A 100 kgh mixture of benzene (B) and toluene (T) containing 50% benzene by mass is separated by distillation into two fractions. The mass flow rate of benzene in the top stream is 45 kg Bh and that of toluene in the bottom stream is 47.5 kg Th. The operation is under steady state.Write balances for benzene and toluene to calculate the unknown componentflow rate in the output streams.

A 100 kgh mixture of benzene (B) and toluene (T) containing 50% benzene by mass is separated by distillation into two fractions. The mass flow rate of benzene in the top stream is 45 kg Bh and that of toluene in the bottom stream is 47.5 kg Th. The operation is under steady state.Write balances for benzene and toluene to calculate the unknown componentflow rate in the output streams.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In an electrolysis of water experiment, 39.75 mL of H2 gas was collected over water at 60.0 °C and an atmospheric pressure of 1.03 atm. The vapour pressure of water at 60.0 °C is 19.92 kPa. What mass of H2 was collected?
A river has a flowrate of 3 m3/s. A stream discharges into the river at a flowrate of 0.05 m3/s. A tracer is added to the stream for research purposes. Determine the minimum concentration of tracer in mg/L that must be achieved in the stream so that 1.0 mg/L of tracer can be measured after the river and stream mix (downstream)? What mass rate in kg/d of tracer must be added to the stream? (Assume complete-mix reactor).
A mixture of 1 mole CO2 and 3.5 moles of air is contained in a vessel at 1 bar and 15°C. The volumetricanalysis of air can be taken as 21% oxygen and 79% nitrogen. Calculate for the mixture : (i) The massesof CO2, O2 and N2, and the total mass. (ii) The percentage carbon content by mass. (iii) The apparentmolecular weight and the gas constant for the mixture. (iv) The specific volume of the mixture.
0.5 kg of Helium and 0.5 kg of nitrogen are mixed at 20 degrees * C and at a total pressure of 100 kPa. Find (a) the volume of the mixture (b) the partial volumes of the components (c) the partial pressures of the components (d) the mole fraction of the components (e) the specific heats c_{p} and c, of the mixture and (f) the gas constant of the mixture.
Solve all I give a thumb up A vessel contains a binary mixture of O2 and N2 with partial pressures in the ratio 0.3 and0.7 at 25°C. The total pressure of the mixture is 1.5 bar. Calculate the followinga) Molar concentrations,b) Mass densities,c) Mass fractions,d) Molar fractions of each species.
A gold block initially at 62.9°C is put into 120 grams of H20 at 25.8°C in a container. The mixture at thermal equilibrium reached a temperature of 28.3°C. What is the mass of gold used?
An ideal gas at 0.60 atmospheric and 87 deg C occupies 0.450 Liter. How many moles are in the sample? (R = 0.0821 atm/mole K) A transportation company specializes in the shipment of pressurized gaseous materials. An order is received for 100 liters of a particular gas at STP (32 deg F and 1 atm). What minimum volume tank is necessary to transport the gas at 80 deg F and a maximum pressure of 8 atm?
A 5.00-g sample of aluminum pellets (specific heat capacity = 0.89 J/°C • g) and a 10.00-g sample of iron pellets (specific heat capacity = 45 J/°C • g) are heated to 100.0° The mixture of hot iron and aluminum is then dropped into 97.3 g water at 22.0°C. Calculate the final temperature of the metal and water mixture, assuming no heat loss to the surroundings.
100 grams of water are mixed with 150 grams of alcohol (ρ = 790kg/m3 ). What is the specific volume of the resulting mixture, assuming that the two fluids mix completely?
Calculate Z, HR, and SR by the Redlich/Kwong equation for benzene at 575 K and 30 bar, and compare the results with values found from suitable generalized correlations.
A mixture containing 500[g] water and 100[g] ice is initially in thermal equilibrium at a temperature of 0[°C] in an insulated vessel. Then 200[g] of water vapor at 100[°C] is introduced into the vessel. Assume that the heat capacity of the vessel is negligible, further consider:Lmelting = 3.33*105[J/kg], Lvaporization = 22.60*105[J/kg] and specific heat of water cwater = 4200[J/kg*°C].Determine the final composition of the system in grams and the final temperature.
Shown to the right is the solid-liquid phase behavior for mixtures of component A and component B at 1 atm. Use the phase diagram to answer the following questions. a) Specify the melting point of substance B at 1 atm b) What is the maximum composition (mole fraction) of component B that is possible for the mixture to exist in phase S2? At what temperature does this occur? c) 20mol of component A and 180mol of component B are mixed at 350°C and 1 atm. The mixture is cooled at constant pressure to 200°C. i) What phases are present at the final state? ii) What is the composition of each phase at the final state? iii) What is the number of moles of each phase at the final state?