Answered: A 1.00 farad capacitor is charged to…

A 1.00 farad capacitor is charged to 10.0 volts. At time t=0.000 the capacitor is connected to a 1.00 ohm resistor. At what time t does the capacitor reach 1.00 volt? Answer in seconds.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 68PE: A 500- resistor, an uncharged 1.50-F capacitor and a 6.16-V emf are connected in series, (a) What is...

See similar textbooks

Related questions

Q: A capacitor of capacitance 5.0×10-6 F is discharging through a 4.0-MΩ resistor. At what time will…

A: Energy stored in a capacitor at time t in terms of the initial energy stored

Q: A 2.00-nF capacitor with an initial charge of 5.14 pC is discharged through a 2.29-ki2 resistor. (a)…

A: GivenC=2 nF=2×10-9 FInitial charge, Q=5.14 μC=5.14×10-6 CResistance , R=2.29 k ohm

Q: Suppose R = 150 0 and C = 40_µF in a (charging) RC-series circuit with a 8 V power source. What is…

A: Resistance (R)= 150 ohm Capacitance (C) = 40μF Voltage of the battery (V) = 8 volts

Q: () THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN HERE, R2 www The emf source, E = 3.4…

A: Time constant in RC circuit, τ = ReqCeq Req is equivalent resistance Ceq is equivalent capacitance…

Q: The figure below shows a capacitor, with capacitance C = 35.0 µF, and a resistor, with resistance R,…

Q: A charged capacitor is connected to a resistor and a switch as in the figure below. The circuit has…

A: Given that The time constant of the circuit is (T) = 2.5s The charge on the…

Q: If 480 C pass through a 4.0- resistor in 10 min, what is the potential difference across the…

Q: A voltage spike causes the line voltage in a home to jump rapidly from 110. V to 150. V. What is the…

Q: "In the experiment to measure the capacitance (C) of a capacitor, the capacitance comes out to be…

Q: ne Which of the following resistors, when placed in series with a fully charged 5 mF capacitor,…

A: Given, A fully charged 5 mF capacitor connected in series with resistor. Time constant for…

Q: A 100 resistor and an initially empty 20 uF capacitor are connected in series and connected to a 6 V…

Q: A capacitor with an initial potential difference of 100 V is discharged through a resistor when a…

Q: Switch S in in the figure is closed at time t = 0, to begin charging an initially uncharged ca…

A: GivenC=17.9μFR=22.8Ω

Q: You connect a battery, resistor, and capacitor as in (Figure 1), where E = 46.0 V, C = 5.00 μF, and…

A: Given: Battery voltage E = 46.0 V Capacitance C = 5.0 µF Resistance R = 130 Ω

Q: An uncharged capacitor and a resistor are connected in series to a source of emf. If e = 9.00 V, C =…

Q: An uncharged capacitor and a resistor are connected in series to a source of emf. If E = 11.0 V, C =…

Q: a 1.0 MQ resistor was connected in series with a capacitor. The voltage across the capacitor was…

Q: A capacitor that is initially uncharged is connected in series with a resistor and a 700.0 V emf…

Q: circuit has a resistor of 1.4MΩ and a capacitor with a capacitance of 1.8µF hooked up in series with…

Q: A 14.5-μF capacitor is charged to a potential of 40.0 V and then discharged through a 65.0 Ω…

A: Given: C = 14.5 μF = 14.5*10-6 FV = 40.0 VR = 65.0 Ω

Q: A series RC circuit consists of a resistor, a capacitor that is initially uncharged, a battery, and…

A: We know that we have given an RC circuit in which the resistance and capacitor are in the series,…

Q: An electronic flashgun has a capacitor with capacitance C that is charged to a voltage V. Answer the…

A: Capacitance, C = 1441 μF Voltage,V = 317 V Time, t= 0.0032 s

Q: 1. Consider an RC curcuit shown in Figure 1 of charging capacitor given with time constant T=RC=0.05…

Q: R C 3. From the figure above, a switch is closed at time t = 0, allowing the capacitor to begin…

Q: At time t = 0, an RC circuit consists of a 20.0-V emf device, a 50.0-N resistor, and a 146.0-µF…

A: The time constant for a series RC circuit is defined as the product of resistance and capacitance…

Q: What value resistor will discharge a 2.90 μF capacitor to 20.0% of its initial charge in 2.60 ms?

A: Formula for the discharging of a capacitor is:

Q: The figure below shows a capacitor, with capacitance C = 7.22 PF, and a resistor, with resistance R…

Q: The duration of a photographic flash is related to an RC time constant, which is 0.110 us for a…

Q: A 1.0 μF capacitor is being charged by a 9.0 V battery through a 10 MΩ resistor. (A) Determine the…

A: The equation for voltage versus time when charging a capacitor C through a resistor R, is given by…

Q: "In the experiment to measure the capacitance (C) of a capacitor, the capacitance comes out to be…

Q: An uncharged capacitor and a resistor are connected in series to a source of emf. If Ɛ = 7.00 V, C =…

A: Given data: Emf of the source, ε=7.00 V Capacitance, C=25.0 μF = 25×10-6 F Resistance, R=100 Ω (a)…

Q: A resistor with value 2-ohm is connected in series with a capacitor that has a capacitance rating of…

Q: A 20.0 microF capacitor and a 180 Ohm resistor are connected in series. The capacitor is initially…

A: The capacitance of the capacitor is C = 20μF. The resistance of the resistor is R = 18Ω. The voltage…

Q: A 2.00-nF capacitor with an initial charge of 4.28 µC is discharged through a 2.72-kΩ resistor. (a)…

Q: A 400 µF capacitor is connected through a resistor to a battery. Find (a) the resistance R and (b)…

A: Given value--- capacitance = 400 micro F. time = 0.5 sec. charge = 0.024 C. We have to find---…

Q: You connect a battery, resistor, and a capacitor as in figure 1, where R= 15.0 ohms and C=…

A: Given data The resistance is given as R=17 Ω. The capacitance is given as C = 5 x 10-6 F. The…

Q: !) THE FOLLOWING QUESTIONS ARE BASED ON THE NFORMATION GIVEN HERE. R2 The emf source, E = 4.4 V, of…

A: Equivalent resistance , as they are connected in parallel when viewing from capacitor side…

Q: 1) In the RC circuit, when a resistor R=100 M2 is connected to a fully charged capacitor C= 1µF ,…

A: Resistance, R=100 MΩ = 100×106 Ω Capacitance, C=1μF=1×10-6 F

Q: The given pair of capacitors in the figure below is fully charged by a 14.0-V battery. The battery…

A: The charge stored on the first capacitor is, Q1=C1V=3.0 μF14.0 V=42.0 μC The charge stored on the…

Q: the emf source, E=3.2 V, of the circuit shown in the figure has negligible internal resistance. the…

Q: An uncharged capacitor is connected to a battery of potential 10 V through a resistor of resistance…

A: Given: The potential (V) of the battery connected across the capacitor is 10 V. The resistance (R)…

Q: The figure below shows how a bleeder resistor (R = 250 kΩ) is used to discharge a capacitor (C =…

A: Bleeder resistor: A bleeder resistor which is connected in parallel with the output of a…

Q: In the circuit diagram, the emf of the battery is 12V. Resistor R1 has a resistance of 4.0ohms, and…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.
The- pair of capacitors in Figure P28.63 are fully charged by a 12.0-V battery. The battery is disconnected, and the switch is then closed. Alter 1.00 ms has elapsed, (a) how much charge remains 011 the 3.00-F capacitor? (b) How much charge remains on the 2.00-F capacitor? (c) What is the current in the resistor at this time?
A battery has an emf of 15.0 V. The terminal voltage of the battery is 11.6 V when it is delivering 20.0 W of power to an external load resistor R. (a) What is the value of R? (b) What is the internal resistance of the battery?
(a) Determine the equilibrium charge on the capacitor in the circuit of Figure P27.46 as a function of R. (b) Evaluate the charge when R = 10.0 . (c) Can the charge on the capacitor be zero? If so, for what value of R? (d) What is the maximum possible magnitude of the charge on the capacitor? For what value of R is it achieved? (c) Is it experimentally meaningful to take R = ? Explain your answer. If so, what charge magnitude does it imply? Figure P27.46
Draw two graphs of charge versus time on a capacitor. Draw one for charging an initially uncharged capacitor in series with a resistor, as in the circuit in Figure 21.38, starting from t = 0. Draw the other for discharging a capacitor through a resistor, as in the circuit in Figure 21.39, starting at t = 0, with an initial charge Q0. Show at least two intervals of t.
In the circuit of Figure P28.30, determine (a) the current in each resistor and (b) the potential difference across the 200- resistor.
Three 100- resistors are connected as shown in Figure P21.41 The maximum power that can safely be delivered to any one resistor is 25.0 W. (a) What is the maximum potential difference that can be applied to the terminals a and b? (b) For the voltage determined in part (a), what is the power delivered to each resistor? (c) What is the total power delivered to the combination of resistors?
The circuit in Figure P21.59 has been connected for a long time. (a) What is the potential difference across the capacitor? (b) If the battery is disconnected from the circuit, over what time interval does the capacitor discharge to one-tenth its initial voltage?
A student makes a homemade resistor from a graphite pencil 5.00 cm long, where the graphite is 0.05 mm indiameter. The resistivity of the graphite is =1.38102/m . The homemade resistor is place inseries with a switch, a 10.00-mF capacitor and a 0.50-V power source, (a) What is the BC time constant of the circuit? (b) What is the potential drop across the pencil 1.00 s after the switch is closed?
A circuit contains a D-cell battery, a switch, a 20- resistor, and three 20-mF capacitors. The capacitors are connected in parallel, and the parallel connection of capacitors are connected in series with the switch, the resistor and the battery, (a) What is die equivalent capacitance of the circuit? (b) What is the KC time constant? (c) How long before the current decreases to 50% of the initial value once the switch is closed?
A homemade capacitor is constructed of 2 sheets of aluminum foil with an area of 2.00 square meters, separated by paper, 0.05 mm thick, of the same area and a dielectric constant of 3.7. The homemade capacitor is connected in series with a 100,00- resistor, a switch, and a 6.00-V voltage source, (a) What is the RC time constant of the circuit? (b) What is the initial current through the circuit, when the switch is closed? (c) How long does it take the current to reach one third of its initial value?
Consider the circuit shown in Figure P28.9. Find (a) the current in the 20.0- resistor and (b) the potential difference between points a and b.