A cylindrical drum (2-ft diameter, 3-ft height) is filled with a fluid whose density is 40 lb/ft 3 . Determine (a) the total volume of fluid, (b) its total mass in pounds and slugs, (c) its specific volume, and (d) its specific weight where g= 31.9 fps 2 .

A cylindrical drum (2-ft diameter, 3-ft height) is filled with a fluid whose density is 40 lb/ft 3 . Determine (a) the total volume of fluid, (b) its total mass in pounds and slugs, (c) its specific volume, and (d) its specific weight where g= 31.9 fps 2 .

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The diameter of a pipe carrying water changes gradually from 6 inches at a lower point to 18 inches…

Q: An agricultural land install a pump with a 218mm diameter suction pipe and a 200mm diameter…

A: Let's suppose, the suction side as point A and the discharge side as point B, and the vertical…

Q: A manometer is used to measure the pressure in a tank filled with air. The fluid has a specific…

A: given atmospheric pressure = 96 kPa S.G= 0.95 ρw=1000 kg /m3 h=65 cm=0.65 m Gauge…

Q: 3. The system in Figure is at 20°C. If atmospheric pressure is 101.33 kPa and the pressure at the…

A: Given:- SG of oil=0.9 Pressure=242kPa To find:- Specific gravity of fluid X

Q: A 2x3 ft cylindrical drum is filled with a fluid whose density is 40 lb/ft3 . Determine (a) the…

Q: Find the quantity flowing in liters per second and calculate reynolds number for the flow. determine…

A: p1ρg+v212g+z1=p2ρg+v222g+z2+hfBut v1=v2z1=5mz2=0m Therefore p1ρg+5=p1ρg+0+hf γ=ρg=8000…

Q: A plunger (54 mm Ø and 0.5 m long) is moving through a horizontal cylinder (60 mm Ø) containing oil…

Q: A nozzle of inner radius 1.04 mm is connected to a hose of inner radius 8.55 mm. The nozzle shoots…

Q: Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

A: Given Pressure, P = -22 kPa = -22000 Pa Density of mercury = 13,600 kg/m3 Density of water = 1000…

Q: A 9.2-kg plastic tank that has a volume of 3.3 m3 is filled with liquid water. Assuming the density…

Q: A circular vessel 2 m in diameter and 3 m high is filled with three liquids standing 1 m high each.…

A: Given data in question Diameter and height of vessel Relative densities Area of orifice Constant…

Q: 4. A Venturi meter is installed in a pipeline carrying air. The meter has a diameter of 600 mm at…

A: It is highly accurate discharge measuring instrument of incomprehensible fluid flow. It consists of…

Q: Water flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow will…

A: Solution; Given Data; For water, D=25 mm =25*10-3m V=6 m/s ρ=1000 kg/m3μ=1.3*10-3 kg/m.s

Q: Topics: Fundamental of fluid flow In Lake Geneva (Switzerland), there is a water jet (called the…

A: step 1-

Q: Problem: A 1-m diameter and 1.6-m height cylindrical drum is filled with a fluid whose density is…

Q: A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

A: Given: Volume of water in rigid container, V = 1 m3 Pressure applied by the piston = 46 Mpa = 46 *…

Q: A circular pipe of diameter 0.5 m carries the discharge of 50 litres/s. The head loss due to…

Q: A cylindrical container filled with a specific liquid has an area of 97 m2 and a height of 8 meters.…

A: To find out the specific gravity of the fluid.

Q: The outside diameter of a right circular cylindrical tank is 3,000 mm and its height is 6,000 mm. If…

Q: A fluid flows through a square conduit. At one point along the conduit, the conduit sides are 0.100…

Q: Two chambers with the same fluid at their base are separated by a piston whose weight is 25 N, as…

Q: The tank shown contains a liquid having a density of 1.22 slug/ ft^3 Determine the weight of the…

Q: Calculate the location of the center of pressure, Lp, to in m to the nearest 1000th. Fluid: Orange…

A: NOTE : as per our guidelines we are supposed to answer only one question. Kindly repost the another…

Q: An industrial tank is discharging a fluid through a 5-inches nozzle with a velocity of 5 meters per…

A: Given; Diameter of nozzle=5"=5×0.0254m=0.127m Velocity of water flowing out = 5m/s Rate at which…

Q: An oil of density 892 kg/m³ is flowing in a pipe having an internal diameter 5cm. This pipe is…

Q: A circular orifice 15-mm diameter is located 0.35 m above the bottom of a rectangular tank 50 cm by…

Q: Water entering through 5 ft long and 1 inch diameter pipe has a flow rate of 100 kg/min at a…

A: Given: Length, L = 5 ft Diameter, D = 1 in Mass flow rate, m = 100 kg/min Temperature, T = 100°C…

Q: of the unknown fluid is 12.56 what is its specific weight

A: We knowSpecific gravity of fluid=Unit weight of fluidUnit weight of WaterWe know Unit weight of…

Q: A cylindrical object 84mm diameter, 158mm height and a mass of 589g, is placed in the tank, which…

A: To determine the height of the cylinder that floats above the oil. Given, Diameter of the cylinder…

Q: Q1. The U-tube manometer shown is used to measure the pressure in the pipeline at A. The water is at…

A: The given figure is shown below:

Q: An open cylindrical vessel 1.2 m in diameter and 2.1 m high is 2/3 full of water. Compute the amount…

A: To determine the volume of water spilled. Given, Diameter of the tank, say D = 1.2 m Height of…

Q: A cylindrical object 84mm diameter, 158mm height and a mass of 593g, is placed in the tank, which…

A: Diameter of the cylindrical object = 84 mm or 0.084 mm. height of the cylindrical object= 158…

Q: A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

A: Volume of water in container=1m3 It is required to determine the change in volume of water when a…

Q: A circular pipe of diameter 0.5 m carries the discharge of 50 litres/s. The head loss due to…

Q: A 1-m³ volume of water is contained in a rigid container. Estimate the change in the volume of the…

Q: Q3: A tube has a u-shaped, as in the following figure, if the density of water is 997 kg / m3, the…

A: in given figure pressure at a pointPa=ρghPa=997×9.81×0Pa=0pressure at b…

Q: In fluid flow, it is assumed that the fluid's density is constant throughout the system. True or…

A: In Fluid mechanics, the density is assumed to be constant through the flow this flow is called…

Q: A gaseous fluid circulates through a 20 mm diameter pipe whose G.E = 1.35 at a temperature of 12 ° C…

A: d= diameter = 20 mm specific gravity = 1.35 ρ=density = 1350 kg/m3 v=velocity = 3 m/s A= area

Q: A cylindrical container filled with a specific liquid has an area of 87 m2 and a height of 2 meters.…

A: solution Given area of the container A=87m2height h=2mts so the volume becomes V=Ah=872=174m3the…

Q: Calculate the pressure difference between the centers of tanks A and B. If the entire system is…

A: The dimensions of a tube are given . The relative density of fluid are given . The density of fluid…

Q: FIGURE Q2(d) shows a pressurized tank of water has a 10 cm diameter orifice at the bottom, where…

Q: 9. Oil with a specific weight of 8.64 kN/m³ flows from A to B through the system shown in Figure 8.…

A: Given data in question Deflection in manometer Diameter Specific weight of oil To find out…

Q: Oil with a specific weight of 8.64 kN/m3 flows from A to B through the special fabricated system…

A: Given:- specific weight=8.64kN/m3 Sgo=1.4 To find:- volume flow rate of oil

Q: Determine the average velocity of water at the nozzle exit. The average velocity of water at the…

A: given diameter of the hose Dh= 1 in average velocity of hose Vh = 5.8 ft/sec diameter of nozzle…

Q: Calculate the volumetric flow rate of oil flowing in a circular pipe of 50 mm diameter. The Reynolds…

A: Given data- circular pipe dia D=50 mm=50×10-3 mReynold's number Re=2320Density ρ=920 kg/m3Dynamic…

Q: centrifugal pump is used to pump a liquid in steady turbulent flow through a smooth pipe from one…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: A tube of diameter 25 mm is used (as shown in the below figure) as a siphon to discharge water from…

A: Given data, Diameter of tube=25mm Atmospheric pressure=101.325kPa

Question

A cylindrical drum (2-ft diameter, 3-ft height) is filled with a fluid whose density
is 40 lb/ft 3 . Determine (a) the total volume of fluid, (b) its total mass in pounds and
slugs, (c) its specific volume, and (d) its specific weight where g= 31.9 fps 2 .

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Mass and mass related variables in engineering

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 2x3 ft cylindrical drum is filled with a fluid whose density is 40 lb/ft3 . Determine (a) the totalvolume of the fluid, (b) its total mass in pounds and slugs, (c) its specific volume, and (d) its specificweight where g = 31.9 fps2
A fluid flows through a square conduit. At one point along the conduit, the conduit sides are 0.100 m, the velocity is 7.55 m/s, and the fluid’s SG is 0.86. at a second point, the conduit sides are 0.250 m, and the velocity is 2.02 m/s. Find the mass flow rate of the fluid.
Consider a rectangular plate of width B = 1m (measured in the direction normal to the plane of this sheet) and negligible thickness, which separates two fluids of densities ρ and ρw. A mass of density ρs is supported by an inextensible rope that passes through a pulley connected to one end of the plate. Consider that ρ = 1.59ρw and ρs = 2.40ρw, where ρw = 1000 kg/m3. Determine the volume that this mass must have for the system to remain in equilibrium, as shown in the figure.
Water floes through a circular pipe with a constant radius of 8cm. The speed and pressure at point a is 6 m/s and 300000 Pa respectively.a.) what is the speed of fluid at point b?b.) what is the pressure at point b which is higher than point a for about 5cm?
A manometer is used to measure the pressure in a tank filled with air. The fluid has a specific gravity of 0.95, and the manometer column height is 65cm. If the local atmospheric pressure is 96 kPa, determine the absolute pressure within the tank. answer in kPa abs
The volume of the fluid inside the upright conical tank is 0.8 ft3.(a) Determine the needed volume to fill up the entire container.(b) Determine the height of the air from the peak and base of the tank.(c) If the mass of the fluid is 40 kg, determine its density. Use 2 decimal places.
Water entering through 5 ft long and 1 inch diameter pipe has a flow rate of 100 kg/min at a temperature of 100 °C and pressure of 1.95 bar at exit. The density of water at these conditions is 961.5 kg/m3. Calculate the rate of work done at the exit of pipe.
Edible oil (specific gravity = 0.83) flows through a venturi meter with a range of flow rates from 0.002 to 0.02 m^3/s. Calculate the range in pressure differences required to measure these flow rates. The pipe diameter is 15 cm and the diameter of the venturi throat is 5 cm.
Find the quantity flowing in liters per second and calculate reynolds number for the flow. determine the flow of the direction. γ=8000 n/m3 and u=0.04kg/mxs
A fluid (s=1.26) flows through a 80 mm diameter pipe at a velocity of 14 m/sec. Compute the weight flow rate. (N/s)
The diameter of a pipe carrying water changes gradually from 6 inches at a lower point to 18 inches at a higher point by 15 ft. What will be the difference in pressure, in psi, between these points if 6.2 cfs is flowing considering no loss in energy.
The water flow rate in the pipe will be measured using the pitot tube system given in the figure. At point 1, the velocity is zero and represents the stationary point. Since there is mercury with a density of 13600 kg/m3 in the manometer and the height of the manometer is read 0.06, calculate the volumetric flow rate of the water flowing in the pipe with a diameter of 0.2 m. (ρwater = 1000 kg/m3)