A 2x3 ft cylindrical drum is filled with a fluid whose density is 40 lb/ft3 . Determine (a) the total volume of the fluid, (b) its total mass in pounds and slugs, (c) its specific volume, and (d) its specific weight where g = 31.9 fps2

A 2x3 ft cylindrical drum is filled with a fluid whose density is 40 lb/ft3 . Determine (a) the total volume of the fluid, (b) its total mass in pounds and slugs, (c) its specific volume, and (d) its specific weight where g = 31.9 fps2

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter18: Energy Storage

Section: Chapter Questions

Problem 4P

See similar textbooks

Related questions

Q: Q3. Re-right the above equation for the following conditions a. dry cohesion soil (7 sar – my „) tan...

A: Answer: Given equation Fs=cγsatHcosβsinβ+(γsat-mγw)tanϕγsattanβ

Q: An open cylindrical vessel 1.20m in diameter and 2.10m high is 2/3 full of water. If the vessel is r...

A: Given data in question Diameter Height Constant speed rotation To find out Height of paraboloid

Q: A pump is installed in the pipeline between reservoirs A and E as shown in the figure below. Water s...

A: Given, Hazan Williams coefficient =120 discharge Q=10 ft3/s Elevation A and B is 25ft and 40 ft

Q: In a free cylindrical vortex flow, at a point in the fluid at a radius of 200 mm and at a height of ...

A: Pressure at radius 400 mm and height 200 mm is 117.76 kN/m2

Q: 1.36 The bell crank, which is in equilibrium under the forces shown in the figure, is supported by a...

Q: what will be the delta for a crop when its duty is 710 hec/cumec on the field ?? If base period of t...

A: To determine the delta for a crop, provided with the duty and base period of the crop. Given, Duty...

Q: A man descends to the ground from an airplane with the help of a parachute which is hemispherical ha...

Q: er experts to do , otherwise i will downvote The following series of standard penetration test ...

A: According to given data 18-ft thick stratum of relatively uniform silty sand: Groundwater table i...

Q: A W360 x 122 section is used as a column with an effective length of 10 m. Determine the maximum loa...

A: Thus question belongs to subject Design of rcc structure. In this question find out Maximum load car...

Q: The time period of rolling of a ship of weight 30,000 kN in sea water is 12 seconds. The centre of b...

Q: An oil of viscosity 5 poise is used for lubrication between a shaft and sleeve. The diameter of the ...

Q: The truss shown in figure.

Q: 25 kN A B 50 kN E F G 6 m 8 m

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the exac...

Q: The A-36 steel W 6 x 20 column 6 m in height is pin connected at its ends and is subjected to the ax...

Q: The end block of a post-tensioned beam is 100 mm x 150 mm. A prestressing cable consisting of 7 wire...

Q: Assume that the sections have cracked, compute the bending stresses in the concrete and steel for th...

Q: A pipe of diameter 2 m is running full with water with a velocity of 1.7 m/s. What is the depth (in ...

A: Given data- Circular pipe-Diameter D=2 mWater is running full.velocity of water in pipe=1.7 m/s

Q: Appraise the critical state soil mechanics concept. You may evaluate this concept in relation to the...

A: Critical state soil mechanics is the area of soil mechanics that encompasses the conceptual models t...

Q: A simple curve of the proposed extension of Mantabahadra Highway have a direction of tangent AB whic...

A: Given data- Bearing=N50oEA at PC = 20+130.46Degree of curve D=4o

Q: Each bar has a cross-sectional area of 3 in? and modulus of elasticity E = 12x106 lb/in?. If a 40-ki...

A: According to given data

Q: Compute the maximum deflection for the beam loaded as shown below 400 Ib 400 Ib 160 Ib/ft 100 Ib/ft ...

A: To find Maximum deflection for the beam

Q: P 2 ing в с B 10° 6 in 2 in

Q: Piston

A: The following are the process involved in the Piston- Engine PowerPlant : 1.Fuel lift to Internal Co...

Q: In using the rational formula, Q ▪ CIA, for the design of any structure, what do the terms Q. C, I, ...

A: Q = CIA Q = Peak rate of runoff ( in cubic feet per second ) i = Rainfall Intensity (inch/hour) A...

Q: Give three sustainable construction methods or materials used in the Philippines today. Cite some ex...

A: Sustainability means meeting our own needs without compromising the ability of our future generation...

Q: Qsn. A soil mass has kx=8*10-7cm/s and ky=4*10-7cm/s. The effective permeability of the soil is ___...

A: Given data Permeability of Anisotropic soil in different direction : - Kx = 8 * 10-7 cm/sec Ky = ...

Q: Determine static indeterminacy of frame

A: Given data : The number of member in framed structure m=6 The number of external support reaction R=...

Q: Estimate the lag time (hr) for the following watershed:

A: HYDROLOGY:

Q: Find the collapse load in a 7m x 5m rectangular slab fixed at all edges for which the support moment...

Q: Check stability of truss

A: Given data : The number of Joint in a truss J=3 The number of member in a truss m=2 Support conditio...

Q: Problem: The deep beam shown in the following Figure supports a factored column load of 1450 kips. T...

Q: A beam is 18m long and it's one overhang side is subjected to a uniform load of 6kN/m. If the modulu...

Q: A pipe of diameter 300 mm and length 3500 m is used for the transmission of power by water. The tota...

Q: A spar buoy is a rod weighted to float vertically, as shown. Let the buoy be wood (SG = 0.6) with di...

Q: of concrete required for the piers in a foundation. The piers are 10" diameter, 20 deep, and 66 are ...

A: According to given data The piers are 10" diameter, 20 deep, and 66 are required.

Q: The A-36 steel W 6 x 20 column 6 m in height is pin connected at its ends and is subjected to the ax...

Q: A. The perpendicular offset distance from point P which is located on the simple curve to point Q wh...

Q: the baseline of a triangulation survey was measured to be 1,800m at a place having an altitude of 15...

Q: A pipe of diameter 2 m is running full with water with a velocity of 1.7 m/s. What is the depth (in ...

Q: Given closed traverse with omitted measurements, Line Distance (m) | Azimuth (from North) AB 281.4 1...

A: To determine the omitted measurements. Given closed traverse, Line Distance (m) Azimuth (from ...

Q: The common tangent of AB of a compound curve is 76.42 m, with an azimuth of 268°30'.The vertex V bei...

Q: What are the various combinations of the stress state variables that can be used for an unsaturated ...

Q: The 240-lb body as shown in the figure below is supported by wheels at B which roll freely without f...

A: Given:- m=240lb acceleration=1/3g coefficient of friction=0.40 To find:- P

Q: A simple curve has a central angle of 36° and a degree of curve of 6°. a) Find the nearest distance ...

Q: The hot air balloon exerts a 1000 N force along the y-axis. If the allowable tensile stress on the c...

Q: A series of vane shear tests have been performed on a soft clay stratum. The results of these tests ...

Q: O O OO O o o W shape

Q: A steel column has the following properties: length = 5 meters ; moment of inertia = 37.7x106 mm4 an...

Q: Given the sieve analysis and plasticity data for five soils, classify the 5 soils according to Unifi...

Q: A 2 m long steel wire is fixed and hanging vertically with a tensile load of 2 kN and causes it to s...

A: ##Determine the diameter ofthe steel wire ##

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

A 2x3 ft cylindrical drum is filled with a fluid whose density is 40 lb/ft3

. Determine (a) the total
volume of the fluid, (b) its total mass in pounds and slugs, (c) its specific volume, and (d) its specific
weight where g = 31.9 fps2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A cylindrical drum (2-ft diameter, 3-ft height) is filled with a fluid whose densityis 40 lb/ft 3 . Determine (a) the total volume of fluid, (b) its total mass in pounds andslugs, (c) its specific volume, and (d) its specific weight where g= 31.9 fps 2 .
A fluid flows through a square conduit. At one point along the conduit, the conduit sides are 0.100 m, the velocity is 7.55 m/s, and the fluid’s SG is 0.86. at a second point, the conduit sides are 0.250 m, and the velocity is 2.02 m/s. Find the mass flow rate of the fluid.
Consider a rectangular plate of width B = 1m (measured in the direction normal to the plane of this sheet) and negligible thickness, which separates two fluids of densities ρ and ρw. A mass of density ρs is supported by an inextensible rope that passes through a pulley connected to one end of the plate. Consider that ρ = 1.59ρw and ρs = 2.40ρw, where ρw = 1000 kg/m3. Determine the volume that this mass must have for the system to remain in equilibrium, as shown in the figure.
The volume of the fluid inside the upright conical tank is 0.8 ft3.(a) Determine the needed volume to fill up the entire container.(b) Determine the height of the air from the peak and base of the tank.(c) If the mass of the fluid is 40 kg, determine its density. Use 2 decimal places.
Water floes through a circular pipe with a constant radius of 8cm. The speed and pressure at point a is 6 m/s and 300000 Pa respectively.a.) what is the speed of fluid at point b?b.) what is the pressure at point b which is higher than point a for about 5cm?
A fluid (s=1.26) flows through a 80 mm diameter pipe at a velocity of 14 m/sec. Compute the weight flow rate. (N/s)
Find the quantity flowing in liters per second and calculate reynolds number for the flow. determine the flow of the direction. γ=8000 n/m3 and u=0.04kg/mxs
Water entering through 5 ft long and 1 inch diameter pipe has a flow rate of 100 kg/min at a temperature of 100 °C and pressure of 1.95 bar at exit. The density of water at these conditions is 961.5 kg/m3. Calculate the rate of work done at the exit of pipe.
A hydraulic jack contains 2.0 litres of oil as the working fluid. The compressibility of the oil is 1.98 × 10^-10/ Pa. Given that,compressibility of a liquid = 1/ bulk modulusof the liquid Calculate the absolute decrease in the volume of the oil when it is under a constant pressure of 1.50 × 107 N/m^2.
An open rectangular tank 3.8m high, 2.5m wide and 6m long is filled with water at a depth of 2.2m. If it is accelerated at 2.3 m/s^2 and is moving at a plane inclined 15 degrees from the horizontal, determine the following: a. acceleration of the vessel along the horizontal; and b. angle of fluid inclination. Note: Use density of water as 1000kg/m3 and specific weight as 9.81kN/m3.
A discharge of 30 liter/s of water is flowing in the pipeline shown in the figure, what pressure shall be maintained at 1 if the pressure at 2 is to kept 75kPa and the loss of head between 1 and 2 is 5% of the difference in pressure heads at 1 and 2.
An agricultural land install a pump with a 218mm diameter suction pipe and a 200mm diameter discharge pipe. Respectively each pressure reads 1.12 bars and 0.96 bars. The water flow measured 12.500 liters/min.at normal temperature. Calculate the following: 1. Head at the discharge side, m 2. Velocity Head. m 3. Total Head of the pump, m