A 10 AWG copper conductor with type THW insulation is to be run in free air. What is the maximum ampacity of this conductor if the ambient air temperature is 40 degree Celsius

Q: 12. A copper conductor has a diameter of 1.265 mm and length of 500 m, calculate the operating…

A:

Q: A cylindrical conducting wire which is 4658.98cm long, 83.02mm thick and resistivity of 8.92 ohm per…

A: The electrical current suffers an obstruction while it's flow. This obstruction offered to the flow…

Q: What's the primary disadvantage of using copper conductors? A. Weight B. Durability C. Cost D.…

A:

Q: 5. From tables provided in this chapter, identify the ampacity of the following conductors: a. No. 8…

A: Copper conductor with THHN insulation  Size : 8 AWG Temperature : 900 C/1940 F

Q: What is the ampacity of nine 10 AWG THHN current-carrying conductors installed in a single raceway…

A:

Q: Airframe Electrical System Question: What happens to the resistance of a wire if its temperature…

A: Resistance – at normal temperature material opposes the flow of electric charge through them, the…

Q: Example 11.20. A single-core cable is laid in the ground, the core diameter being 30 mm and the…

A: Given data of single core cable are: Core diameter is 30 mm. Dielectric thickness is 40 mm. The…

Q: 1) For each of the unconventional conductors a and b given in Figure 1 below find the Geometric Mean…

A:

Q: (b) A 3-phase, 50 Hz, 132 kV overhead line of length 150 km has conductors placed in a horizontal…

A:

Q: No. 12AWG copper conductor with a two-way length of 500ft is carrying a load of 10A on a 270V,…

A:

Q: 2- A single core cable 3 km long has an insulation resistance of 1820 MQ. If the conductor diameter…

A: Given length of cable=3km or 3000m, insulation resistance=1820 Mega ohm or 1820x10^-6 ohm, conductor…

Q: A cylindrical 4 AWG copper wire is coated with NEMA class A insulation. The normal operating…

A:

Q: A load is located 100 ft from a 230V power supply and is wired with 4 AWG aluminum conductors. What…

A: Given Length L =100 ft V0ltage V =230 V

Q: A 2-wire d.c. distributor, 500 m long is fed at one of its ends. The cross-sectional area of each…

A: Transmission line diagram -

Q: Determine the ampacity of a No. 12 AWG copper conductor with THHN insulation that will be used in a…

A: The characteristics of the given conductor are,  Wire size=12 AWG…

Q: Determine the allowable ampacity of a 350 kcmil THW aluminum conductor installed in a raceway with…

A: The National Electrical Code (NEC) table 310.15(B)(16) is shown below:

Q: 7. A cylindrical rubber insulated cable has a diameter of 0.18 inch and an insulation thickness of…

A: In this question, we will find insulation  resistance of cable....

Q: Calculate the direct current resistance for 1 km of a 3 cm diameter aluminum conductor? (Resistance…

A:

Q: For each of the unconventional conductors a and b given in Figure 1 below find the Geometric Mean…

A:

Q: Q3/ Discuss the advantages and disadvantages of shielding the copper cables .

A: Shielding reduces electrical noise through the copper cables transmission shielding the copper…

Q: You can determine a conductor’s short-time withstand rating using charts published by the ____.…

A: Conductor’s short-time withstand rating: When a fault occurs, a short circuit current s flows…

Q: Determine the ampacity of a No. 8 AWG copper conductor with THHN insulation that will be used in a…

A: Given:  Conductor size no.=8 AWGInsulation type=THHNConductor type=CopperAmbient temperature not…

Q: What is the resistance of a 1 km length of #6 AWG copper conductor that has a diameter of 0.414 cm

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: -) A I50m long conductor of uniform cross - section has or voltoge drop of 8V between its ends. If…

A: In given question we need to find a conductivity of the material .

Q: Determine DC Resistance of a 141m long wire, If the resistivity is 2.3E-8 Ωm, the Area of a…

A: Basic problem on netwroks .. Look below for the solution..

Q: 12. The rate at which electrons move through a conductor varies. True False

A: According to guidelines we need to solve only first question. According to the question we have to…

Q: The diameter of a given bare conductor is 0.50inch . A thermoplastic insulation with thickness of…

A: Given data: The diameter of a given bare conductor, d = 0.50 inch…

Q: A 2-wire DC distributo

A:

Q: A copper conductor has a resistance of 15 ohms at 20 degrees celcius. Determine the resistance at 80…

A: A copper conductor has a resistance of 15 Ω at 20°C.here we have to determine the resistance at 80°C…

Q: A 10 AWG copper conductor with type THW insulation is to be run in free air. What is the maximum…

A:

Q: A copper conductor is connected in parallel with twice its length of aluminum conductor. The…

A:

Q: Find the smallest suitable conductor size for a building that will supply power to four (4) units of…

A: Given V=220 V load =4 units of 5.1 kW ambient temperature =38 degree C Copper wire

Q: An overhead line has a span of 150 m between level supports. The conductor has a cross-sectional…

A: We have an overhead line with the line parameters as, Line Span (l) = 150 m Cross-sectional area = 2…

Q: withstand 1425 kV peak lightning, 1050 kV peak switching and 480 kV peak pow frequency overvoltages.…

A: Given:- Gap factor( Kg) = 1.55 Altitude correction factor (KA) = 1.15 temporary overvoltages = 0.55…

Q: 3. A load that draws 12A is located 275 feet from its 240VDC source. It is supplied by aluminum…

A: Resistance of  conductor will be given by :-  VI = ρlAl = length of conductorA =area of conductor ρ…

Q: If the area of cross-section increases, the resistance of the conductor decreases. Select one: O…

A:

Q: A load that draws 12A is located 275 feet from its 240VDC source. It is supplied by aluminum…

A: The solution can be achieved as follows.

Q: A copper conductor is connected in parallel with twice its length of aluminum conductor. The…

A:

Q: A conductor has a resistance of 10.005 ohms at 25 C and 10.015 at 30 C. Determine the: a)…

A: In this question we will find temperature coefficient of resistance...

Q: A cylindrical 00 AWG copper wire is coated with NEMA class B insulation. The normal operating…

A:

Q: 5. Which of the following not TRUE about resistance? When the length of the conductor is doubled,…

A:

Q: A 10 AWG copper conductor with Type THW insulation is to rum in free air. What is the maximum…

A: The ampacity of a copper conductor with type THW insulation in free air is,  The correction factor…

Q: Compute the resistance of a conductor whose resistivity is 20.54 ohm-CM per foot with circlar…

A:

Q: copper wire at 20 degrees C, and 164 cmil, has a K value of 10.4 ohms per mi-foot. If the distance…

A: Given that A=164 cmilK=10.4 Ω/mi-ftL=600 ft=183m Although, 1 cmil=5.067×10-10 m2And1…

Q: A 2-wire d.c. distributor, 500 m long is fed at one of its ends. The cross-sectional area of each…

A: Draw the transmission line diagram for the above case.

Q: A conductor has a size of 500 MCM, what will be its size in square m?

A:

Q: copper conductor has a diameter of 17inch and it is 189 feet long. assume that it carriers a total…

A:

Q: ne specific resistance p depends upon he area of cross-section of the conductor he nature of the…

A: There is mentioned only three colors that is blend brown blue which means is has resistance of 1…

Q: trical conductivity - c) Increase of temperature - d) Decrease

A: The conductor is types of material that allow the current to flow into it. They are basically…

Q: A potential difference of 100 volt exists between the ends of a conductor having length of 300 cm.…

A: We have a conductor having, Potential difference (V) = 100 V Length of conductor (l) = 300 cm = 3 m…

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.