8. And a ladder problem, a 32 foot ladder is place up against a wall. The base is 21 feet out from the wall. The ladder weighs 62 pounds and I weigh 150 pounds. When I am 3 feet down the ladder from the top, what is the Us I need from ground to not have it slide out on me? Us=

8. And a ladder problem, a 32 foot ladder is place up against a wall. The base is 21 feet out from the wall. The ladder weighs 62 pounds and I weigh 150 pounds. When I am 3 feet down the ladder from the top, what is the Us I need from ground to not have it slide out on me? Us=

Name: Question 8 please under a force of 100KN. Su=Pa8. And a ladder problem
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: Question 8 please under a force of 100KN. Su=Pa8. And a ladder problem, a 32 foot ladder is place up against a wall. The base is 21 feet out from thewall. The ladder weighs 62 pounds and I weigh 150 pounds. When I am 3 feet down the ladder fromthe to

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 82A

See similar textbooks

Similar questions

A 12 ft ladder that weighs 50lb rests against a frictionless wall at a point 10ft above the ground. How much force does the ladder exert (a) on the ground and (b) on the wall?
A 12m long post is bolted to the wall on its left end. It's right end is held horizontal by a wire that is attached to the wall, making a 35° angle with the post. If the post is 13kg what is the tension in the wire?
A window washer is standing on a scaffold supported by a vertical rope at each end. The scaffold weighs 192 N and is 3.3 m long. What is the tension in each rope when the 692–N worker stands 1.18 m from one end?
A typical jar that has been tightened to a reasonable degree requires 2.0 N⋅mN⋅m to open. f you grab a 8.2-cmcm-diameter jar lid with one hand so that your thumb and fingers exert equal magnitude forces on opposite sides of the lid, as in the figure, what is the magnitude of each of the forces?
A large advertisement board (W) is held in position by cable F1, with a breaking strength of 1500 N and a wooden strut F2 with a breaking of 750 N. Calculate the maximum weight the board can hold.
A typical jar that has been tightened to a reasonable degree requires 2.0 N ⋅ m to open. If you grab a 7.0-cm-diameter jar lid with one hand so that your thumb and fingers exert equal magnitude forces on opposite sides of the lid, as shown, what is the magnitude of each of the forces?
The 3.0-m-long, 96 kg rigid beam in the figure is supported at each end. A 72 kg student stands 2.0 m from support 1. How much force does the support 1 exert from the beam? How much upward force does support 2 exert on the beam?
A 20 kg traffic light hangs midway on a cable between two poles 40 meters apart. If the sag in the cable is 0.40 meters, what is the tension in each side of the cable?
A ladder leans against a wall 5 meters above the ground so a homeowner can clear his gutters of leaves from last fall. The bottom of the ladder just begins to slip when it is 1.7 meters from the wall. What is the coefficient of static friction between the bottom of the ladder and the ground?
A block of wood with mass 1kg is clamped to a vertical board with a force of 10N. What is the minimum vertical force needed to move the block upward? μs=0.15
A 10 m long and 20 kg ladder leaned against a vertical wall at an angle of 53o to the horizontal. The friction coefficient between the stairs and the ground is 0.3. The ladder does not rub against the wall. The first step of the ladder (the distance from the end of the ladder to the first rung) and the other steps are 37 cm. dir. How many steps can a man with a mass of 70 kg climb without slipping? (g = 10 m / s2, cos53o = 0.6, sin53o = 0.8)
A horizontal 4.0 m long 5.0 N uniform bar at one end is attached to a wall by a frictionless hinge; and at the middle of the bar there is a vertical cable pulling down 7.0 N, and at the middle of the bar there is also a cable that is at 45 ° to the horizontal pulling up as shown. i) What is the tension of the upper cable?