8.Two impedances, Z, = 0.8 + j5.6 Q and Z2 = 8 - j16 Q, and a single-phase motorare connected in parallel across a 200- V rms, 60HZ supply as shown in figurebelow. The motor draws 5 kVA at 0.8 power factor lagging.0.8 + j5.6 Q8-j16 OS3 = 5 kVAat 0.8 PF lag20020° VMa) Find the complex power S,, S2 for the two impedances, and S, for the motor.b) Determine the total power taken from the supply, the supply current, and theoverall power factor.

In this question we will find complex power for each impedance and total current and total power…

8. Two impedances, Z, = 0.8 + j5.6 Q and Zz = 8 - j16 Q, and a single-phase mot are connected in parallel across a 200- V rms, 60HZ supply as shown in figu below. The motor draws 5 kVA at 0.8 power factor lagging. 0.8 + j5.6 Q 8- j16 Q S3 = 5 kVA at 0.8 PF lag 20020° V M a) Find the complex power S,, S2 for the two impedances, and S3 for the motor. b) Determine the total power taken from the supply, the supply current, and the overall power factor.

8. Two impedances, Z, = 0.8 + j5.6 Q and Zz = 8 - j16 Q, and a single-phase mot are connected in parallel across a 200- V rms, 60HZ supply as shown in figu below. The motor draws 5 kVA at 0.8 power factor lagging. 0.8 + j5.6 Q 8- j16 Q S3 = 5 kVA at 0.8 PF lag 20020° V M a) Find the complex power S,, S2 for the two impedances, and S3 for the motor. b) Determine the total power taken from the supply, the supply current, and the overall power factor.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.29MCQ: The total instantaneous power absorbed by a three-phase motor (under balanced steady-state...

See similar textbooks

Similar questions

Consider a 3-phase delta induction motor that is operating at 120 Hz. The motor (load) impedance, Z_Δ is given as (9+j12)Ω. The line-to-line voltage at the load is, ?_ab=416 ∠30ºVrms. Let the source be wye-connected, and line impedance be negligible. a) Draw the single-phase wye equivalent circuit and label all known parameters numericallyincluding load voltage. b)Determine the rms phase current phasors for each phase. c) Calculate the complex power consumed by the 3-phase load. d) Determine the capacitance value of each capacitor in a 3-phase delta capacitor bank needed to correct the load to a power-factor of 0.9, lagging.
Consider a 10 kVA, 200/400 V, 50 HZ: single-phase tranformer has the folloving test results:0.C. test: 200 V, 0.6A, 63 W (L.V.side)S.C. test : 20 V, 25A, 85 W (H.V. side)Deternine:i- The eficiengy at 75 % offiull-load at 0.9 leading power factor.ii -The secondary terminal voltage on fill-load at tunity power facton
A single-phase alternator connected to 6,600-V bus-bars has a synchronous impedance of 10Ω and a resistance of 1 Ω. If its excitation is such that on open circuit the p.d. would be 5000 V, calculate the maximum load the machine can supply to the external circuit before dropping out of step and the corresponding armature current and p.f. [2864 kW, 787 A, 0.551]
L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm, line voltage 220 V and frequency 50 Hz star-connected 3-phase ASM, ignoring core (iron) losses given as follows: R1=0.21 Ohm, R2=0.18 Ohm, X1=X2=0.66 Ohm and Xm=9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly?
In an energy transmission system with a power value of 100 MVA and a power coefficient of 0.8 reverse (inductive), the generator in a hydroelectric power plant was operated as an over-excited synchronous motor for grid power compensation and was connected to this system as a capacitive load of approximately 40 MVAR. Show the active, reactive and apparent powers on the phasor diagram (power triangle) and calculate the new power factor after the synchronous capacitor is connected.
Consider a 3-phase delta induction motor that is operating at 120 Hz. The motor (load) impedance, Z_Δ is given as (9+j12)Ω. The line-to-line voltage at the load is, ?_ab=416 ∠30ºVrms. Let the source be wye-connected, and line impedance be negligible. b)Determine the rms phase current phasors for each phase. c) Calculate the complex power consumed by the 3-phase load. d) Determine the capacitance value of each capacitor in a 3-phase delta capacitor bank needed to correct the load to a power-factor of 0.9, lagging.
A 400-V, 3-phase induction motor load takes 900 kVA at a power factor of 0.707. Calculate the KVA rating of the capacitor bank to raise the resultant power factor of the installation of 0.866 lagging. Find also the resultant power factor when the capacitors are in circuit and the motor load has fallen to 300 kVA at 0.5 power factor.
Which termination would result to a phase change of 180 degrees at the load if Zo = 100 ohm? a. 50 ohm b. short circuit c. 75 ohm d. all of these What is the purpose of impedance matching? a. maximum return loss b. maximum SWR c. maximum load power d. maximum reflection A short piece of transmission line that may be open or shorted and used for impedance matching purposes. a. converter b. decoder c. stub d. transformer
Impedance values in ohms per phase of 380 V, 50 Hz, 2p = 6, star connected induction motor:R1 = 0.3X1 = j0.45R2 = 0.15X2 = j0.45xm = j15Its total mechanical losses are 500W. Core losses are negligible. For a rotor slip of 0.01 at rated voltage, calculate the following:a. Input currentb. power factorc. rotor frequencyd. synchronous speede. rotor speedf. Input active powerg. Stator copper lossesh. air gap poweri. Transferred power and Output powerj. shaft momentk. Yield
L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm, line voltage 220 V and frequency 50 Hz star-connected 3-phase ASM, ignoring core (iron) losses given as follows: R1=0.21 Ohm, R2=0.18 Ohm, X1=X2=0.66 Ohm and Xm=9.9 Ohm How many times the rated current will the inrush current be when the ASM is started directly?
Please answer all subparts for like either dislike is ready at least 5 subparts... A 3-phase, 450 V, 2-pole, 50 Hz, wye-connected, synchronous alternator. Xs = 1.62 ohm/phase. Connected to an infinite bus and supplies 120 kW with a power angle of 35 degrees.Neglect losses and find:a. turbine torque supplied to alternator.b. excitation voltage.c. active, reactive power and machine power factor.d. neglecting saturation effects of the field, the excitation voltagee. if the field current is reduced to 80% of its original value in part a.f. the turbine speed for 60 Hz operation.
Two parallel loads are connected to a 120 volt rms, 60 Hz power line. One load absorbs 10 k watts at 0.8 power factor lagging. The second load absorbs 4 k watts at 0.9 power factor leading. Determine the real (watts) and reactive (VARS) power of the combined load.