Q: 01/ Find the stoichiometric A/F ratio for the combustion of ethyl-alcohol (C2HSOH) in a petrol…
A: Introduction: The combustion products are mostly gaseous. When the steam is not included in the…
Q: Determination of AHf of NH4CI(s) & AH soln AHf of NH4CI(s) using your values of AH neut AHf of…
A: Please note that dissolution is an endothermic process. So, ∆Hsol should be 8.68 kJ/mol ( a positive…
Q: Explain the differences between the following calibration methods and why they are needed. a)…
A: Calibration is the method of configuring an instrument so that we can observed a result within an…
Q: Esall 0/50/ved its Volume (4L) His focusfooing Nagl from sodiumchloride it was related 3. by a daing…
A: Calculating the molarity of a diluted solution by using an equation given by dilution law: M1V1=M2V2…
Q: What is the value of Kw at 25 ∘C?
A: Ionic product of water:The ionic product of water (Kw) is depends on the concentration of H+ and OH-…
Q: A clinic had 25 patients on Friday morning. If 21 patientswere given flu shots, what percentage of…
A: In order to calculate the percentage of patients who received flu shots, the number of patients who…
Q: A pilot plant reactor was charged with 50 kg naphthalene and 200 kg (98% by wt) H2SO4. The reaction…
A: Complete analysis of the products can be obtained by calculating the mass formed of each product.
Q: [References] [Review Topics) N2(g) + 202(g)2NO2(g) Clear All >0 AHxn ASpxn = 0 AGxn > 0 low T, 0…
A:
Q: Data of Candy: Mass of candy: 6.1115g Concentration of NaOH (M): 0.09639 Volume of NaOH solution…
A:
Q: Using the percent purity calculations, determine the percent yield of synthesis of aspirin.…
A:
Q: Give the standard deviation of these three molaritys. 0.0366 0.0373 0.0370
A: Standard deviation: Standard deviation tell about the variability(error) in data set. If standard…
Q: Arrange the steps of gravimetric analysis in chronological order
A: Gravimetric analysis is a quantitative method of the measurement of the substance on basis of their…
Q: what is molarity, the average molarity, and standard deviation? igmsa H Titrations - Report Sheet…
A:
Q: In Fe + O2 --> Fe2O3 what is the coefficient for Fe?
A:
Q: 1) Mass of flask, aluminum foil, and rubber band 68.45g 2) Temp. Of boiling, water…
A:
Q: Value of (5) is equal ат JP/V ат aP/V ӘР ( ат у ӘР as V to....
A:
Q: The molarity of a solution is determined by four separate titrations or replicates, where the…
A: Given : Measurements: 0.4120 0.4920 0.3920 0.4320
Q: When ln(Ksp) is plotted vs 1/T(K), the graph has a y-intercept of 44.17. Calculate dS in units of…
A: According to the question, ln(Ksp) is plotted against 1/T. We know that: ∆G° = ∆H° - T∆S° ∆G° = -RT…
Q: Will a ppt of PBCO3 (s) form if you mix 30 mL of 1.3х 108 М РЫ(NO3)2 (aq) with 120 mL of 5.7 x 10-6…
A: Option (4) is the correct choice.
Q: Two different laboratories within a company further studied the morantel recovery percentage in…
A:
Q: wAte 0/20s of simitarites fer gfucase sufar Cattae?
A: "Since you have asked multiple questions, we will solve the first question for you ( as per our…
Q: What is the simplest CGS unit for "poise"?
A: Poise is the unit of viscosity. Poise itself is the CGS unit and it can be simplified as follows-
Q: 789mK/s to uK/ms. Express your answer in three significant figures.
A: Given : value in mk/s = 789
Q: If exactly 200.0 mL of an aqueous solution that is 1.037E3 ppb Pb(NO3)2 (331.2 g/mol) is mixed with…
A: 1 ppb = 1 ug / L 1 mL = 10^-3 L 1 femto (f) = 10^-15
Q: could you please explain theses datas and graph for the synthesis and spectrophotemetric analysis of…
A: Interpretation: To explain the data of the graph and and spectrophotometric analysis of aspirin.
Q: 4. A student performs the HCl tests on the three solid samples as described in Step 5 of Part B and…
A: Explanation:Upon being heated, some substances undergo chemical changes, some undergo physical…
Q: Distribution Coefficient - Please help write conclusions based on results provided. Thank You!
A: The mass of acid in ethyl acetate after single extraction = 0.1072 g And, the mass of acid in ethyl…
Q: Determine the percentage Fe in a sample of limonite from the following data: -Sample : 0.5000g…
A: Percentage composition simply it means amount of element present relative to total amount of…
Q: 4AI203 + 3CH4→ 8AI + 3CO2 + 6H20 AH° rxn kJ exo ? endo thermic AH° = -1676 -75 -394 -242 kJ/mol…
A:
Q: Prepare 100ppm of Cd (NO3).4 H2O in a 1 Liter
A: In the question, we will prepared the Cd(NO3). 4H2O in a 1 Liter volume. You can see detail…
Q: WATCH THIS TWO MINUTE VIDEO TO SOLVE…
A: A multiple choice question based on theoretical yield, which is to be accomplished.
Q: lease use excel to calculate Fe analysis by ICPMS. 1') Generate a standard curve 2') calculate the…
A:
Q: QUESTION 8 Were the sample prep and the standard prep supplemented with the same amount of internal…
A: An internal standard in analytical chemistry is the substance similar to the unknown sample that is…
Q: Data of Candy Mass of candy: 6.1115g Concentration of NaOH (M): 0.09639 Volume of NaOH solution…
A: The acid-base titrations such as sodium hydroxide versus hydrochloric acid can be used to determine…
Q: A student performed the experiment described in this module, using 5.00 mL of a 3.2% H2O2 solution…
A: To calculate the percentage error, we need to find the gas constant (R) value obtained from the…
Q: Consider the calcination of CaCO;: CaCO3 -> CaQ + CO2 Before calcination, the initial weight of…
A: The reaction is process by the reaction between two or more reactant to each other. The mass of each…
Q: Average AG°= 43,42 AH°= . AS°= (Note: the slope of the best fit line is equal to -AS° rather than…
A: Given data:
Q: In an analysis of the content of carbohydrate present in a glycoprotein, the following results were…
A: Given that, in an analysis of the content of carbohydrate present in a glycoprotein, the results…
Q: q (joules) AH (ki/mol) RUN REAGENT MASS/VOLUME TI It AT 24.82°C 0.1100 g 100 ml 19.20°C Mg HCI…
A: Mass = Volume × Density Amount of Charge (q) = Mass × Specific heat capacity × temperature change…
Q: 5) Write the standard for
A:
Q: 9. The concentration of a solution (in ppb) was measured several times, resulting in the following…
A: Given : Concentration in ppb 7.45 8.49 6.91 7.32 The Accepted value for the…
Q: When bromoform (d=2.89 g/ml) and water ( d=1 g/ml) are mixed, two layers form. Is the bottom layer…
A: Given: Density of bromoform = 2.89 g/mL. And the density of water = 1 g/mL.
Q: A student performed the experiment described in this module, using 7.00 mL of a 1.8% H2O2 solution…
A: First calculating the H2O2: 1.8% H2O2 solution means 1.8 g H2O2 in 100 ml of watermass in 7 ml = 1.8…
Q: A commercial cola brand states that the cola contains 45 mg phosphorus per 250 mL serving. Calculate…
A:
Q: Consider the following information. 2 H2S(g) +3 O2(g) → 2 SO2(g) + 2 H₂O(g) H2S(g) 02(g) 205.2…
A:
Q: 2- Heat Decomposition mass Curve of sample S with mass 20.00 mg is shown below. Study the TGA…
A: TGA stands for thermogravimetric analysis or thermal gravimetric analysis. It is an analytical…
Q: What is the capital cost of a plant that produces 250,000 tons per year of ethanol (fuel grade)…
A: Ans) $ 149.89 M
Q: An excess of 0.34 mg Pb is obtained from an assay test determined in an analysis. What is the…
A:
Q: qualitative and quantitative analysis?
A: Ans. Sodium chloride can be analysed by various analysis techniques: Flame photometry is an atomic…
(9.29 × 105/8)-20.81 =
with correct sig figs
Step by step
Solved in 2 steps
- How would each of the following errors affect the determination of the molar mass of the unknown (Increase/Decrease/No effect)? a. Thermometer reads 2.0o higher than the true temperature. b. Some of the t-butanol was unknowingly spilled after it had been weighed but before the solute was added. 3. A student accidentally added acetylsalicylic acid (MW = 180.157 g/mol) rather than salicylic acid (MW = 138.121 g/mol), if no other mistakes were made, how would this error affect the determined molal freezing point depression constant for t-butyl alcohol (Kf)? 4. Based on the Tf and Kf you determined for t-butyl alcohol, predict the freezing point of a t-butyl alcohol solution containing 0.530 m NaCl. Assume 1.9 is the van’t Hoff factor for NaCl in t-butyl alcohol. Show your work.What is the simplest CGS unit for "poise"?Table 5.5 (data)ObservationsSample Tested Add HCISolid CaCO 3 _______Solid CuSo 4 _______Mixture _______Filtrate _______Solid fromfunnel _______
- If exactly 200.0 mL of an aqueous solution that is 1.037E3 ppb Pb(NO3)2 (331.2 g/mol) is mixed with 100.0 mL of an aqueous solution that is 3.090E9 fM KI (166.00 g/mol), how many micrograms of solid PbI2 (461.01 g/mol, 6.16 g/mL) are formed? Assume complete reaction.1-Calculate the distribution of 6 particles over two chambers? 2- Calculate the distribution of 8 particles over two chambers?You take a representative soil sample and determine the following data: Exchangeable cation cmolc/kg of soil Ca2+ 2.7 Mg2+ 1.0 K+ 0.1 H+ 1.0 Al3+ 2.8 Na+ 0.1 1) What is the CEC (cmolc/kg ) of this soil?
- Using the percent purity calculations, determine the percent yield of synthesis of aspirin. Part I Synthesis of Aspirin Mass of salicylic acid used (g) 2.029g Volume of acetic anhydride used (mL) 5ml Mass of acetic anhydride used (vol. × 1.08 g/mL) 5.4g Mass of aspirin synthesized (g) 3.256g Part II Melting Temperature Data Melting temperature (°C) 133°C Part III Salicylic Acid Standard Stock Solution Initial mass of salicylic acid (g) 0.210g Moles of salicylic acid (mol) 0.0147 mol Initial molarity of salicylic acid (M) 0.724 M Part III Beer’s Law Data for Salicylic Acid Standard Solutions Trial Concentration (M) Absorbance Water (mL) 1 10 0.301 0 2 7.5 0.219 2.5 3 5.0 0.163 5.0 4 2.5 0.074 7.5 Best-fit line equation for the salicylic acid standards Test of the Purity of the Synthesized Aspirin Initial mass of aliquot of product (g)…Aleks data for AgBrO3 is 5.38 x 10^-5If an instrument gives a response of 1240 for a standard containing 8 ppm of a substance, how much if this substance is in a sample that gives a response of 1705? Are any assumptions needed?
- 5.00 mL of stock solution is diluted to 25.00 mL, producing solution ALPHA. 10.00 mL of solution ALPHA is diluted to 25.00 mL, resulting in solution BETA. 10.00 mL of solution BETA is then diluted to 25.00 mL, producing solution GAMMA. dilution factor for ALPHA from stock solution = 0.167 dilution factor for BETA from ALPHA solution = 0.0476 part c and d?Why do we plot mV vs. log[Cl-] instead of mV vs. [Cl-]? What would the mV vs. [Cl-] graph look like?2 CoCl2(aq) + 8 NH3(aq) + H2O2(aq) + 2 NH4Cl(aq) 2 [Co(NH3)5Cl]Cl2(s) + 2 H2O(l) In a 50-mL Erlenmeyer flask, cobalt(II) chloride hexahydrate (1.075 g), an aqueous solution of ammonia (1.2 mL, 15 M), ammonium chloride (0.505 g), and hydrogen peroxide (1.0 mL, 30.0% (w/w), density = 1.10 g/mL) were combined. After completion of the reaction, [Co(NH3)5Cl]Cl2 (0.450 g) was isolated. What was the percent yield of the product?