A 15.0-F parallel-plate capacitor is connect in series to a 24.0-volt battery. When electrostatic equibrium is attained, the potential energy stored in the capacitor is 9a776 m Ob. 2.16 mj OC 5.79 m) Od 4.32 m) Oe10 10.0 mj

A 15.0-F parallel-plate capacitor is connect in series to a 24.0-volt battery. When electrostatic equibrium is attained, the potential energy stored in the capacitor is 9a776 m Ob. 2.16 mj OC 5.79 m) Od 4.32 m) Oe10 10.0 mj

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: For the root locus shown below, the break in point is -25 -20 -15 -10 -5 03 -18 -10+9i -10 O

A: - Root locus is the technique to analyse the stability of the closed loop control system.

Q: a.) Explain the output waveform at + input cycle. b.) Explain the output waveform at – input cycle.

A: Here the concept related to the Zener diode is discussed.

Q: Given Vo = 3.5 4122, V₁ = 5.0 Z-10, V₂ = 1.9 292, find the phase sequence components VA, VB and Vc.

Q: Determine the a.c. ripple voltage across the load of full wave rectifier which delivers 40 W to a…

Q: Consider the feedback control system 100 R(s). s(s+11.8) Select one: O a. co, = 3.26 rad/sec b.,…

A: Given: Feedback control system

Q: n the given network a. determine re calculate Zi and Zo = Find Av and Ai 1μF HH Vcc=16V 39 k 14,7 ΚΩ…

Q: Problem 2: Design a circuit that has three input signals A, B, and C and one output F. The output…

Q: Two long, parallel wires are separated by a distance of 2.70 cm. The force per unit length that each…

A: We need to find out current for given for given force

Q: of the system with specification given, Ka = 25,600? A.

Q: 10. A linear system has the transfer function given by W H(w) = w² + 15w+5 Find the power spectral…

A: We need to find out psd of output

Q: For the circuit shown, find an expression for the output voltage in term of Vi1,Vi2 and Vi3 given…

Q: 3.29) in the network shown below, it is given that v = 1V and dv/dt = -10 V/s at a time t, where t…

A: Given circuit, Where, v=1 Vdvdt=-10 Vs

Q: Consider a voltage source v(t) = 220 cos (100nt - 30°) Define a. The amplitude of v(t) b. The…

Q: Find the Inverse Laplace of a) 1/s3-s b) (s-1)/s(s+1)2

Q: Given a D-MOSFET circuit used as an amplifier with the following parameters: IDSS=12mA and a…

A: We need to find out drain to source voltage and output voltage for given circuit

Q: A 30 x 30 x 30 m room is installed with a fan designed to supply air every second. If the losses due…

A: Given,The volume of the room,V=30×30×30 mThe fan supplies air every second.So, t=1sDue to…

Q: Find Leq 77 pH نعقد 17 pH m m 4 nH -Lea] b 12 nH ele 72 pH m 1 nH ell 7 pH m 14 pH

Q: A coil of resistance 10 22 and inductance 0.8 H is connected to 200 V dc supply. The initial rate of…

A: Given: A coil of resistance, R=10 Ω Inductance, L = 0.8 H DC supplied voltage, V = 200 V

Q: The voltage gain of -40 dB is a voltage gain (non-logarithmic) of: O A. 1/1000 O B. None of the…

Q: If Vz-8 V and Pzmax=150mW. Determine the minimum value of RL to ensure the * Zener diode is in the…

Q: Stability is based on a natural response that decays to zero as time approaches infinity. True…

A: from the question Stability is based on a natural response that decays to zero as time approaches…

Q: The following are the symmetrical components of phase B current. Positive sequence component =…

A: In this question we need to find a positive sequence component of phase A I.e IA(1)

Q: Reduce to a single transfer function: R(S)- S S 200 S S 115 C(s)

A: Given problem can be solved by block reduction technique as stated below.

Q: The system H(s) = ((s+100000)(s+100))/((s+1000)(s+10000)) is: O A. None of the other choices are…

A: given system H(S)=S+100000S+100S+1000S+10000 here we have to determine the type of filter.

Q: 3. A 6 pole induction motor has the ratings: U₁ = 400 V, n = 970 rpm, ƒ№ = 50 Hz, the stator…

A: Given A 6 pole induction motor has the ratings: UN = 400 V, ny = 970 rpm, fv = 50 Hz, the stator…

Q: 1) Calculate the per-unit values for complex powers S2 and S3. 2) Calculate the magnitude of the…

A: We have to determine S2,S3,V1,V2

Q: For a common emitter transistor circuit, the collector current is 20 mA and emitter current is 20.1…

Q: A given BJT, B = 400. What is the value of a for the device? 1.0025 0.9975 0.002

Q: 50-Ω R and 70-Ω XL are in series with 120V applied. Find the impedance, total current, power factor,…

Q: Design Problem: A pattern recognizer with a 1-bit output Y accepts a 1-bit input X. Y becomes 1 only…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Convert into rectangular, polar and exponential form: Given: Z1= 2-j3 Z2=3-j5 1. (Z1)^−5

Q: . Given Vo = 3.5 2122, V₁=5.02-10, V₂ = 1.9 292, find the phase sequence components V₁, VB and Vc.

Q: If you know that the phase crossover frequency is 3.16 (rad/s) for the following transfer function,…

Q: lc = 0.9 2132 3. Given Vo = 3.5 2122, V₁=5.02-10, V₂ = 1.9 292, find the phase seque components V₁,…

Q: The sequence component of phase a current are: Zero sequence current = 0.47 + j1.49…

A: Given,The sequence component of phase a current are as follows,Zero sequence current = 0.47 + j1.49…

Q: Solve for Ic of Figure 42. 3.2 m/ 3.2 UA 4MA 4UA 12 V www -% = 6V --3-80 20130 1B = 40 μA Reference…

Q: 3. Find Leq

Q: Show your solutions clearly and systematically. The D latch of Figure 1 is constructed with four…

A: Given The D latch of Figure 1 is constructed with four NAND gates and an inverter. Consider the…

Q: Solve the collector-base voltage of an emitter stabilized bias circuit with Vcc=18V, RB-720k ohms,…

Q: closed and switch 2 is opened, or if switches 2, 4, and 7 are closed and switch 1 is opened, or if…

A: We use 7 switches to operate , If, Switch 1,3,5,7 - closed Switch 2 - open If, Switch 2,4,6 -…

Q: Determine the closed-loop gain of the ideal OP-AMP circuit given with the following parameters: R1 =…

A: We need to find out closed loop gain for given circuit

Q: The characteristic equation of a given system is s4 + s3 + 2s2 + 12s + 10 = 0. The stability…

A: Consider the given characteristic equation is: s4 + s3 + 2s2 + 12s + 10 = 0.

Q: A LED which bright one color when * forward and another color on reverse is called O Dimensional LED…

A: We need to select correct option for given LED.

Q: What is the power absorbed in Watts by a resistor with resistance of 5.00 is connected to a voltage…

A: Given: Resistor with resistance, R=5 Ω Voltage source with voltage, V = 2.7 V

Q: R₁ www Vout + Vin For the operational amplifier circuit shown, what value must R2 be in kilohms in…

A: The solution is given below.

Q: 021) Find the value of R, if 1, 3A Rx www 562 562 www E-24 V 1-3A

A: To find the value of Rx if I2 = 3 A in the given circuit

Q: The value of the damping ratio (C) of a critically damped Second order system is OT 0-1 <1 0

Q: A diode is a two terminal device. The application of a voltage across its terminals leaves three…

A: Diode- Diode is an electronic device which has two ports for supply connection. It is made up by the…

Q: Ex: Find VA iB مد3 m 42 2 VA using Thevenin theorem. 6 A + VA - Mu 20 V(+ It + د 2 26 B

Q: Ceiling fan is a a. Single Phase Induction Motor b. DC Motor c. Three Phase Induction Motor d.…

A: Motor and its application: Motor Applications Single phase induction motor Small fans,…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A 15.0-F parallel-plate capacitor is connect in series to a 24.0-volt battery. When electrostatic equibrium is attained, the
potential energy stored in the capacitor is
Qa776 m)
Ob. 2.16 mj
OC 5.79 m)
Od 4.32 mj
Oe. 10.0 mj

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A capacitor uses air as a dielectric and has a capacitance of 3 F. A dielectric material is inserted between the plates without changing the spacing, and the capacitance becomes 15 F. What is the dielectric constant of this material?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Can current flow through a capacitor?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
List the five capacitor replacement rules.
4. In what form is the energy of a capacitor stored?
You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
An industrial load consisting of a bank of induction motors consumes 50 kW at a power factor of 0.8 lagging from a 220-V,60-Hz, single-phase source. By placing a bank of capacitors in parallel with the load, the resultant power factor is to be raised to 0.95 lagging. Find the net capacitance of the capacitor bank in F that is required.
Inductive Circuits Fill in all the missing values. Refer to the following formulas: XL=2fLL=XL2ff=XL2L Inductance (H) Frequency (Hz) Inductive Reactance ( ) 1.2 60 0.085 213.628 1000 4712.389 0.65 600 3.6 678.584 25 411.459 0.5 60 0.85 6408.849 20 201.062 0.45 400 4.8 2412.743 1000 40.841
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.