K Collision rate = 5.00 × 10 19 s-1 The average velocity is calculated as…

Q: A plot of Langmuir has been carried out for the adsorption of gas X onto platinum metal. The plot…

A:

Q: When the gas pressure is 200 torr at 0°C we see the adsorbed volume v is close to 100 cm^3, estimate…

A: Given: Pressure (P1) = 200 torr Temperature (T1) = 273 K Volume (V1) = 100 cm3 = 0.1 L Pressure (P2)…

Q: Nyroysis reoction is given bela : PPP ty pp toP a Now long will it take for D01% qf pp to hyarolize-…

A: The given hydrolysis reaction is a consecutive reaction in which initial concentration of substrate,…

Q: Q.2. The purification of hydrogen gas by diffusion through a palladium sheet: Compute the number of…

A:

Q: An analyst obtained the following data for the percent compound Z in triplicates (n=3) of an…

A: Given., the percent compound Z in triplicates (n=3) of an insecticide preparation: 7.47, 6.98, and…

Q: ON i, HNO3, H,SO, ii %23 - AIcı, ii, AICI, RCOCI

A: Two reaction are given, and their product are quite different than our expectation.

Q: From the Eº calculate Ksp for: a- Ag2CrO4 if Ag2CrO4 +2e- → 2 Ag+ + CrO42- Eº= 0.446v and Ag+ e- →…

A:

Q: Determine the concentration of Pb2+ in solution w/ 0.040 M NaNO3 that's satured with PbCl2 . (Ksp,…

A: The solubility product of PbCl2 = 1.66 × 10-5 Molarity of NaNO3 solution      = 0.040 M

Q: The location of particle and its direction on.1 solid surface depend on I. The dual interaction…

A: The location of particle and its direction on solid surface depends upon the following factors:

Q: Calculate ‘most probable velocity’ (Cmp) of oxygen at 40oC. (R= 8.314J/K/mol، 1J = 1Kgm2/s2)

A: calculation  of most probable velocity  Ump= 2RT/M T = 40°C Oxygen gas molar mass =32 g/mole

Q: A solid surface with dimensions 3.5 cm × 4.0 cm is exposed to helium gas at 111 Pa and 1500 K. How…

A:

Q: The data below relate to the adsorption of N2 on rutile (TiO,) at 75K, reduced to standard…

A: For N2 at 75K, the vapour pressure P∘=570 torr, Where, P(torr) values and their volume are given, We…

Q: 40 Boyle's, law 35 30 25 15 02 0-4 Dete 8 What is the sShape of the deta 2inear Yes.

A: In this question we will define Boyle's law and plot the respective graph. We will tell the shape of…

Q: Calculate the initial sticking probability of oxygen, if O2 gas at 10-6 mbar is dissociatively…

A: The sticking probability (s) = paI where, Pa = adsorption rate I = Flux

Q: Relative Intensity 3220 24 3209 24 2871 23 2057 28 2724 74 2713 74 2703 72 2013 79 1614 62 1600 39…

A:

Q: A nuclcon is scattered elastically from a heavy nucleus. The effect of the heavy nucleus can be…

A:

Q: A thin film of Co was deposited on the end of a long cylinder of Fe3O4. Afterwards, the cylinder was…

A: Concept: Diffusion coefficient can be calculated using Fick's Law. J =DdcdxOn rearranging, we…

Q: given that [Fe2+] = 0.60 M and [Cd2*] = 0.010 M? %3D %3D

A:

Q: Given the following modure of two compounds 50.00 mL of X (MW 67.00 g/mol)(density 1.224 g/mL) and…

A: Given: 1. Compound X, Volume = v = 50.00 mL Molecular weight = MW = 67.00 g/mol Density = d = 1.224…

Q: P16B.1 The viscosity of benzene varies with temperature as shown in the following table. Use the…

A: The term viscosity is defined as the resistance present internally in a liquid created at the time…

Q: In a homogeneous isothermal liquid polymerization, 20% of the monomer disappears in 34 minutes for…

A:

Q: The viscosity of Cl₂ gas at 293 K and 1.0 atm is 120 up, using these data, what would be the…

A: The expression to calculate the collisional cross-section of a molecule is: σ = 1 / 3 [(8RT / πM)1/2…

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.