9. Find the load impedance Z₁ for the networks in Fig. for maximum power to the load, and find the maximum power to the load. (answer: = 2.48N+j5.15N, 309.135 W) R₁ 3 Ω E₁100 V20⁰ voo 4Ω + ZL voo 9Ω Xc822 R₂ 120 + E₂200 V Z 90°

Q: For the common emitter (CE) circuit shown below, find the value for the output impedance Rout in…

A: Given data IC=7.0 mA VA=150 V RL=∞ RC=10 kΩ To find out We have to determine the value for output…

Q: Problem #6) Given the Thevenin's Equivalent Circuit for the single-port network shown in the figure…

A: Given, The Thevenin's equivalent circuit is shown below,

Q: Use the step-by-step technique to find vo(t) for t > 0 in the circuit shown below. (-+) 12 V t= ΖΩ W…

A:

Q: What arrester nominal rating shall be used in a 13.8 KV grounded system? How and why?   •    11 KV •…

A: To find: What arrester nominal rating shall be used in a 13.8 KV grounded system? How and why?

Q: Find the rms voltage, V1.rms, across the primary coil of the transformer. V1.rms [V]:

A: In this question We need to determine the rms current in the secondary side, voltage across the…

Q: Use the step-by-step method to find vo(t) for t > 0 in the circuit shown below. + v(t) 18V (+ ww 3…

A:

Q: Given a = 2, b = 1, c = 1, d = 12, e=24, f = 1 and g = 7.5, in the circuit below, obtain the phasor…

A: here we have to find the current I0 .

Q: 1. A 30 MHz plane wave with h=10 sin(wt+ ßx)âmA/m exists in region x20 having σ = 0, ε =25ɛ, µ=4µ.…

A: According to the question, the given EM wave h→ =10sinωt+βxaz^  exist in the region x≥0 having σ=0,…

Q: A load of 145 MW at a power factor of 0.6 lagging can be delivered by a 3-phase transmission line.…

A:

Q: Question 2 [ "J Consider the following circuit and answer the questions below. sa 12V B R1 60 i1 ↓…

A:

Q: D.  Find y22. Express your answer to three significant figures and include the appropriate units.

A: In this question we need to find Y22 of the given two port network.

Q: answer asap find: IaA IbB IcC provide soln ty

A:

Q: Given Vcc=100V, R₁-2002, ß-100, VBB-5V, flip the switch to close, 3. and Ic=0.4A, 1) Determine IB.…

A: Given that  Vcc =100 v RL = 200 ohms Beta = 100 VBB = 5 v Ic = 0.4 A

Q: Question 1 Consider the circuit shown below where: R₁ = 10; R₂ = 8; C = 1/8 F; L=2 H; i (0) = ½ A;…

A:

Q: Problem #1) Given the time-varying voltage: (t)=30-sin(377-1+45°) Express the voltage as its (RMS)…

A:

Q: 1. An iron ring has its mean length of flux path as 60 cm and its cross sectional area as 15 cm ^2.…

A: Final answer is  Current I = 1145.91 AT  Bair = 2.4 x 10-3 T

Q: Problem 2: For the transfer function below (s + 4) s³ +68² +11s +6 write the state equations and the…

A:

Q: Explain the Minimum Model of 8086 With the Corresponding pin signals description.   this is related…

A: The 8086 microprocessor is a 16-bit CPU with a 20-bit address bus and a 16-bit data bus. The minimum…

Q: P11_a, f= 5 kHz |VR| = P11_b, f= 70 kHz |VR| P11_c, f= 100 kHz |VR| = (mV) LVR= LVR= LVR= (deg.

A: Given Data: Circuit diagram is given as, Peak input Voltage Vin, p=1 V Here, the RMS input voltage…

Q: A point at which two or more elements have a common connection is called a mesh. Select one: O True…

A: A point at which two or more elements have a common connection is called a node.

Q: 2. The plane wave ₹ = 50 sin(wt – 5x)ây V/m in a lossless medium (µ=4µ, ε = ¿) encounters a lossy…

A:

Q: 20001, 1ΚΩ 2ΚΩ 12V + Tw 2ΚΩ 1kΩ Ix 1ΚΩ Vo

A:

Q: With neat block diagram explain the speed measurement system using tacho-generator. 2. Explain the…

A: A tachogenerator is a type of electromechanical device that is commonly used to measure the speed…

Q: Question 17 mammi     .Find f by simplifying the following equation 1. f= (ABCD)' 2. Find f' if f…

A: We need to simplify the given Boolean expression and we need to find out compliment of given…

Q: 3.36 Assume steady-state conditions and find the energy stored in each capacitor and inductor shown…

A:

Q: 1. Write a Verilog code (one line) that implements the schematic below a P BD B

A: here we have to write the verilog code for the given diagram

Q: Suppose that R= 80 12 in (Eigure 1). Figure 30 Ω 2 1 ww 20 Ω R 3 1 of 1 Y Part A To which two points…

A: We need to find out power dissipation in the given circuit.

Q: 4. Phasors and Impedance: Calculate the impedance of the circuit shown below at @= 5 radians per…

A: The equivalent impedance of the capacitor and inductor can be calculated for the given angular…

Q: 9nm 8nm P 6nm 7nm D A B с 3.0x10 17C -5.0x10-17C 2.0x10-17℃ -4.0x10-17C What is the total work done…

A: Potential at a point due to a point charge V=kQr where k→contant Q→Charge  r→distance of point from…

Q: Q1.) Find the current io(t)

A: It is given that:

Q: Draw the continuous (DC load line) for the circuit and Find the value S? RB = 43 kΩ 10 μF www RE (a)…

A:

Q: Question 2. (a) Find ve(t) for all time in the following circuit. (b) At what time is vc = 0.1vc…

A:

Q: ITEM 2 a. A current is given by this equation 1 = 2t^3+ t^2 + 3, a capacitor has an initial charge…

A: According to given questions, we need to solve only item 2. In the given questions, we need to…

Q: Question-2 Consider the following circuit (assuming the ideal diode model): iD V +1 Dic↓ ILY C R (a)…

A:

Q: Question 24 Determine the current flowing through a 6 mH inductor if the voltage (defined such that…

A: here we have to find the current through the inductor of 6mH.

Q: A 3-phase, 50 Hz, 50 km long overhead line supplies 550 kW at 22 kV, 0.9 p.f. lagging. The line…

A:

Q: Just where is it most convenient to find a PKES system?

A: Automobiles is most convenient to find a PKES system

Q: If Phasor C = Phasor A + Phasor B, what is the resultant magnitude of C? Blank 1 What is the…

A: In this question We need to determine the resultant magnitude and angle of the phasor C.  Given…

Q: 4. Determine the voltage gain of the non-inverting op-amp with Rf-100k and R1=4.7kQ2. Calculate the…

A:

Q: A point at which two or more elements have a common connection is called a mesh. Select one: True…

A:

Q: A circuit is to be designed that generates the following sequence of values on each rising edge of…

A: According to the question, A circuit is to be designed that generates the following sequence of…

Q: Differential between the high temperature Low Sag Conductors and Convetional converters,

A: To differentiate  between the high temperature Low Sag Conductors and Conventional converters. The…

Q: Hanging a ceiling fixture directly from a plastic outlet box is permitted only if

A: Hanging a ceiling fixture directly from a plastic outlet box is permitted only if the box is…

Q: 5. Consider a discrete system, if the input x(n) = (0.6)" u(n) and the impulse response h(n) =…

A:

Q: There exists a uniform electric field with a magnitude of 20 kN/C. What is the electric potential at…

A: Given data Magnitude of the electric field; E=20 kN/C Potential point from the zero potential point,…

Q: Q3) For the following Op-Amp circuit. Calculate V, when Vi=1.5V and Va=-3.8V. 20 ΚΩ 10 ΚΩ 60 ΚΩ 50…

A:

Q: Calculate the value of the resistors R, through R, in the circuit of Fig. 2-34.

A:

Q: 2. A 20 KVA, 2500/250 V, 50Hz, single-phase transformer gave the following test result: Open-circuit…

A:

Q: -1 0 1 2 3 4 5 sing the discrete signal x[n], represent by a graph the following signal. [n-2] n

A: Given here x[n] signal and asked to draw the graph of x[n-2] signal.

Q: In the balanced three phase power measurement using two wattmeter method, each wattmeter reads 20…

A: In this question we need to find the reading of wattmeter .

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.