A 22-lb body is traveling in a horizontal straight line with a velocity of 11.1 ft/sec when a horizontal force P is applied to it at right angles to the initial direction of motion. If P varies according to the accompanying graph, remains constant in direction, and is the only force acting on the body in its plane of motion, find the magnitude of the velocity of the body when t = 1.6 sec and the angle 0 which the velocity makes with the direction of P.

A 22-lb body is traveling in a horizontal straight line with a velocity of 11.1 ft/sec when a horizontal force P is applied to it at right angles to the initial direction of motion. If P varies according to the accompanying graph, remains constant in direction, and is the only force acting on the body in its plane of motion, find the magnitude of the velocity of the body when t = 1.6 sec and the angle 0 which the velocity makes with the direction of P.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

5. A slider of mass 10 kg moves along a slipway as shown. The spring has a value of K = 60 N/m and when the slider is stationary atAt position A, the spring is stretched for a distance of 0.6 m. moves through point CAt a speed of 1.2 m/s, find the magnitude of the force acting on the end of the rope.
(The complete question is in the picture) Consider a 2.0 [kg] box that is attached to two identical springs that are in their relaxed state when the block is centered on the frictionless horizontal floor. The box is pressed to the left and then was released from rest as shown in the figure. If work done by the left spring is Wby spring = 25 [J], what is the speed of the boxas it passes the center x = 0? A. 8.2 [m/s]B. 7.1 [m/s]C. 3.5 [m/s]D. zero
the P platform is located on a spring and is tied to the ground with lines so that they cause the spring to deflect from a free state of 1 m to 0.4 m. Next, a brick with a mass of 2 kg was placed on the platform and the spring was loaded by 0.1 m, and then the platform with the brick was released so that the brick was shot up to the height h. Determine the height h in relation to the ground. Assume the acceleration due to gravity g = 9.81 m / s ^ 2. k = 250 N/m
By using a forked rod, a smooth cylinder C having a mass of 0.5 kg is forced to move along the vertical slotted path (r = 0.4 θ) m, where θ is in radians. If the angular position of the arm is θ = (0.3 t3 ) rad, where t is in seconds. The cylinder is in contact with only one edge of the rod and slot at any instant. Find "the force of the rod on the cylinder at the instant t=2s" Find "the normal force of the slot at the instant t=2s" Find the "radius of curvature at t=2s" Find the "ψ angle at t=2s"
A body weighing 445 N is drawn along a rough surface. The force applied in the direction of motion is 135 N while the frictional force is 90 N. if there is an air resistance whose magnitude (in N) is equal to twice the velocity (m/s) at any instant, assume the body to start from rest.Determine the displacement at any time, t.
A 3.00 kg block slides on a semicircular track as shown. If it starts from rest at point A, determine the following a) potential energy at A b) kinetic energy and velocity at B c) potential energy, kinetic energy, and velocity at C.
A body above the surface of the earth is pulled toward the center of the earth with a forceproportional to the reciprocal of the square of the distance of the body from the center. If the radiusof the earth is 6375 km, find the velocity of the body as it strikes the surface of the earth if it fallsfrom rest at a distance four times the earth’s radius measured from the center of the earth. What isthe velocity if it falls from an infinite distance?
A wagon weighing 500 kN starts from rest, runs 30 meter down one percent grade and strikes the bumper post. If the rolling resistance of the track is 5 N/kN, find the velocity of the wagon when it strikes the post. If the bumper spring which compresses 1 mm for every 15 kN determine, by how much this spring will be compressed.
A mass-spring system is initially compressed towards a wall and hold in equilibrium withthe help of a forceF. At timet=0sec, the force Fis suddenly released. The mass-spring system then reaches a velocityvwhile sliding on the frictionless surface. (a) Is the linear momentum conserved? (b) Calculate the average force exerted by the wall on the mass-spring system after theforceFis released, assuming that the spring remains in contact with the wall for a shorttimeΔt. Express your answerin terms of k,m,Δt and F.
A 75-kg man stands on a spring scale in an elevator. During the first 3 seconds of motion from rest, the tension T in the hoisting cable is 8300 N. Find the reading R of the scale in newtons during this interval and the upward velocity v of the elevator at the end of the 3 seconds. The total mass of the elevator, man, and scale is 750 kg.
It is known that the mass of the 1,2,3 block is the same, which is 2 kg. The mass of block 4 is equal to the mass of block 5. The system is at rest. Neglect the masses of all ropes, Springs, and pulleys. If the magnitude of the acceleration due to gravity. g= 10 m/s², determine: a. Rope tension I b. Rope tension 3 c. The forces acting lincluding direction and magnitude) on blocks 2 and 3 as I unit ( two blocks are seen as 1 point object) d. Acceleration of block 4 when rope 3 is cut e. The force acting on block 3 if rope 2 is cut
Starting at time t = 0, net force F1 is applied to an object that is initially at rest. (a) If the force remains constant with magnitude F1 while the object moves a distance d, the final speed of the object is v1. What is the final speed v2 (in terms of v1) if the net force is F2 = 2F1 and the object moves the same distance d while the force is being applied? (b) If the force F1 remains constant while it is applied for a time T, the final speed of the object is v1. What is the final speed v2 (in terms of v1) if the applied force is F2 = 2F1 and is constant while it is applied for the same time T? In a later chapter we’ll call force times distance work and force times time impulse and associate work and impulse with the change in speed.)