A 1 kg block B is moving with a speed of 2.55 m/s as it strikes the 0.3 kg sphere A which was at rest. If the coefficient of friction between the block and the floor is p = 0.2 and the speed of the sphere was 1.54 m/s immediately after impact, compute the distance (m) travelled by the block. Round off only on the final answer expressed in 3 decimal places. momentum.png ...

A 1 kg block B is moving with a speed of 2.55 m/s as it strikes the 0.3 kg sphere A which was at rest. If the coefficient of friction between the block and the floor is p = 0.2 and the speed of the sphere was 1.54 m/s immediately after impact, compute the distance (m) travelled by the block. Round off only on the final answer expressed in 3 decimal places. momentum.png ...

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 1.19 kg block B is moving with a speed of 3.38 m/s as it strikes the 0.46 kg sphere A which was at rest. If the coefficient of friction between the block and the floor is μ = 0.26 and the speed of the sphere was 1.51 m/s immediately after impact, compute the time (s) it takes for the block to stop. Round off only on the final answer expressed in 3 decimal places.
Application of de A motorboat and its load weigh 2,450 N. AssumIng that the propeller force is constant and equal to 120 N, and water resistance is equal numerically to 7.50v N, where v is the speed at any instant in m/sec., and if the boat starts from rest, determine the speed and the distance traveled at the end of 10 seconds.
If a ball is dropped from a height of 5 feet, determine velocity of the ball just before impact with the ground. Let positive y be upward, so the ball will have negative velocity. Provide your answer in ft/sec, but do not include units in your submittal.
The 50 lb crate is given a speed of 10 ft/s in t = 4 s starting from rest. If the acceleration is constant, determine the power that must be supplied to the motor when t = 2 s. The motor has an efficiency 1 =0.65. Neglect the mass of the pulley and cable. Determine the power that must be supplied to the motor when t=2 s . Express your answer in units of horsepower to three significant figures. Should correct (gpt/ai wrong answer not allowed)
A jogger with mass m = 55 kg uses energy at a rate of P = 802 W when she jogs on horizontal ground at a constant speed of s = 3.5 m/s. The efficiency of her “human engine” however, is e = 0.27. (In other words, the power used for locomotion is e = 0.27 times the total power.) Q) Write an expression for the rate of energy expenditure whenshe jogs at the same constant speed up a slope of 4.99 degrees. Assume whatever frictional or drag forces are the same in each case. Your answer should be in terms of the symbols given in the problem statement and g(9.80 m/s^2)
Part A: If they are sliding on a smooth horizontal plane with the velocities shown, determine their speeds just after impact. The coefficient of restitution between them is e = 0.8. Enter your answers in meters per second to three significant figures separated by a comma.
A box is released from rest at the position shown. Determine its speed (m/s) after traveling 1.3m along the 41.4ᴼ inclined surface if the coefficient of kinetic friction between the box and the surface is 0.2. Round off only on the final answer expressed in 3 decimal places.
A student pilot taxiing a Cessna 172 - Skyhawk is brought to a full stop with a total distance of four hundred fifty meters from a speed of 21 knots. (a)Determine the frictional energy absorbed by the breaks. (b) Consider that the stopping force is brought by a constant force resisting the motion, what is the force? Note: The kinetic energy of rotation of the wheel is negligible. Given: mpilot = 170lbs mairplane = 757 kg
Two blocks A and B of the same mass 0.92 kg are released from rest on a 29° incline when they are S = 18.5 m apart, as shown. The coefficient of friction under the upper block A is 0.22, and that under the lower block B is 0.38. Compute the elapsed time (in seconds) until the blocks touch each other. Round off only on the final answer expressed in 3 decimal places.
Assume that b=0.22m and that the coefficient of kinetic friction between the rope and the inclined surface is μk=0.47. Let y (in metres) be the distance travelled by the rope after it has been released from rest.
The carnival ride from Prob. 12.51 is modified so that the 80-kg riders can move up and down the inclined wall as the speed of the ride increases. Assuming that the friction between the wall and the carriage is negligible, determine the position h of the rider if the speed v0 = 13 m/s.Reference to Problem 12.51:
A 42-lb suitcase slides from the rest 20 ft down the ramp. The suitcase has an initial velocity down the ramp of v_A = 7 ft/sft/s and the coefficient of kinetic friction along AB is μk = 0.19. (Figure 1) (a) How long does it take to go from A to C? Express your answer to three significant figures and include the appropriate units. The answer is not 1.561 seconds.