Answered: A 100-volt shunt motor is developing 6…

A 100-volt shunt motor is developing 6 hp while operating at an overall efficiency of 86%. The armature and shunt field resistances are 0.06 and 50 ohms respectively. Determine stray power losses.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 51PE: If the power output in the previous problem is 1000 MW and line resistance is 2.00 (, what were the...

See similar textbooks

Related questions

Q: A 0.550 kg hammer is moving horizontally at 8.50 m/s when it strikes a nail and comes to rest after…

Q: The direction of the net magnetic field at point A due to the current in the wire shown in the…

A: The current in the L shaped wire = I To find : The direction of magnetic field at point A

Q: Put an X in front of the factors that affect how quickly an object will fall. how far the object has…

Q: What are the directions of the torque present in each system from (a) to (f)? (OB: out of the board,…

Q: It is the ratio of the ultimate stress to allowable stress. poisson's ratio. O shear modulus modulus…

A: Poisson's ratio is defined as the ratio of the lateral strain to longitudinal strain, within the…

Q: A current is looping in the direction shown in the figure below. What is the direction of the…

A: The direction of the magnetic field on the axis of a circular loop can be obtained using the right…

Q: Part A An LC circuit is built with a 40 mH inductor and an 12.0 pF capacitor. The capacitor voltage…

Q: 14. A sheet of paper can be withdrawn from under the bottle of milk without toppling it if the paper…

A: 14. (C) Inertia Bottle of milk has inertia and hence it will notove unless a big enough force acts…

Q: You hold your physics textbook in your hand. (Assume that no other objects are in contact with the…

Q: Describe and compare the wavelength, amplitude, frequency, and period of the waves in the figure…

Q: Two masses are attached to a uniform meter stick as shown in the figure 2. The masses of m1 and m2…

Q: 1. A microwave uses standing electromagnetic waves to cook food. Assume the wavelength is 12.2 cm.…

Q: An electric coffeemaker has a 610-W heating element. The specific heat of water is 4.19 × 103…

A: Given data: Power (P) = 610 W Specific heat capacity (c) = 4.19×103 J/kg.°C Initial temperature…

Q: A ternary string is a string made up of Os, 1s, and 2s. How many ternary strings of length 11 are…

Q: Which of the statements below does not coincide with the definition of Newton's 3rd Law of Motion? *…

A: Here the option (d) is correct. i.e An object at rest may or may not experience action-reaction…

Q: Two charged particles: Q1= -25.75 uC and Q2= +15.55 uC are separated by a distance r = 27.0 cm. What…

A: Given data: Two charged particles Q1 = -25.75 μC Q2 = +15.55 μC Distance (r) = 27.0 cm = 0.270 m…

Q: Solve for the angular speed of a car while taking a circular turn of radius 100 m at 36km/hour. a.…

Q: Part A A 16.5-cm-diameter loop of wire is initially oriented perpendicular to a 1.9-T magnetic…

Q: Question 2 A Dodge Colt traveling at 95 km/h can stop in 49.04 m. Given that the actual stopping…

A: initial speed of dodge colt (v) = 95 kmhrdeacceleration = 7.1 ms2actual stopping distance = 55 m

Q: An ice cube is placed in a sealed insulated container of hot water at 80°C. After five minutes, the…

Q: a copper wire is 2.50m long and has a diameter of 2.5 mm. How much current will it draw when…

A: Given data: A copper wire Length (L) = 2.50 m Diameter (d) = 2.5 mm = 2.5×10-3 m Voltage (V) = 3.5…

Q: Concave mirrors have a _____ focal length. While convex mirrors have a _____ focal length A.…

Q: A baseball is thrown upward with an initial velocity magnitude of 35.0 m/s. What is its velocity at…

Q: A space probe of mass 86 kg is moving with an initial speed of 10 m/s in the outer space. A constant…

A: Given that, Mass(m)= 86 kg Initial speed (v)= 10 m/s Fnet = <42,28,19>N So, Fnet= 42i + 28j +…

Q: Verify the current and voltage results of the simulation by using Kirchhoff's Rules.

Q: Three moles of an ideal gas are in a rigid cubical box with sides of length of 0.200 m. (a) What is…

Q: A 2- kg box is lifted 1 m from the floor to a table top and then to a shelf 1 m above the table.…

A: Gain in gravitational potential energy for small heights = mgh0. Here, m = mass of box = 2 kg. g =…

Q: A dark band in a double-slit interference pattern happens when light from both slits reach the…

A: In double slit experiment dark band is formed because of destructive interference whereas bright…

Q: For the following circuit, calculate the total charge, in Coulombs, delivered by the voltage source.…

Q: Another long, straight current-carrying wire has a circular loop with a 13.44-mm radius. If the…

Q: A door hinged on the right is shown in the diagram below: The door is 0.8m wide and 2.2m tall.

A: Given information: The mass of the door (M) = 10.0 kg The width and length of the door: w = 0.8 m; l…

Q: 2 Calculate to five significant figures the binding energy in J/nucleon of the nucleus of an atom of…

Q: This time, the pendulum is 1.07 m long and has a mass of 4.92 kg. You give it a push away from…

A: length (L) = 1.07 m mass (m) = 4.92 kg initial speed = 2.88 msenergy lost = 1 J

Q: A 1.5 kg mass vibrates according to the equation f(x) = 0.75 cos ( 10.5t) Determine the amplitude,…

A: amplitude =0.75m frequency w=2πf f=w/2*3.14 =10.5/2*3.14 =1.67Hz

Q: 6. At a certain point between Earth and the Moon, the net gravitational force exerted on an object…

Q: all forces on the free-body diagram of a body can be computed using only equilibrium analysis, the…

A: If all forces on the free body diagram of a body can be computed using only equilibrium analysis ,…

Q: A converging lens has a focal length of +22.5 cm. An object is placed 43.9 cm away. What is the…

A: Given Data:- Focal length of the lens is f=22.5 cm Object distance is u=43.9 cm Required:-…

Q: A metal has a work function of 5.5 eV. d) The stopping potential, required to stop the electrons…

Q: 10 nC -10 nC 3 cm 4 cm 5 nC Figure Q1 Three charges, 10 nC, -10 nC and 5 nC are located at three…

A: Given, Three charges 10nc,-10nc and 5nc are located at the corner of a rectangle.

Q: JC-42) Probability to Find an Electron An electron in its ground state is trapped in the 1D Coulomb…

Q: Point charges of magnitude +2 µC and +4 µC are respectively placed at points A and B. The two points…

A: Point charges of magnitude +2 µC and +4 µC are respectively placed at points A and B. The two points…

Q: An object is placed 25 cm in front of a lens of focal length 20 cm. 60 cm past the first lens is a…

Q: The speed of light in a certain substance is 85 % of its value in water (nwater = 1.33). What is the…

Q: Your mass is 91.5 kg, and the sled s mass is 18.3 kg. The sled is moving by itself on the ice at…

A: Given Mass of a person = 91.5 kg Mass of sled = 18.3 kg Initial speed of sled = 4.88 m/s along the…

Q: At the instant the traffic light turns green, a car that has been waiting at an intersection starts…

Q: xpress your answer to three significant figures and include the appropriate units. HÀ Value Units…

Q: A boy kicks a soccer ball that is at rest and it reaches a speed of 10 m/s 1 second after being…

Q: The acceleration of an object (in m/s2) is given by the function a(t)=8sin(t)a(t)=8sin(t). The…

A: a(t)=8sin(t)a(t)=8sin(t) v(0)=−10v(0)=-10 m/s

Q: A solid copper cube has an edge length of 89.6 cm. How much stress must be applied to the cube to…

Q: Mary applies a force of 72 N to push a box with an acceleration of 0.41 m/s?. When she increases the…

Question

5.) A 100-volt shunt motor is developing 6 hp while operating at an overall efficiency of 86%. The armature and shunt field resistances are 0.06 and 50 ohms respectively. Determine stray power losses.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Calculate the peak voltage of a generator that rotates its 200-turn, 0.100 m diameter coil at 3600 rpm in a 0.800 T field.
Why is the power dissipated by a closed switch, such as in Figure 21.43, small?
If the power output in the previous problem is 1000 MW and line resistance is 2.00 (, what were the old and new line losses?
Review. A novel method of storing energy has been proposed. A huge underground superconducting coil, 1.00 kin in diameter, would be fabricated. It would carry a maximum current of 50.0 kA through each winding of a 150-turn Nb3Sn solenoid. (a) If the inductance of this huge coil were 50.0 H. what would be the total energy stored? (b) What would be the compressive force per unit length acting between two adjacent windings 0.250 in apart?
What is the peak power consumption of a 12G-V AC microwave over that draws 10.0A?
Suppose you have a motor with a power factor significantly less than 1. Explain why it would be better to improve the power factor as a method at improving the motor's output, rather than to increase the voltage input.
Explain what causes physical vibrations in transformers at twice the frequency of the AC power involved.
At what angular velocity in rpm will the peak voltage of a generator be 480 V. if its 500-turn, 8.00 cm diameter coil rotates in a 0.250 T field?
The generator of a car idling at 1500 rpm produces 17.4 V What will the output be at a rotation speed of 2800 rpm, assuming nothing else changes? Express your answer to three significant figures and include the appropriate units.
Integrated Concepts Hydroelectric generators (see Figure 20.43) at Hoover Dam produce a maximum current of at 8.00 X 103 A at 250 kV. The water that powers the generators enters and leaves the system at low speed (thus its kinetic energy does not change) but loses 160 m in altitude. How many cubic meters per second are needed, assuming 85.0% efficiency?
At what angular velocity in rotation/min will the peak voltage of a generator be 540 V, if its 420–turn, 6.30 cm diameter coil rotates in a 0.290 T field? (You do not need to enter any units.)
7. If the power consumed by a 4.00 Ω speaker is 160 W, then the current that flows through the speaker is a) 0.0250 A b) 0.158 A c) 6.32 A d) 40.0 A (Must be free from plagiarism use prepostseo if explanation or else i will rate unhelpful do it fast for helpful rating)