Given a 8-bit number at memory location 2050H. Write 8085 instruction to move the value stored at the following locations: Register B Accumulator 2052H Write a single program and show register and accumulator screenshot and also attach memory view. In sim8085 software.

Given a 8-bit number at memory location 2050H. Write 8085 instruction to move the value stored at the following locations: Register B Accumulator 2052H Write a single program and show register and accumulator screenshot and also attach memory view. In sim8085 software.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Related questions

Q: Microprocessor Systems Question: A 20-bit address bus, an 8-bit processor uses a 3-to-8 decoder to…

A: The solution can be achieved as follows.

Q: Q2. Write assembly language program to substrate two 8-bit numbers and store the result on memory…

A: considering the two 8 bit numbers are located in the locations 2000H and 2001H. and the result will…

Q: Microprocessor 8085 : Note 1: Use F for fetch, R for memory read, W for memory write, IOR for IO…

A: CPI instruction stands for Compare immediate data with Accumulator. This is a two byte instruction…

Q: How does Arduino microcontroller differentiate an input logic signal 0 to logic signal 1 given a 5V…

A: Microcontroller is a pin device which contains Input/output ports and CPU for processing.

Q: What is the memory organization for a chip that has 13 address lines and 8 data lines?

A: Memory of an IC Is organized into the number of locations in it. As it is given that A chip is…

Q: The segment registers, instruction pointer, address generation & bus control, instruction queue…

A: The segment register, instruction pointer, address generation & bus control, instruction queue…

Q: 10. What type of data (serial or parallel) is enabled by a low mode control input? Parallel Data…

A: by observing the above circuit ,it can be seen that the and gate to which the parrallel data input…

Q: a) Draw the figure for memory segments with 8086 microprocessor software model. Explain the logical…

A: There are 4 segments in 8086: 1) Code Segment (CS) 2) Data Segment (DS) 3) Stack Segment (SS) 4)…

Q: (a) Write the difference between digital and analog system? (b) Mention the advantages of digital…

A: Digital system digital systems deal with discrete data that has a fixed number of values i.e…

Q: Assume SS=5000H, DS=6000H, ES=7000H, CS=9000H, BX=1000H, DI=2000H, BP=3000H, IP=4000H, SI=2000H, the…

Q: 2. What is the duration of bus cycle in 8086 MPU if the clock is 20 MHz and two wait states are…

A: Actually all the questions are different, so I am solve 1St questions. 2.

Q: The 8085 instruction set does not include a Clear Accumulator instruction. Which single-byte logical…

A: XRA A is the instruction which is of only 1 byte of size ,which can reset the content of accumulator…

Q: Explain the program memory structure of 8051 microcontroller.

A: We are authorized to answer one question at a time since you have not mentioned which one you are…

Q: Design a memory system for the 8088 Microprocessor such that it can select two EPROMS (128K x 8)…

A: Given starting memory address=20000 H2 EPROM =128×8

Q: 1.Using the byte rotation scheme described for the ARM7TDMI, calculate the instruction and rotation…

A: Using byte rotation scheme Following is determined

Q: Continuing with a 32 Khz system clock/8000 Khz instruction clock, assuming a pre-scalar of 1:1 (i.e.…

A: According to the question, for continuing with a 32 kHz system clock/8000 kHz instruction clock,…

Q: Write assembly language program to substrate two 8 bit numbers and store the result on memory…

A: % SUBTRACT 30H FROM 40H AND STORE THE RESULT IN ACCUMULATOR MVI A,40H MOV B,A MVI A,30H SUB B STA…

Q: Describe any possible methods through which you can implement a RAM memory using logic gates?

A: RAM : RANDOM ACCESS MEMORY . Since flip flop are made up of logic gates hence if we implemented the…

Q: In a RAM chip of size 256M x 32, what are the number of data lines and address lines?

A: Buses have a address lines data lines and control lines. The data lines: Convey bits…

Q: Explain the program memory structure of 8051 microcontroller.

A: 8051 microcontroller is designed in the year of 1981 by INTEL. It is an 8-bit microcontroller, have…

Q: What Is the jobs done by registers inside a CPU

A: A register is each of a small set of knowledge-holding locations that are part of a pc processor. A…

Q: Draw the complete logic circuit using pic16f84a microcontroller and write the necessary code that…

Q: Write an assembly language program in microprocessor 8085 so that I can fetch 2 8 bit numbers from…

A: Let us assume that two 8 bit numbers are stored in the following memory locations: 8100H: 1st number…

Q: 6.) Select all the 8088 input signals that can cause the microprocessor to take an interrupt. a.)…

A: 8088 Is the first generation 16-bit microprocessor from the intel corporation. It can processed…

Q: A 16-bit successive approximation ADC is to be designed to operate at 50,000 conversions/second.…

A: Given Nmax=50,000 conversion/s Calculating conversion time TT=1NmaxTT=150,000 conversion/sTT=2×10-5…

Q: Convert decimal number 54.3125 to fixed point binary notation. How many bits are needed? Suppose…

Q: Suppose we have two registers, Rl and R2, and between them we have a combinational logic circuit.…

A: Formula of maximum frequency; fc(max)=1Tmax Formula of Tmax; Tmax=tpcq+tpd+tsu+tccq+tcd+th…

Q: Q.65 (i) How many 128x8 RAM chips are required to provide a memory capacity of 2048 bytes. (ii) How…

A: Solution !!

Q: In the MIPS processor that is part of the PIC32 microcontroller, what is the length of each…

A: MIPS stands for Microprocessor without Interlocked Pipelined Stages. MIPS processor is a part of the…

Q: B) Name the intemal registers of 8086. Table the combination of registers to form the physical…

A: Internal Registers of 8086 : Instruction Pointer Four Data Register Four Pointer & Index…

Q: Q3: The original contents of CX, AX, memory location Beta, and carry flag (CF) are FFE116 11AB16,…

Q: Assume that the contents of 8086 microprocessor registers are: DS= 3300H, CS=1033H, SS= 1614H, SP=…

A: The stack memory at 1E76A H is not covered by the segment. This is because the maximum value of the…

Q: Consider the following instruction mix of the LEGV8 assembly code: R-type I-type LDUR STUR CBZ B 24%…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: BHE and A0 when an 8086 Microprocessor is 1- What logic levels would you find on writing a byte to…

A: 8086 Microprocessor- It is an upgraded version of 8085 microprocessor. Properties- It is 16 bit…

Q: Explain the ADD instruction of 8086. Compare it with ADC instruction.

A: Given that Explain the ADD instruction of 8086. Compare it with ADC instruction.

Q: 2// Explain the advantage's of Programmable Logic Devices?

A: programmable logic device is an semiconductor device that programmed to obtain various logic…

Q: 1. Represent the decimal values 11 and -10 as 8-bit signed integers. Add the two binary…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Q1) Write an assembly program to duplicate each memory location block (size N) starting at address…

Q: How many bits do the registers of the 8086 processor have and which registers can be split into…

Q: Q4/ design synch. Counter using T flip flop and any extra logic cct's needed to count the sequence…

Q: In a multibyte addition program, when must you use the ADD instruction? When must you use the ADC…

A: In this question we will write about ADD and ADC instruction..

Q: Browse for the datasheet of 8086 from Intel and using the information from datasheet answer the…

A: i) Draw the neat diagram of 8086:

Q: Q3: The original contents of CX, AX, memory location Beta, and carry flag (CF) are FFE1 16 11AB1,…

Q: 1. Using the byte rotation scheme described for the ARM7TDMI, calculate the instruction and rotation…

A: The instruction and rotation needed to load the following are determined as shown below

Q: 3) Assume SS=5000H, DS=6000H, ES=7000H, CS=9000H, BX-1000H, DI=2000H, BP=3000H, IP=4000H, SI=2000H,…

A: Dear student ,you have posted 2 question in a single request.We will answer first question only.If…

Q: 1. Maximum operating frequency of PIC microcontroller is 8 MHZ 12 MHZ 16 MHZ 20 MHZ 2. PIC 16f877a…

A: 1) Option - D -- 20 MHZ Maximum operating frequency of PIC microcontroller is 20 MHZ 2) Option -…

Question

Given a 8-bit number at memory location 2050H. Write 8085 instruction to move the value stored at the following locations:

Register B
Accumulator
2052H

Write a single program and show register and accumulator screenshot and also attach memory view.

In sim8085 software.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

What is an MSDS?
Microprocessor 8085 : Note 1: Use F for fetch, R for memory read, W for memory write, IOR for IO read, and IOW for IO writeNote 2: Use hexadecimal where possible Q/ Using (SIM) instruction, what is the data required in the accumulator to enable all hardware interrupts and send a (zero) serially?
The 8085-instruction set does not include a Clear Carry instruction. Which single-byte logical instruction can clear the carry without modifying the contents of the accumulator?
Draw the figure for memory segments with 8086 microprocessor software model. Explain the logical address structure used for each segment (Explain which registers are used in logical address presentation of each segment; segment address : offset address). Give an example solution to find the physical address in a segment from the logical address for 8086 microprocessor.
Assume SS=5000H, DS=6000H, ES=7000H, CS=9000H, BX=1000H, DI=2000H, BP=3000H, IP=4000H, SI=2000H, the physical address and the addressing mode of the following memory location specified in the instruction MOV [DI+3000H], AL are ……… and ……… .
Write an assembly language program for 8085 microprocessor to add 2 digit BCD numbers stored in memory location C050H and C051H respectively and store the result in memory location C052H.
Write an assembly language program in microprocessor 8085 so that I can fetch 2 8 bit numbers from memory locations and store the product, whether it's 8 bit or 16 bit, in 2 different memory locations. I am aware with programming logic. So, only give me the working program and attach a snapshot of the output. No need to explain.
Construct a bus system using tri state buffer for 2 registers having 4 bits each.
2.Assuming the processor frequency is 20 MHz, find the highest square wave frequency that can be generated using Timer0 in 16-bit mode. (Calculations only, no code needed).
Explain the program memory structure of 8051 microcontroller.
Microprocessor 8085 : Note 1: Use F for fetch, R for memory read, W for memory write, IOR for IO read, and IOW for IO writeNote 2: Use hexadecimal where possible Q/ -How many address lines are required for 4 kB memory addressing - What are the machine cycles required for (LDA) instruction?
Consider two microprocessors having 8-bit and 16-bit wide external data buses, respectfully. The two processors are identical otherwise and their bus cycles are the same speed. Suppose all instructions and operands are two Bytes. By what factor do the maximum data transfer rates vary? Suppose all instructions and operands are one Byte. By what factor do the maximum data transfer rates vary? Discuss your answers.