A 10.34 molal aqueous nitric acid solution was prepared. (Density of nitric acid = 1.51 g/mL, density of water = 1.0 g/mL, and the MW of nitric acid = 63 g/mol) a. How many grams of HNO3 were used to prepare the solution? b. What is the Molarity of the solution? c. What is the concentration (%v/v) of the solution?

A 10.34 molal aqueous nitric acid solution was prepared. (Density of nitric acid = 1.51 g/mL, density of water = 1.0 g/mL, and the MW of nitric acid = 63 g/mol) a. How many grams of HNO3 were used to prepare the solution? b. What is the Molarity of the solution? c. What is the concentration (%v/v) of the solution?

Introductory Chemistry For Today

8th Edition

ISBN:9781285644561

Author:Seager

Publisher:Seager

Chapter7: Solutions And Colloids

Section: Chapter Questions

Problem 7.42E

See similar textbooks

Similar questions

A gaseous solute dissolves in water. The solution process has H=15 kJ. Its solubility at 22C and 6.00 atm is 0.0300 M. Would you expect the solubility to be greater or less at (a) 22C and 1 atm? (a) 18C and 6 atm? (a) 15C and 10 atm? (a) 35C and 3 atm?
A 12-oz (355-mL) Pepsi contains 38.9 mg caffeine (molar mass = 194.2 g/mol). Assume that the Pepsi, mainly water, has a density of 1.01 g/mL. For such a Pepsi, calculate: (a) its caffeine concentration in ppm; (b) its molarity of caffeine; and (c) the molality of caffeine.
The dispersed phase of a certain colloidal dispersion consists of spheres of diameter 1.0 102 nm. (a) What are the volume (V=43r2) and surface area (A = r2) of each sphere? (b) How many spheres are required to give a total volume of 1.0 cm3? What is the total surface area of these spheres in square meters?
You have read that adding a solute to a solvent can both increase the boiling point and decrease the freezing point. A friend of yours explains it to you like this: The solute and solvent can be like salt in water. The salt gets in the way of freezing in that it blocks the water molecules from joining together. The salt acts like a strong bond holding the water molecules together so that it is harder to boil. What do you say to your friend?
Sodium chloride (NaCl) is commonly used to melt ice on roads during the winter. Calcium chloride (CaCl2) is sometimes used for this purpose too. Let us compare the effectiveness of equal masses of these two compounds in lowering the freezing point of water, by calculating the freezing point depression of solutions containing 200. g of each salt in 1.00 kg of water. (An advantage of CaCl2 is that it acts more quickly because it is hygroscopic, that is. it absorbs moisture from the air to give a solution and begin the process. A disadvantage is that this compound is more costly.)
Specifications for lactated Ringers solution, which is used for intravenous (IV) injections, are as follows to reach 100. mL of solution: 285315 mg Na+ 14.117.3 mg K+ 4.9Q.O mg Ca2+ 368408 mg Cl 231261 mg lactate, C3H5O3 a. Specify the amount of NaCl, KCl, CaCl2 2H2O, and NaC3H5O3 needed to prepare 100. mL lactated Ringers solution. b. What is the range of the osmotic pressure of the solution at 37C, given the preceding specifications?
Solutions Introduced directly into the bloodstream have to be isotonic with blood; that is, they must have the same osmotic pressure as blood. An aqueous NaCl solution has to be 0.90% by mass to be isotonic with blood. What is the molarity of the sodium ions in solution? Take the density of the solution to be 1.00 g/mL.