A 0.54 kg toy car is loaded into a spring launcher that is compressed 2 cm. The spring has a spring constant of 860 N/m. What was its initial velocity when it was released by the spring, in m/s?

Q: 1. A baseball player slides into third base with an initial speed of 4.0 m/s. If the coefficient of…

A:

Q: 2. A diverging lens has a focal length that has a magnitude of 34.0 cm. An object is placed 15.5 cm…

A:

Q: A horizontal spring with spring constant 250 N/m is compressed by 15 cm and then used to launch a…

A:

Q: Can this equation be used to find the same solution to the question?

A: Yes , this equation will be used to solve the given problem.  For your simplicity---  Mass , m = 1.3…

Q: Calculate the work done by the force of gravity when a 7.0 kg object is lifted to a height of 46.0 m…

A:

Q: The (non-conservative) force propelling a 1.90 x 10³-kg car up a mountain road does 8.00 x 106 J of…

A: We are given the work done by propelling force. By work energy theorem, the total work done by non…

Q: Water flows out of a spigot at the bottom of a very wide storage tank at a velocity of 10.4 m/s?…

A:

Q: Calculate the standard heat of formation of solid W0, from solid Wand 0₂ gas at 25°C (98 K) and 1…

A: Below I have provided the solution of the given question

Q: 1. The magnetic field inside a 150-turn solenoid 12.56 mm long that carries a 20-A current is (a)…

A: Given data: Number of turns (N) = 150 Length (L) = 12.56 mm = 12.56×10-3 m Current (I) = 20 A…

Q: The diagram below shows two concentric, conducting, circular loops with currents traveling in…

A:

Q: Subpart 3: Set up Newton's Second Law in the x-direction when the ice block is accelerating to the…

A:

Q: A motorcycle daredevil plans to ride up a 2.85 m high 29.0° ramp, sail across a 10-m-wide pool…

A: Given:  Ramp height = h = 2.85 m Inclination angle of the ramp = θ = 29 degrees width of the pool =…

Q: How many turns of a coil are necessary to produce a 0.25-T magnetic field inside a 50-cm-long…

A: Given data:  Magnetic field (B) = 0.25 T Length (L) = 50 cm = 0.50 m Current (I) = 20 A Required:…

Q: How much work is required to lift a 6.9-kg backpack 1.9 m to put it on?

A: mass(m)=6.9 kg displacement(d)=1.9 m g =acceleration due to gravity=9.80 m/s2

Q: A baseball (m = 147 g) approaches a bat horizontally at a speed of 40.7 m/s (91.1 mi/h) and is hit…

A: Given Mass of the base ball is m=147 g=147×10-3 g Initial speed of the baseball is vi=40.7 m/s Final…

Q: . Pulling up on a rope, you lift a 4.35-kg bucket of water from a well with an acceleration of 1.78…

A:

Q: 2. A ball is kicked upward with an initial velocity of 20m/s from the roof of a building 30 m high.…

A:

Q: If R is the distance from a magnetic dipole, then the magnetic field it produces is proportional to:…

A: Given R is the distance from magnetic dipole We have to find the relation between magnetic field and…

Q: a) Find E for 84P20 Հ show all Gaussiaan surfaces 92² b) Plot E vs r c) Find charges on the surfaces…

A:

Q: Compare the strain energy stored in the following: a) A tendon that is stretched 5 mm if the…

A:

Q: 4. What is the mass of a solid copper ball that has a radius of 7.0 cm?

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A car is travelling up a hill that is inclined at an angle ? above the horizontal. Determine the…

A: a)0.9659 b)0.819

Q: What is the expected reading on the ammeter and voltmeter? (Ignore voltmeter when you use Kirchhoff,…

A:

Q: Ms Q R Mp (b) How do the tangential speeds of planets B and C compare to that of Planet A? In a…

A: Given:  Three planet star systems:

Q: Use the following information for next TWO (2) questions. 3. P OA. 1.9µT OB. 2.8μT OC. 3.7µT D.…

A:

Q: B. Solve the problems related to the application of First Order Differential Equations. 1.…

A: First order differential equation: An equation with the formula F(t, y, y)=0 is referred to as a…

Q: This is an displacement-time (x-t) graph of a SHM. A O X T 27 -A For A = 4.5cm and T = 1.5s find the…

A:

Q: Two springs, with force constants k, and key, are connected in series, as shown in the figure…

A:

Q: O Free-body diagrams for four situations are shown below. The net force is known for each situation.…

A:

Q: (8') Show your answers in the following figures. You use words to explain your answers clearly. Two…

A:

Q: A stone is thrown upward at an angle of 36 with the horizontal, It lands 70 m measured horizontally…

A:

Q: Carts A and B in Figure 1 have 5 kg and 10 kg masses, respectively. A force of F = 50 N is applied…

A: Given data:  Mass of object A (mA) = 5 kg Mass of object B (mB) = 10 kg Force (F) = 50 N Required:…

Q: (a) Write down the formulas for the velocity v and for the positions of the car. You may assume that…

A: Given So=0 (initial position of car ) u=55km/h=55×518=15.28 m/s (initial velocity of car before…

Q: Two buckets of sand hang from opposite ends of a rope that passes over an ideal pulley. One bucket…

A: weight heavy bucket = 120 N weight of lighter bucket = 63 N

Q: Two baton twirlers spin identical batons. Twirler A spins their baton around one of its ends.…

A:

Q: Two ice cubes are placed in a cup, and the cup is filled to the rim with water. As the ice cubes…

A:

Q: Pressure cookers have been around for more than 300 years, although their use has strongly declined…

A:

Q: 3. A spring of constant k, compressed a distance x, is used to launch a mass m up a frictionless…

A:

Q: When a 9.09-kg mass is placed on top of a vertical spring, the spring compresses 4.18 cm. Find the…

A: We have, mg = kx therefore, k = mg/x k = (9.09x9.8)/(0.0418) k = 2131 N/m

Q: 4. An object 5.0 cm tall is 26.0 cm from a concave lens. The resulting image is one-fifth as large…

A:

Q: oes around a curve on a road that is banked at an angle of 33.5°. Even though the road is slick,…

A:

Q: Match the description of a process with the corresponding arrow in a. Absorption of a photon whose…

A:

Q: The drawing shows light incident on a polarizer whose transmission axis is parallel to the z axis.…

A:

Q: Are all the following statements is/are true about friction? a. Static friction is always greater…

A:

Q: The Sun is powered by releasing hydrogen to helium. Through either the proton-proton chain or the…

A:

Q: A uranium-238 nucleus undergoes a radioactive decay, 238 U 234Th + 4He. The masses are approximately…

A: A uranium-238 nucleus undergoes a radioactive decay, 238U --> 234Th + 4He The masses are…

Q: One of the nuclides in spent nuclear fuel is U-235, an alpha emitter with a half-life of 703 million…

A: Given T=703 million years (half life) The decay constant is given by  λ=0.693T=0.693703=9.86×10-4…

Q: What is the sum of the following four vectors: a. In unit vector notation b. as a magnitude and an…

A: The vectors are given as: A→=(3 m)i+(5 m)jB→=[(3 m)cos178°]i+[(3 m)sin178°]j=(−2.998 m)i+(0.1047…

Q: Consider a horizontal spinning disc of radius R=4.7m. A ball of mass m=4.93kg and negligible size is…

A:

Q: An aluminum calorimeter with a mass of 100 g contains 250 g of water. The calorimeter and water are…

A:

Spring Potential Energy

The potential energy is the energy possessed by a body by virtue of its position or the energy held by the object due to its position relative to other objects, its force like stresses, charge, and other factors affecting the particles of the body. The potential energy is the measure of the net work done by or on the body. The spring potential energy is the potential energy stored due to the deformation of an elastic spring and this elasticity is due to the stretched spring. The elasticity is the ability of a solid-state matter to come back to its equilibrium position or original position after any kind of external force is acted on it. It is also known as Elastic potential energy. The potential energy here is caused due to the displacement of the spring from its equilibrium position to another position and this potential energy is equal to the net work done due to the stretching of the spring. It also resembles the same mechanics of the oscillation of a simple pendulum, where due to the external force, the object moves from its equilibrium position to its maximum ends and the periodic motion continues till it comes back to the equilibrium position to rest.