A 1000-turn coil is wrapped around a magnetic core, with a current of 2.5 amperes. If the total core reluctance is 100000 A-t/Wb, what will be the resulting magnetic flux in the core? Express your answer in webers (Wb), up to four decimal places. Answer:

A 1000-turn coil is wrapped around a magnetic core, with a current of 2.5 amperes. If the total core reluctance is 100000 A-t/Wb, what will be the resulting magnetic flux in the core? Express your answer in webers (Wb), up to four decimal places. Answer:

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter8: Basic Electric Motors

Section: Chapter Questions

Problem 3RQ

See similar textbooks

Related questions

Q: 2. How can you improve the spectrum resolution? What are -nces bot. TFT?

A: Given We need to provide ways to improve spectral resolution. Please find the below attachment for…

Q: مد The figure represents 16-ary QAMO 16-PSK O 4-ary QAM 4-PSK

A: We need to select correct option for given diagram .

Q: 14. A single-phase AC supply has ac mains voltage of 230 V at 50Hz and feeder (source) impedance of…

Q: A 30, 45 kV is supplied to converter which is used in a HVDC transmission system. Each thyristor has…

A: Given data is shown below. Vf=45kVVbm=1740V△ID=42.5mAη=77%=0.77

Q: 3. Find Thevenin's equivalent circuit for the circuit shown below b www RL 100 V +₁|||||| 12 ww

Q: What is the Baud rate for M-ary digitally modulated carrier if M = 8 and channel capacity = 2.7 kHz…

A: Given data, Channel capacity = 2.7 kHz M = 8

Q: Design a 16x1 Mux. Using 4x1 Mux? Design a 16x1 Mux. Using 2x1 Mux?

A: Multiplexer : A multiplexer is a circuit used to pick out and path anybody of the several enter…

Q: The operating frequency for UHF RFID is

A: For Ultra High Frequency (UHF) band , frequency range from 300 MHz to 1 GHz. RFID systems that are…

Q: Q2:- calculate the electrical energy consumed by T.V. (250V) during one Month if this T.V used (3…

Q: The bridge rectifier with a resistive load only which has an ac source with Vrms=120 V at 50 Hz, and…

A: Given, The bridge rectifier with resistive load has AC source voltage, Vrms=120 V Source frequency,…

Q: 1. Which combination is correct? 10 V M1 Yo K = 2 mA/V² V₁ = 1 V 5 V K = 64 mA/V² M2 S VT = 1 V 2 V…

A: Saturation currect of transistor M1 is equated to triode current of transistor M2. Solving above…

Q: The phaser form of v=123cos(50t-30)= 123 /-30 True False

A: We need to tell about whether the given statement is true or false

Q: Ex: A 500-kv three-phase transposed line is composed for one ACSR 1,270,000 (mil, 45/7 Bittern…

A: Inductance is induced a electromotivee force by current in circuit in a neighbouring circuit.…

Q: Q2: find Z equivalent if the frequency is 50: R2 R1 R3 ww w 3002 552 792 3mF Zeq 4mF 1. Add File 2H

Q: 2- What is the role of emitter bypass capacitor CE in CE amplifier circuit shown in Fig. ?

A: The objective is to determine the role of emitter bypass capacitor in the amplifier.

Q: Given: RG 1Mega VG OV IG=0A RD 50k Vps oss = 180 μA Vp=-1.6 V GS lo-loss(1-² P VDD 10V

Q: U Let x[n], 1, 2, 1, 2, 1, 2, 1, 2, 1, 2, 1, 2, 1, 2, 1, 2, 1, 2, 1, 2,--- and U y[n] = {, 1, 2, 2,…

Q: 1. MOV SI,DI is example of - 2. MOV AL, 'G' is an example of ---- -addressing mode. -----addressing…

A: 1. Answer: Direct addressing mode. Explanation: Here the data prsesnt in DI register is directly…

Q: 6-If the flip flop Q2: Design a sun are not clocked simultaneously, it is -counter through the…

A: Bartleby has policy to solve only first question. So reupload the 2nd question.

Q: A 10 KVA, single phase transformer has a trunks ratio of 12:1 and is supplied from a 2.4 KV supply.…

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100t) volt R3 R2 R1…

A: 1) To find the voltage across 1 H inductance

Q: Current "I" that flows through the resistor 12 Q2 is 0.5 A, Find the potential difference between…

Q: For the circuit below with E = 10 V, R = 5800 N. Find the following: a) current in the circuit b)…

Q: A DMA controller has kept 8 Bus request signals to the CPU under Burst mode. The maximum of the data…

A: We know that For n bus signals we have 2^n combinations. So for 8 bus signals we have 2^8 = 256…

Q: Q2: for figure 1, find IP for load and S for source? L 380/0° V 380-120° V 380/120° V 11 AQ 212…

A: In this question, We need to determine the value of the load current, active power P and complex…

Q: Q4: find the current in 4mf capacitance if the source value is 4 sin(100ſt) Amp: R3 R2 5.02 792 ↑.…

Q: Obtain the series expansion of f(x) = log x in powers of (x-1).

A: In order to calculate the series of logx in terms of (x-1), we have used Taylor's Series Expansion.

Q: Realize Op-amp as adder, subtractor,buffer, integrator and differentiator circuit.

Q: Find the sine function of: 1. Z = 10 + i

Q: Combining the equation for the convection current density and the equation relating the drift…

A: Brief description: With reference to the given statement initially we have to make certain equations…

Q: Q/ The reactance X of inductance L =j/ WL True False

Q: system is stable in the K-h region of the closed-loop block diagram below. Perform on the plane.…

A: The System is stable in the K-h Region of the closed-loop block diagram. The block Diagram is given…

Q: Find the complex conjugate number 12 + 5j, Select one: O a.-12-5j O b. 12+5j O c. -12+5j O d. 12-5j…

A: For complex conjugate of any number a+jb is a-jb

Q: Q1] find the voltage of the inductance 1H if the value of the source is: 50 sin( 100 t) volt R3 R2…

Q: If a signal bandwidth is 1 MHz and the channel signal-to-noise ratio is 30 dB, what is the Shannon…

Q: 3- Implement f(a,b,c,d) =Em(0,1,5,6,7,9,10,15) by using 4 multiplexer and a,b as a select line.

Q: Derive an expression for Idc and Irms of center tap full wave rectifier circuit & find its maximum…

A: Expression for Idc and Irms of center tap full wave rectifier & find its maximum efficiency.…

Q: Consider two infinitely long parallel wires. The wires are separated by a distance of 10 cm. Both…

A: Given: Two infinity long parallel wires separated by, Distance, d = 10 cm Both wire carries a…

Q: Find voltage gain, that is, Av = Vo1/Vi. hfe = 1600

A: The circuit is as shown below,

Q: onin Determine the d.c. resistance

Q: (2-2) An ideal germanium diode at a temperature of 125°c has a reveres saturation current of 30μA.…

Q: PROBLEM: Derive the z-transform for f(t) = sin oot u(t).

A: It is Given that: f(t)=sinωtu(t)

Q: Figure 4.00 Ω . 3.00 AL 2.00 A R &₁ + ww 23.00 Ω 1 of 1 > 6.00 Ω 15.00 A Submit Request Answer Part…

A: Given data, Circuit diagram is given as,

Q: A 24kVA, 6000/200 V transformer during the short circuit test the following result is obtained in…

A: In this question short circuit tests is given ...We have to find out voltage applied on high voltage…

Q: d name two 2) types

A: There are two types of the sampling methods. They are 1. Probability sampling 2. Non-probability…

Q: An Amplitude Modulation (AM DSBFC) radio broadcasting station with its carrier frequency of 750 kHz…

Q: Q3: A 20-KVA transformer has a maximum efficiency of 98 percent when delivering three- fourth…

Q: What is the Baud rate for M-ary digitally modulated carrier if M = 8 and channel capacity = 2.7 kHz…

Q: The phaser form of v=123cos(50t-30)= 123 /-30 O True False

Q: The plates of a capacitor are of conical shapes and are defined by the surfaces 0 = 27° and 9 = 66°.…

A: The Given data is The Surface of the conical shapes is ϕ1=27°; ϕ2=66° The Height of the both…

Question

A 1000-turn coil is wrapped around a magnetic core, with a current of 2.5 amperes. If the total
core reluctance is 100000 A-t/Wb, what will be the resulting magnetic flux in the core?
Express your answer in webers (Wb), up to four decimal places.
Answer:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the difference between a thermal overload and a magnetic overload? Draw the symbol for each.
A square magnetic core has a mean path length 55cm and x-sectional area of 150cm2. A 200 turns coil of wire is wrapped around one leg of the core. The core is made of the material having relative permeability 3980. Find • How much current is required to produce 0.012 Wb of flux in the core • Calculate the reluctance and magnetomotive force.
The magnetic circuit of Figure shown has current 10 A in the coil of 1800 turns. Assume that all branches have the same cross section of 2 cm^2 and that the material of the core is iron with μr = 1500. Calculate magnetomotive force for the core.
The length of a magnetic circuit in a moving iron instrument is 300mm. The coil around the soft-iron core has 360 turns and takes a current of 1.75 A. The core is square in section with sides of 20 mm. Takethe relative permeability of soft iron as 1100. Determine the flux density
Using figures (a) and (b), a magnetic flux density of 0.1 Wb in the air gap Determine the current I in the coil with 200 turns required to produce
A current in a 250 turn coil is 2.25A, wound in a core that has a reluctance of 12,000 AT/Wb. What is the resulting flux density (in Tesla), if the area of the core is 8cm²?
Question 3.4 (3.4)The length of a magnetic circuit in a moving iron instrument is 300mm. The coil around the soft-ironcore has 360 turns and takes a current of 1.75 A. The core is square in section with sides of 20 mm. Takethe relative permeability of soft iron as 1100. 3.4.1) Determine the magnetomotive force in the core 3.4.2)Determine the field strength 3.4.3) Determine the total flux
The length of a magnetic circuit in a moving iron instrument is 300mm.The coil around the soft iron core has 360 turns and takes a current of 1.75A.The core is square in section with sides of 20mm.Take the relative permeability of soft iron as 1100. Determine the magnetomotive force in the core. Determine the field strength. Determine the flux density. Determine the total flux.
Consider the magnetic circuit in figure. A current of (3A) flowsthrough 200 turns of wire around a core of cross sectional aea of10-3 m2 and a relative permeability of 5000.a) Determine the magnetic flux in each legb) Determine the magnetic field intensity in the air gapc) Determine the magnetic force on the across the air gap
The reluctance of a non-magnetic circuit is 14 units. How much flux will be set up if surrounded by a coil 620 turns carrying a current of 3.6 Ampere? Draw the diagram
The length of a magnetic circuit in a moving iron instrument is 300mm. The coil around the soft-iron core has 360 turns and takes a current of 1.75A . The core is square in section with sides of 20mm . Take the relative permeability of soft iron as 1100 . 3.4.1 Determine the magnetomotive force in the core 3.4.2 Determine the field strength 3.4.3 Determine the flux density 3.4.4 Determine the total flux
A magnetic circuit consists of silicon steel of 3000 permeability and an air gap.The length of the steel core is 10cm and the air gap is 2cm. Both have the samecross section of 1.5 sq. cm. A current of 1⁄2 ampere flows through the windings toproduce 2351 maxwells flux. How many turns are there in the coil? ans: 5000 turns