9. Water flows in a 2- by 4-cm rectangular duct at 15 m/s. The duct undergoes a transition to a 6-cm-diameter pipe. Calculate the velocity in the pipe in m/s. A. 3.65 C. 4.87 D. 5.22 B. 4.24 10. Two meters of water is equivalent to how many millimeters of mercury (sg = 13.56)? A. 287.45 C. 269.65 B. 278.96 D. 254.11

9. Water flows in a 2- by 4-cm rectangular duct at 15 m/s. The duct undergoes a transition to a 6-cm-diameter pipe. Calculate the velocity in the pipe in m/s. A. 3.65 C. 4.87 D. 5.22 B. 4.24 10. Two meters of water is equivalent to how many millimeters of mercury (sg = 13.56)? A. 287.45 C. 269.65 B. 278.96 D. 254.11

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Water at 20°C exits the atmosphere through the split nozzle as shown in Figure-5. The duct areas are ?1=0.02 m2 and ?2=?3=0.008 m2. If the gauge pressure at the inlet is equal to 9786 kPa and the flow rate is ?.2=?.3=200 m3/h, compute the force acting on the flange.
Water flows through a pipe at 5L/s as shown in the figure. The gage pressure of 150.5 kPa,118.03 kPa, and 115.87 kPa are meassured for p1,p2 and p3, respectively. A.What is the head loss between 1 and 2 Choices: 3.31m,3.81m,5.24m,4.25m B.what is the headloss between 2 and 3 Choices: 7.8m,7.7m,7.9m,8.0m C.What is the distance between 1 and 2 if the friction factor 0.02? Choices: 25m,15m,20m,30m
Refer to Fig. P5.4. Water at 10°C flows up AB (5 m long, 40 mm diameter),then along BC (3 m long, 30 mm diameter). The measured pressure at A is 275kPa. (a) Find the pressure at C if the flow rate is 2.0 L/s. Neglect pipe frictionand energy losses. 6) Repeat for the same flow rate in the opposite direction.Table A.1 for water at 10°C: y = 9.804 kN/m².Vertical
The rectangular bin with an inclined gate AB is filled with water to the depth shown. Determine the location in meters along with the inclination of the center of pressure from the water surface when the total pressure is acting on gate AB x=0.82 a=2.02 m b=30 degrees asap 15 mins
A rectangular gate 1.60 m wide and 2.40m high has water on one side and is inclined 45\deg with them horizontal. Water is 1.50m above the top of the gate. Evaluate the location, in meters, of the center of pressure from the top of the gate. a. 1.34 b. 1.49 C.1.56 d. 1.64
A new cast iron pipe must carry 1.2 m3/2 at a head loss of 5m per km length of the pipe. Compute the diameter of the pipe in mm using n= 0.019 Choices: A. 1210.47 B. 1012.74 C. 2101.74 D.112.47
A pipe line between points A and B consist of 305m of 200mm, followed by 245m of 300mm, followed in turn by 150m of 200mm. If n = 0.011 and the total headloss from A to B 3.65m. determine Q by computing the equivalent length of 12in pipe.
find the total head and point (1+8) if the cross section of the system is 10cm knowing that k=0.5k=k
water from a reservoir flows at 0.85 m3/s through a rigid pipe 1200 mm diameter and completely stopped by a closure of a valve almost instantly. Bulk modulus of water is 2.20 x 109 N/m2. a) Find the water hammer pressure for sudden closure. b) Find the discharge if water hammer pressure is 700 KPa. c) If the time of closure of valve is 4 sec. and located at 650 mm from the reservoir, find the water hammer pressure at flow rate at 0.85 m3/s.
Water flows upwards through a venturi section. The venturi section varies indiameter from 15cm at the top and bottom to 5cm at the narrowest point. A differential pressuretransducer measured a pressure difference of 43kPa. Assuming steady flow, determine the velocity ofthe flow through the narrowest region and the discharge through the meter. Assume that water has adensity of 1g/cm 3 .b) The discharge through the venturi section
Given: As = 3m2 C = 0.92 Ao = 0.01m2 Find: Determine the time for the depth of liquid in the tank to be 0.8m
Water flows upwards through a venturi section. The venturi section varies indiameter from 15cm at the top and bottom to 5cm at the narrowest point. A differential pressuretransducer measured a pressure difference of 43kPa. Assuming steady flow, determine the velocity ofthe flow through the narrowest region and the discharge through the meter. Assume that water has adensity of 1g/cm 3 .c) Is the fluid pressure at the bottom of the venturi section greater than, less than, or equal to the fluidpressure at the narrowest region?