8085 microprocessor went through its manipulation operation in the ALU, the results was transferred on the data bus and status of the results was stored in the flag register for indications . With your knowledge and understanding illustrate a complete bit configuration of 8085 flag register and show the functions of the represented bits in the register.

8085 microprocessor went through its manipulation operation in the ALU, the results was transferred on the data bus and status of the results was stored in the flag register for indications . With your knowledge and understanding illustrate a complete bit configuration of 8085 flag register and show the functions of the represented bits in the register.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Similar questions

What is an MSDS?
S Display will be designed for a thermometer. The display will show that degree for minimum temperature and 99 degrees for maximum temperature. According to this; a) What is the number of bits that will be needed in the binary code to express the temperature? b) What are the binary, octal and hexadecimal equivalents of 95 degrees? () What is the BCD representation of 95 degrees? d) What is the hex equivalent of this temperature when it shows 111 degrees octal? e) If the thermometer showed a temperature between -99 and +99 degrees, how many bits would we need?
In a digital communication, explain all the methods/mechanism used for the minimization of Bit Error Rate (BER). Also state that which method/mechanism is preferred and why?
Microprocessors; Draw the figure for flag-bits allocation in an 8086 microprocessor. Explain shortly the meanings of letters used for each flag statues in Assembler.
Q: Show, how to use the ROM circuits to multiply two binary numbers each of two bits.(DSD)
An ADC has a uniform quantizer followed by a 7-bit binary encoder. The bit rate of the system is 50Mbps. What is the maximum frequency of the analog signal for which system operation is satisfactory?
The 8085-instruction set does not include a Clear Carry instruction. Which single-byte logical instruction can clear the carry without modifying the contents of the accumulator?
A 4 bit binary count have terminal count of?
Draw the figure for memory segments with 8086 microprocessor software model. Explain the logical address structure used for each segment (Explain which registers are used in logical address presentation of each segment; segment address : offset address). Give an example solution to find the physical address in a segment from the logical address for 8086 microprocessor.
5) below is the accuracy table showing the output values for two separate binary number entries (W and Y) with a length of two bits. Get the simplest form of output functions with the Karnaugh diagram. Draw a logic diagram of the circuit that performs the function of these functions.Describe in detail which functions a, b and C perform for 2-bit binary numbers in the input.
Is it possible to convert 16-bit binary data to 8-bit binary data such as: 1111111011111110 -> this 16 bit to 8 bit? If possible then do it and mention the converted binary number.
1a. If an 8-bit binary number is used to represent an analog value in the range from 010 to 10010, what does the binary value 011001002 represent? 1b. If an 8-bit binary number is used to represent an analog value in the range from 32 to 212, what is the accuracy of the system? In other words, if the binary number is incremented by one, how much change does it represent in the analog value?