A 12m high circular tank with 45m radius contains oil weighing 9.4kN/m3. This tank stands over a 3m saturated sand layer (γsat = 18.88 kN/m3) underlain by a 14m thick clay layer (γsat = 17.30 kN/m3 , e = 1.27 and Cc = 0.40). Neglect weight of the tank. Assume no precompression has occurred. What is the difference between the settlement below the center and below the end of the tank?

A 12m high circular tank with 45m radius contains oil weighing 9.4kN/m3. This tank stands over a 3m saturated sand layer (γsat = 18.88 kN/m3) underlain by a 14m thick clay layer (γsat = 17.30 kN/m3 , e = 1.27 and Cc = 0.40). Neglect weight of the tank. Assume no precompression has occurred. What is the difference between the settlement below the center and below the end of the tank?

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter18: Sheet-pile Walls

Section: Chapter Questions

Problem 18.13P

See similar textbooks

Similar questions

A clay layer of 30 m thick with a unit weight of 20 kN/m3 overlies a sand layer. The groundwater table is at the ground surface initially. A 20 m deep excavation is made in the clay layer. Piezometric measurements show artesian pressure at the bottom of the clay layer, amounting to a water level of 8 m above the excavation base. Calculate the factor of safety against the bottom heave for the excavation.
The soil profile at the site consists of a 5.0 m sand layer underlain by 13 m of clay layer. The groundwater table is at a depth of 2.8 m below the ground surface. The sand has a unit weight of 19 kN/m3 above the groundwater table and 20 kN/m³ below the ground water table. Meanwhile, the saturated unit weight of clay is 15.7 kN/m3. At a depth of 11m from the ground lever, calculate the Total Pressure, Porewater Pressure, and the Effective Pressure (in kPa).
1.A raft foundation 60 X 40 m carrying a net pressure of 145 kN/m^2 is located at adepth of 4.5 m below the surface in a deposit of dense sandy gravel 22 m deep: thewater table is at a depth of 7 m. Below the sandy gravel is a layer of clay 5 m thickwhich, in turn, is underlain by dense sand. The value of mv for the clay is 0.22 m^2/MN. Determine the settlement below the centre of the raft, the corner of the raftand the centre of each edge of the raft, due to consolidation of the clay.
A 10-m-thick layer of stiff saturated clay is underlain by a layer of sand (Figure 9.28). The sand is under artesian pressure. A 5.75-m-deep cut is made in the clay. Determine the factor of safety against heaving at point A.
A 10 m depth of sand overlies an § m layer of clay, below which is a further depth of sand. For the clay, m, = 0.83 m?/MN and cv = 4.4 m/year, The water table is at surface level but is to be lowered permanently by 4 m, the initial lowering taking place over a period of 40 weeks. Calculate the final settlement due to consolidation of the clay, assuming no change in the weight of the sand. and the settlement two years afte the start of lowering.
Plz give the correct answer. Compute the intensities of active and passive earth pressure at depth of 8 m in dry cohesionless sand with an angle of internal friction of 30 degrees , and unit weight of 18kN / (m ^ 3) What will be the intensities of active and passive pressure if the water level rises to the level? Take the saturated unit weight of sand as 22kN / (m ^ 3) .
Determine the critical hydraulic gradient of a coarse gtaned soil if buoyant unit weight is equal to 26.648 kN/cumec
A soil profile consists of a clay layer of 10 m thick between a permeable sand layer above and an impermeable rock layer below, the water table being in the sand layer. Before the construction of a reservoir raft foundation, piezometers were installed in the clay layer.The whole process of filling the reservoir may be approximated to applying rapidly a single pressure increment of 100 kN/m2 uniformly throughout the clay layer. One year after filling the reservoir, the settlement was 20 cm and the piezometers indicated the distribution of excess pore pressure as shown in the figure below. Estimate the final settlement and the time to complete 90 % of primary consolidation.
Estimate the lateral earth pressure at a depth 20 ft (6.1 m) below the ground surface in a loose sand deposit. The wet unit weight of the sand is 115 pcf (19 kN/m3). What would the total lateral pressure be if the water table rose to the ground surface (in psf or kPa)?
trench 80 ft long is excavated 500 ft away and is parallel to a riverbank. A sand aquifer is 40 ft thick The river water surface is 50 ft above the horizontal bottom of the aquifer. If the water depth in the trench must be maintained at 10ft, at what rate must water be pumped from the trench? How far from the trench will the aquifer cease to be saturated? Use K of sand = 30 ft/day
A 9.15m thick layer of sandy soil overlies an impervious rock. The groundwater level is at a depth of 1.22m below the top of the soil. Water was pumped out of the soil from a central well at the rate of 5680 kg/min and the drawdown of the water table was noted in two observation wells. These two wells were on a radial line from the centre of the main well at distances of 3.05m and 30.5m. During the pumping the water level in the well nearest to the pump was 4.75m below ground level. In the furthest well was observed to be 2.13m below ground level. Make a sketch of the situation explained in the foregoing and indicate what kind of aquifer is being described. Evaluate the permeability of this aquifer in m/day.
Estimate the lateral earth pressure developed at a depth 5 m below the soil surface of a loose sand deposit (wet unit weight of soil is 17.5 kN/m3). Also estimate the lateral pressure for the same depth if the sand is in a dense condition (unit weight is 20.5 kN/m3). What would be the total lateral pressure for the loose sand condition described if the water table were at the ground surface?