A 350 km transmission line has the following parameters: z = 0.0195 +j0.35 Ω/km y = j4.5 μS/km Part 1: parameter calculations and pi models. 1. Determine the characteristic impedance and surge impedance for this line, as well as its propagation constant. propagation constant. 2. Determine the ABCD parameters for the total length of the line. 3. Find the equivalent pi diagram for the line. 4. Determine the ABCD parameters if losses are neglected. 5. Find the equivalent pi-diagram for the line, if losses are neglected.

Q: 7.70 Find Z in the circuit of Fig. P7.70, given that Vs = 40 V and Va = 17.22e-j132.2° V. = Vs S +…

A: Given:A circuit, with To find:The value of Z.

Q: With an aid of a. c. equivalent circuit, derive an equation representing common- mode gain (Ac) of…

A: To derive an equation representing the common-mode gain of a circuit using the AC equivalent…

Q: Calculate the bandwidth, Q factor and lower & upper cutoff frequencies • Obtain the transfer…

A: Given:A series R-L-C Circuit,To find:a) B.W., Q factor, lower and upper cutoff frequency. b)…

Q: Chapter 15 12. Calculate the total impedance of the circuits in Fig. 15.89. Express your answer in…

A:

Q: Determine the numerical value for veq if v₁ = V2 = 3 = 8.00 V. The numerical value for veq is V.

A: V1-V2-V3 = 8 V

Q: 3. Determine the currents through R₁, R3, and R4 resistances respectively. 10V V1 R1 1k D2 Si R2 M…

A:

Q: AVDD PDN HK- HH VOD 0 Precharge, Evaluate k (a) Show your PDN design clearly. Your input to PDN is a…

A: To implement the logic function  using Domino logic circuit is given in the question.. Assuming that…

Q: The rotor resistance and stand still reactance of a 3 phase induction motor are 0.02 0/phase and…

A: It is given that:

Q: 1.1 You are given three resistors of values 1, 2 and 3 ohms respectively. How many unique resistance…

A:

Q: QUESTION 1 Use Kirchhoff's method to determine the current flowing through 5 in FIGURE 1 below. I₁…

A:

Q: 12 V 4 Ω 1 0 5Η 100) of {5Ω ЗА

A: The circuit diagram,

Q: 4. Consider the circuit shown in the following Figure. The cut-in voltage of each diode is VDO = 0.7…

A: In this questionWe need to determine the current IR1  , ID1  and ID2  and voltage Vo  as shown the…

Q: is O 3.75 W 25.35 W 20.25 W R In the above circuit, R is the load of the circuit. If R = 9 ohms, 1…

A:

Q: (c) System A and System B are defined by a[n] = 5x[n+ 2] + x[n-2] and b[n] = 5"(x[n+2])+2,…

A: Given:System A, System B, Aim:To compare time-invariant property for both systems.

Q: Please show how to calculate the loads, give the size of wire and circuit breaker size per stall and…

A: The number of bulbs (appliances).Rating of each lamp W.Single-phase supply voltage  Volts.Since…

Q: 5. Cylindrical capacitors of length L is filled up with an inhomogeneous dielectric as shown in the…

A: Given Data:The cylindrical capacitors of,Length Relative permittivity of Radii of the cylinder of To…

Q: Vo????

A: The given circuit is drawn below:

Q: Analyze the circuit below. a. Find the voltages V1 and V2. b. Find the currents I1 and I2. (Utilize…

A: The given circuit is shown below.We need to determine the voltages  and currents .It is mentioned to…

Q: Assume the OPAMP below has the transfer function of: H opam р 10 =s+1 6 Mathematically derive the…

A: Given Data:A non-inverting Op-amp with,Input voltage Output voltage Transfer function To…

Q: Using Mesh analysis, find vo (in Volts) if Vs = 18.1 V and R = 4.2 Ohm. Give answer in 2 decimal…

A: Given:A circuit, with,To find:The value of V0.

Q: Two 20 cm-long thin glass rods uniformly charged to +11nC are placed side by side, 4.0 cm apart.…

A: The length of rods, The charge, Distance between rods,

Q: (b) The circuit shown in Figure Q2 (b) is formed by a 0.002 F capacitor and 5 2 res The input…

A: Given Data:An RC series circuit with,Resistor Capacitor Input voltage To Find:Expression of  in…

Q: (a) If this motor is started from a 460-V infinite bus, how much current will flow in the motor at…

A: Terminal voltage of the motor , VT = 460 VNumber of poles of the motor, P =4Slip at full load…

Q: The following system is designed very well and will not mal-operate; Justify your answer! a. True b.…

A: The statement is false.

Q: b 4.00 10.0 V 14.0 V 36 6.00 www 2.002 Find 11,12,13

A:

Q: Calculate the current through each resistor in (Figure 1) if each resistance R=4.75 kN and V = 12.0…

A:

Q: 7) Find re, gm, Z₁, Zo, Avi, Av2, and Avt (10.402, 3.6mS, 268.7k, 693.30, 0.714, - 66.8, -47.7) Vil…

A:

Q: If the common base DC current gain of a BJT is 0.98, its common emitter DC current gain is

A: It is given that:The common base current gain (DC current gain) is,

Q: When running on its 11.4 V battery, a laptop computer uses 8.3 W. The computer can run on battery…

A:

Q: Write the equations at the specified mesh and simplify it.

A: The above question is based on mesh analysis in a circuit.We need to write the mesh equation in the…

Q: 1) Draw a BJT feedback amplifier including all parameters, AC and DC components. a) Consider a fixed…

A: To draw a BJT feedback amplifier, we need to consider a fixed bias BJT amplifier circuit.

Q: Find i2 in Amperes if Is = 7.5 A and R = 7.3 Ohms. Give answer in 2 decimal places. No need for…

A: The value of the resistance is 7.3 Ohms.The value of the current source is Is=7.5 A.

Q: A TV signal has a bandwidth of 4.5 MHz. The signal is sampled according to the Nyquist theorem,…

A: To determine the transmission rate in baud (symbols/second), we need to consider the different…

Q: For the LTI system whose impulse response is h (t) = 8 (t) — e¯tu (t) The system is a lowpass filter…

A: In this questionWe need to choose the correct and incorrect options. We are solving this problem…

Q: Show all work in detail! Clearly circle your final answers for part A and part B and attach…

A: The circuit isA) We need to determine the voltage across the resistor R3 (i.e VR3) and current…

Q: current values?

A: It is given that:

Q: - The phase deviation Ø(t) The bandwidth according to Carson's rule. 1- If a BPF filter is to be…

A:

Q: 2. R(s) G(s) H(s) C(s) R(s) ? C(s)

A: Given Data:A positive feedback block diagram model with,Reference input Controlled output Open Loop…

Q: In a balanced three-phase system, the source is Y-connected, and Van = 12040° V (RMS voltage). The…

A: Given data: Van = 120∠0° V Z1 = 8 + j6 Ω/Φ Z2 = 6∠36° Ω/Φ

Q: Fill the given waveform for the Delay concept to generate a clean pulse of one period of CLK. CLK…

A: Given a digital circuit input waveform.Asked to generate output waveform as per waveform labels.

Q: 1. By using re model, draw the a.c. equalent circuit for the transistor amplifier shown in figure 1…

A: The circuit is We need to draw the a.c equivalent model for the transistor amplifier by using re…

Q: 5. a) Determine the total resistance and the current through each resistor of the arrangement shown…

A:

Q: Question 2. Find the transfer function T(s) = C(s)/R(s) using both block diagram reduction and…

A:

Q: A prototype active filter (R = 122, C = 1 F, wc = 1 rad/s) has a gain of -160 dB at @ = 0.01 rad/s…

A: Given data:

Q: 4. Find the current through the diode in the circuit. Assume that the diode is ideal. V2= W Volts R1…

A: To find the current through the diode in the circuit.Assume that the diode is ideal..

Q: Bidirectional counters, also known as Up/Down counters, are capable of counting in either direction…

A: To construct the truth table for a 4-bit synchronous binary up/down counter with positive edge…

Q: Draw a half-adder logic circuit using only two gates

A: It is given that:Half Adder

Q: Required information Consider the circuit given below. Given: /= 5.00 A. 192 292 592 www 5ix 14 292…

A: Given Data:A DC resistive circuit with,Independent current source Dependent current source To…

Q: 10 for The following Transmission System, Talking into consideration a base power of 40 MVA and a…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: An optical transmission link to transmit 50 Mb/s is shown as in Figure 4. The output power of the…

A: An optical transmission link to transmit 50 mb/s, is shown as in below figure.Output power of the…

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.