Answered: A 0.11 kg ball is about to roll off the…

A 0.11 kg ball is about to roll off the edge of a 12.51 m high table. What is its current PE? No unit is required for the final answer. Round your answer to 2 decimal places.

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 80A

See similar textbooks

Related questions

Q: A child is riding their bicycle. The rear wheel is spinning at an angular velocity of 187.389 rpm…

A: The initial angular velocity of a rear-wheel is, ωi=187.389 rpm=187.389×2π60 rad/s=19.623 rad/s The…

Q: A typical small rescue helicopter has four blades: Each blade is 4.00 m long and has a mass of 50.0…

A: Introduction: Moment of inertia (I) = mass ×distance 2…

Q: help Find the height a rolling bowling ball that has a mass of 8 kg and a radius of 0.14 m moving…

Q: 100 lb A 80 lb 80 lb Figure 1 100 lb 100 lb 200 lb

A: Given,

Q: A disc has a speed of 1300 rpm and it is made to slow down at a uniform rate of 3 rad/s2.Calculate…

A: We use the equation of angular motion that is similar to the equations of linear motion.…

Q: A light, rigid rod is 68.5 cm long. Its top end is pivoted on a frictionless horizontal axle. The…

A: If the ball is at the top of the circle, its velocity is zero and the kinetic energy is changed into…

Q: A bicycle with tires 50 cm in diameter travels 4.4 km How many revolutions do the wheels make?

A: Given data: The diameter of the bicycle tire, D=50 cm. The distance traveled by the tire, S=4.4 km.…

Q: 5) A meter stick balances at the 50cm mark. If a mass of 100 g is placed at the 20cm mark, the stick…

A: The x-axis is along with the meter stick, with the origin at the zero position on the scale. The…

Q: A light, rigid rod is 75.5 cm long. Its top end is pivoted on a frictionless horizontal axle. The…

A: Given, Length of rigid rod=75.5 cm Let speed at the lowest point is Ui m/s

Q: The hand on a circular spinner is 2 inches long. The spinner is divided into 8 equal sections. What…

A: For small angle approximation,∆θ=∆sr

Q: A ball with an initial velocity of 5.17 m/s rolls up a hill without slipping. (a) Treating the ball…

Q: An electric motor is spinning at a rate of 60 rpm It then slows down with a constant angular…

Q: 3) A 200 g mass is placed on the meter stick 20 cm from the fulcrum. An unknown mass is positioned 8…

A: Given data: The mass of right side of fulcrum is M=200 g. The distance from fulcrum is r=20 cm. The…

Q: Replace the force system by a resultant force and couple moment at point O. 500 N 3 750 N 200 N 1m…

A: Along x Fx= -200+200+500(3/5)= 300N Fy= -750+500(4/5) = -350 N

Q: Casting of molten metal is important in many industrial processes.Centrifugal casting is used for…

A: Step 1 The centripetal acceleration is given as Let f be the rotational rate.Each revolution carries…

Q: You are on a Ferris Wheel that spins at 2.4 rpm. The ride is 29 m across. What is your apparent…

A: Calculate the radius of the wheel.

Q: Four graphs of angular velocity versus time are shown. (a) (b) (c) (d) grid cell has width 1 s and…

A: Angular displacement is area under the graph angular velocity versus time . Width of each cell is 1s…

Q: An energetic father stands at the summit of a conical hill as he spins his 24 kg child around on a…

Q: A tire is spinning with an angular velocity of 190.005 rpm. Suddenly, brakes are applied and the…

A: Given data The initial angular velocity of the tire is Ni=190.005 rpm The time taken to stop is t =…

Q: The figure shows a popular ride in an amusement park. A vehicle at end of a long rotating arms moves…

Q: A 2.8-m-diameter merry-go-round with a mass of 240 kg is spinning at 20 rpm. John runs around the…

A: Given data as per question D = 2.8m m = 240kg N = 20rpm v = 5m/s

Q: Torque is defined as Select one: a.mass times acceleration. b.force times lever arm. c.mass times…

Q: A 200 g puck revolves in a circle on a frictionless table at the end of a 50.0 cm long string. The…

A: Consider the mass of the puck be m, the angular momentum of the puck be L, the radius of the circle…

Q: A rod of length 1.21 m and mass 4.3 kg can freely rotate around uppermost point (see Fig). A bullet…

A: According to question--- Given data-- length of road L = 1.21 m. mass of road = 4.3 kg. mass of…

Q: Ã = (5 m/s)î + (2 m/s)j, B = (3 kg · m/s²)î + (2 kg · m/s²)I %3D

Q: the moment of inertia.

Q: a. b. C. d. 524 lb_ m hr 2.72 × 108 1.89 × 106 9.44 × 104 lb. m hr lb m hr lb. m hr

Q: A 1 kg rock is suspended from the tip of a horizontal meter stick at the 0 cm mark so that the meter…

A: The mass of the rock suspended from the tip of the horizontal meter stick at the x0 = 0 cm, m = 1…

Q: 3) Determine the moment of force on the pin where force is being applied. Make sure to leave your…

Q: The moment of inertia

Q: You install new tires on your car that are rated to last for 60,000 miles .how many revolutions will…

Q: A desk fan has blades of 4 inches rotates at a rate of 249 revolutions per minute. A. Find the…

A: Given data: Length of blades = 4 inches Angular velocity (ω) = 249 revolutions per minute Required:…

Q: A Ferris wheel is a vertical, circular amusement ride with radius 8.0 m. Riders sit on seats that…

A: From equation (2) and (3) we can find the rate of change of momentum:…

Q: A 500 g steel block rotates on a steel table while attached to a 2.0 m long massless rod. Compressed…

A: Given,

Q: Three children are riding on the edge of a merry-go-round that is 102 kg, has a 1.60 m radius, and…

Q: A 5kg object is hanging by a 1.5m wire when it is suddenly hit by a 3kg missile traveling…

Q: A 5.0 g coin is placed 15 cm from the center of a turntable. The coin has static and kinetic…

A: The expression centrifugal force, F=mω2rF=0.005×(2π)2×0.15F=0.0296N

Q: using this tool from…

A: The masses to be balanced net torque about any point in the space must be zero. Write the formula…

Q: A 1.5 kg block and a 2.5 kg block are attached to opposite ends of a light rope. The rope hangs over…

A: Given: The mass of block 1 is m1=1.5 kg. The mass of block 2 is m2=2.5 kg. The mass of pulley is…

Q: The angular speed of minute hand in a clock is a. 0.05233 rad/s b. 0.10466 rad/s c. 0.00087…

A: Angular velocity of the body is the rate of change of angular displacement. ω = dθ/dt Where, ω =…

Q: A carousel with a 40-foot diameter makes 5 revolutions per minute. (a) Find the angular speed of the…

A: Given data: Diameter (d) = 40 foot Angular speed = 5 revolutions per minute

Q: 2.0 kg 10 kg r3.0 m r1.0 m For the seesaw depicted in the diagram, which of the following will…

Q: 9. Doja sits on the outer part of a carousel, and Megan sits midway between the center and the rim.…

Q: The distance between the centers of the wheels of a motorcycle is 155 cm. The center of mass of the…

A: Distance between the centers of the wheel: d=155 cm Distance of center of mass from the rear wheel:…

Q: Two masses of 5kg and 15kg are connected to a pulley as shown in adjacent figure. what will be the…

A: Option b is correct.

Q: A 2.2 kg , 20-cm-diameter turntable rotates at 150 rpm on frictionless bearings. Two 470 g blocks…

Q: The mechanism shown in the figure (Figure 1) is used to raise a crate of supplies from a ship's…

A: Given:Mass of the crate,m=64kgThe radius,r=0.33 mMoment of inertia,I=2.2 kg.m2Radius of the vertical…

Q: Time for 20 Number of Mass of Washers Trial (kg) Weight of Washers (N) revolutions Period (seconds)…

A: Required : Weight of the washers.

Question

A 0.11 kg ball is about to roll off the edge of a 12.51 m high table. What is its current PE? No unit is required for the final answer. Round your answer to 2 decimal places.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

The masses below are situated along a line ; consecutive objects are separated by 1 m. Find the system's center of mass, measured from the far-left mass. Find the system's rotational inertia about an axis perpendicular to the page passing through the 35 g mass.
The m = 500 gg mass in (Figure 1) is pushed across the 2.0-m-long cart of mass 2.5 kg by a 3.0 N force, starting at the left side. The coefficient of kinetic friction between the mass and the cart is 0.40. The cart's coefficient of rolling friction is 0.020. How far has the cart rolled when the mass falls off the right side?
A 2.5 kg, 20-cm-diameter turntable rotates at 100 rpm on frictionless bearings. Two 540 g blocks fall from above, hit the turntable simultaneously at opposite ends of a diameter, and stick. What is the turntable's angular velocity, in rpm, just after this event?
A 2.0 kg, 20-cm-diameter turntable rotates at 100 rpm on frictionless bearings. Two 500 g blocks fall from above, hit the turntable simultaneously at opposite ends of a diagonal, and stick. What is the turntable’s angular speed, in rpm, just after this event?
Torque is the rational analog of a. Acceleration b. Force c. Kinetic Energy d. Linear Momentum
A hoop rolls down a 4.25 m high hill without slipping. -What is the final speed of the hoop, in meters per second?
In the game of tetherball a rope with length ?=1.50 m connects a ball with mass ?=0.750 kg to the top of a vertical pole so that the ball can spin around the pole as shown in the figure. What is the speed ? of the ball as it rotates around the pole when the angle ? of the rope is 38.0∘ with the vertical?
Angular momentum is conserved in the absence of which of the following? (3.7) (a) inertia (b) gravity (c) a net torque (d) linear momentum
A ride at a carnival has four spokes to which pods are attached that can hold two people. The spokes are each 15 m long and are attached to a central axis. Each spoke has mass 200.0 kg, and the pods each have mass 100.0 kg. If the ride spins at 0.2 rev/s with each pod containing two 50.0-kg children, what is the new spin rate if all the children jump off the ride?
Today, waterwheels are not often used to grind food. Instead, we have electrical devices such as blenders, choppers, and mixers. The electric motors in these devices are similar to a waterwheel, but instead of falling water causing the wheel to spin,electricity causes a shaft to spin. The specifications on a particular electric motor reports that at 1.75 103 rpm, it puts out5 hp. What is the corresponding torque in N m?
. A loaded gun is dropped on a frozen lake. The gun fires, with the bullet going horizontally in one direction and the gun sliding on the ice in the other direction. The bullet’s mass is 0.02 kg, and its speed is 300 m/s. If the gun’s mass is 1.2 kg, what is its speed?
Casting of molten metal is important in many industrial processes. Centrifugal casting is used for manufacturing pipes, bearings, and many other structures. A cylindrical enclosure is rotated rapidly and steadily about a horizontal axis, as in Figure P7.62. Molten metal is poured into the rotating cylinder and then cooled, forming the finished product. Turning the cylinder at a high rotation rate forces the solidifying metal strongly to the outside. Any bubbles are displaced toward the axis so that unwanted voids will not be present in the casting. Suppose a copper sleeve of inner radius 2.10 cm and outer radius 2.20 cm is to be cast. To eliminate bubbles and give high structural integrity, the centripetal acceleration of each bit of metal should be 100g. What rate of rotation is required? State the answer in revolutions per minute. Figure P7.62