8:37 : Question 21 of 23 Submit Construct the expression for Ksp for solid Bilz in aqueous solution. Bil,(s) = Bi* (aq) + 3 l (aq) 1 Based on your knowledge of how the solid will dissociate in aqueous solution, use the tiles to form the expression. Ksp RESET [Bil.] 2[Bil.] [Bil.]? [Bi*] 3[Bi*] [Bi*]* [Bi*] 3[Bi*] [Bi*]3 [] 3[1] [1] [18] 3[1*] Tap here or pull up for additional resources

8:37 : Question 21 of 23 Submit Construct the expression for Ksp for solid Bilz in aqueous solution. Bil,(s) = Bi* (aq) + 3 l (aq) 1 Based on your knowledge of how the solid will dissociate in aqueous solution, use the tiles to form the expression. Ksp RESET [Bil.] 2[Bil.] [Bil.]? [Bi] 3[Bi] [Bi] [Bi] 3[Bi] [Bi]3 [] 3[1] [1] [18] 3[1] Tap here or pull up for additional resources

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter16: Solubility And Precipitation Equilibria

Section: Chapter Questions

Problem 52P

See similar textbooks

Similar questions

1. The Ksp of Ca3(PO4)2 is 1.3 × 10−26. Estimate the solubility of this salt in units of g. L−12. If a sample of solid Ca3(PO4)2 is stirred into exactly one litre of a 0.550M solution of Na3PO4, how will the solubility of the salt compare with the answer that you have obtained in question 2.1? Explain you answer in a short sentence.
1.1The Ksp of Ca3 (PO4 ) 2 is 1.3 × 10−26 . Estimate the solubility of this salt in units of g. L −1 . You must show any reaction equation(s) that you may think are necessary. 1.2 If a sample of solid Ca3(PO4)2 is stirred into exactly one litre of a 0.550M solution of Na3PO4, how will the solubility of the salt compare with the answer that you have obtained in question 1.1? Explain you answer in a short sentence.
The Ksp of Fe3(PO4)2 is 5.51⋅10-21 M. Calculate the solubility of Fe2+ and PO43- in a saturated solution.
The solubility of Ag₂SO₄ in water at 25 °C is 0.0155 M. What is Ksp for Ag₂SO₄?
What is the maximum solid solubility of Mg in Al? At what temperature does it occur? e. An Al-Mg alloy (10 wt% Mg, 90 wt% Al) is heated slowly (to insure equilibrium) from a temperature of 200 C: i. At what temperature does the first liquid phase form? ii. What is the composition of the liquid phase at the temperature in part i.? iii. At what temperature does complete melting (no solid phase remaining) occur? iv. What is the composition of the last solid remaining prior to complete melting? f. Using the equilibrium phase diagram of Figure 1, identify the phases present, their compositions, and their relative mass fractions at equilibrium for a 70 wt% Mg – 30 wt% Al alloy held at 300 C.
Calculate the solubility (in g/L) of silver chromate in water at 25°C if the Ksp for Ag3PO4 is 1.75 × 10-18. Ag3PO4(s) <==> 3Ag+ (aq) + PO43- (aq); Ksp = 27s4, s = _________ mol/L x MM of Ag3PO4 = _________ g/L.
The solubility of aqueous PbCr2O7 at 25 oC is 1.55 x 10–2 g/L at 25.0 oC. Calculate the Ksp of PbCr2O7 at this temperature. MM PbCr2O7 = 423.188 g/mol
2.3 - At temperature of 18°C was 4,7 g of silver molybdate (M = 376 g mol–1) mixed with 500 cm3 of a) distilled water b) solution of AgNO3 with concentration of 0,02 mol dm–3 c) solution of Na2MoO4 with concentration of 0,02 mol dm–3 Determine, how many percent of Ag2MoO4 will dissolve in each case. Solubility equilibrium of Ag2MoO4 is 3,1.10-11.
The following evidence was obtained from an experiment to determine the solubility of calcium chloride at room temperature. A sample of saturated calcium chloride solution was evaporated to dryness, and the mass of solid residue was measured.EvidenceVolume of solution (mL) = 15.0Mass of empty beaker (g) = 90.54Mass of beaker and residue (g) = 101.36The solubility of calcium chloride is g/100 mL
A solution is prepared by dissolving 40.00 g of NaCl (f.w. = 58.44 g mol–1), a non-volatile solute, in enough water (m.w. = 18.02 g mol–1) to result in exactly 1 L of solution at 25 °C. Assume the density of the solution is that of pure water (dsolution = 1.000 g mL–1). The ebullioscopic constant (Kb) for water is 0.513 °C m–1. The cryoscopic constant (Kf) for water is 1.86 °C m–1. The vapor pressure of pure water is 0.0313 atm. Find the freezing point of the solution(in C to 2 decimal places)
A solution is prepared by dissolving 40.00 g of NaCl (f.w. = 58.44 g mol–1), a non-volatile solute, in enough water (m.w. = 18.02 g mol–1) to result in exactly 1 L of solution at 25 °C. Assume the density of the solution is that of pure water (dsolution = 1.000 g mL–1). The ebullioscopic constant (Kb) for water is 0.513 °C m–1. The cryoscopic constant (Kf) for water is 1.86 °C m–1. The vapor pressure of pure water is 0.0313 atm. Find the vapor pressure of the solution to 3 decimal places in atm.
A solution is prepared by dissolving 40.00 g of NaCl (f.w. = 58.44 g mol–1), a non-volatile solute, in enough water (m.w. = 18.02 g mol–1) to result in exactly 1 L of solution at 25 °C. Assume the density of the solution is that of pure water (dsolution = 1.000 g mL–1). The ebullioscopic constant (Kb) for water is 0.513 °C m–1. The cryoscopic constant (Kf) for water is 1.86 °C m–1. The vapor pressure of pure water is 0.0313 atm. Find the osmotic pressure in atm to three decimal places