A 35 kW motor running at 1200 rpm drives a compressor at 780 rpm. The arrangement is made through a 90° bevel gearing arrangement. The pressure angle of teeth is 14.5°. The allowable static stress for both pinion and gear are 85 MPa. Determine the number of teeth on the gear, face width, addendum, dedendum, outside diameter and slant height, thickness of tooth. Also check your design from the standpoint of wear. Take surface endurance limit as 690 MPa and modulus of elasticity as 89 kN/mm2. Problem 2: A 35 kW motor running at 1200 rpm drives a compressor at 780 rpm. The arrangement is madethrough a 90° bevel gearing arrangement. The pressure angle of teeth is 14.5°. The allowable static stress forboth pinion and gear are 85 MPa. Determine the number of teeth on the gear, face width, addendum, dedendum,outside diameter and slant height, thickness of tooth. Also check your design from the standpoint of wear. Takesurface endurance limit as 690 MPa and modulus of elasticity as 89 kN/mm?.

Answered: A 35 kW motor running at 1200 rpm…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Concept explainers

Question

A 35 kW motor running at 1200 rpm drives a compressor at 780 rpm. The arrangement is made through a 90° bevel gearing arrangement. The pressure angle of teeth is 14.5°. The allowable static stress for both pinion and gear are 85 MPa. Determine the number of teeth on the gear, face width, addendum, dedendum, outside diameter and slant height, thickness of tooth. Also check your design from the standpoint of wear. Take surface endurance limit as 690 MPa and modulus of elasticity as 89 kN/mm2.

Problem 2: A 35 kW motor running at 1200 rpm drives a compressor at 780 rpm. The arrangement is made
through a 90° bevel gearing arrangement. The pressure angle of teeth is 14.5°. The allowable static stress for
both pinion and gear are 85 MPa. Determine the number of teeth on the gear, face width, addendum, dedendum,
outside diameter and slant height, thickness of tooth. Also check your design from the standpoint of wear. Take
surface endurance limit as 690 MPa and modulus of elasticity as 89 kN/mm?.

Expert Solution

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Design of Power Transmission Elements and Power Transmission Systems

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions